Reviews
You can enjoy the atmosphere of a new car.
Decals are stripped except for vehicles with a high degree of originality.
You can enjoy the feeling of a new car just by affixing it.
However, in the case of a vehicle with a certain level of sophistication, only the decal is strangely beautiful and has a funny atmosphere.
View detail
Fits: KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR)
It's a good sound. I like it a lot.
It sounds and looks really good. I am satisfied. View detail
Fits: KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR)
Straight tube essentials
I got this as a countermeasure for the baffle of ORM Slip-on Silencer installed on my Z900RS, which was making a terrible chattering noise. After installation, it looks good. View detail
Fits: KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR)
Good and close to OEM. Would buy again.
Good and close to OEM. Would buy again. View detail
Used with Z1 Cell Motor Cover
I bought the Cell Motor Cover for my Z1 because it did not come with Packing. I bought it because it was less than half the price of Packing from other manufacturers. It was time-consuming to cut the double-sided tape to the width of the Packing and paste it on the Cover. If I used glue, it would be messy if it sticks out, so I stuck it on with double-sided tape, but it would be better if Packing itself had double-sided tape. I wish the packing itself had double-sided tape, but it was a good thing because the price was so low. View detail
Fits: KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR)
YOSHIMURA style?
I don't know the sound of the YOSHIMURA of the time, and the KZ1000 is a race car, so it It is naturally quieter than "is a racing exclusive parts.
Z1, Z2, and KZ1000 each have obviously different sound quality, but I like the heavy sound of the 1000cc.
On my Motorcycle, the sound was almost the same with or without the Baffle. So, I use the Baffle to reduce vibration.
I think that a Silencer 5,000 yen for a 70mm Short Tube is a good idea to buy it for fun and enjoy it in many ways.
View detail
Brake line grommet
This grommet can actually be universal. I changed the front fender but it doesn't come with the brake line guide. All you need to do is to just drill a 10mm hole to snug it on. View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
Fork Seal Stopper SetΦ36
It is comparable to OEM Product and can be used normally.
We'll change it together when we change the fork seal!
View detail
Fits: KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI 750SS MACHIV (H2)
Dust Boots for Fork MRS-955-K021
It seems a little thicker than OEM Product. A little bit expected.
If oil starts leaking, replace it together with the Seal. By that time, it will probably be cracked.
I wish they would make a compatible product that only requires inexpensive packing replacement. Not all of them need to be Rubber.
M is cheap, though.
View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
Fork Seal Stopper SetΦ36
It is comparable to OEM Product and can be used normally.
If moisture gets into the seal, the seal will rust, so it should be replaced when the fork seal is replaced.
View detail
Fits: KAWASAKI Kawasaki Others
It can be used with 2Pin or 3Pin and responds quickly.
If you have an old car, you can use the Z1 2-pin or CB750Four 3-pin, and if you don't care about the OEM type, the blinker will respond faster than the contact type, which is also good for safety. View detail
Fits: KAWASAKI Kawasaki Others
Very responsive to Linear.
Because of the old motorcycle, the contact type OEM product operates with one-tempo13 delay from the switch operation, but this product operates linearly, which is good for safety if you are not concerned about OEM. View detail
Fits: KAWASAKI ZEPHYR1100, KAWASAKI ZEPHYR1100 RS
Exhaust System with a slightly larger volume
It took a while to arrive, but it installed perfectly and looks nice. The volume is a bit large. The sound quality is thick at low rpm and pleasant at high rpm. View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
Tune with Universal Product at a fraction of the cost!
Earls Gear Wye BurnCLASSIC (Car inspection suit) I was not satisfied with the volume of the silencer I replaced with a Universal OUTEX barrel aluminum silencer, so I purchased this product from Universal. I was not satisfied with the volume, so I bought this product from Universal. The outer diameter was a little small, so I wrapped two rounds of aluminum tape around it and adjusted it. The volume became a little louder, but it was still not enough, so I cut the inside core 3mm shorter. It sounds great! I think it is not so large and quiet.
Since we are only tinkering with Silencer, it should be easy to change it back.
View detail
Fits: KAWASAKI Kawasaki Others
I can use it without problems
It's a little bit old motorcycle, so it doesn't light up immediately after pressing the switch, and there is a time lag. The price is not too high and it seems to be reliable, so I chose it. View detail
Fits: KAWASAKI ZEPHYR750 RS, KAWASAKI ZEPHYR750
Cost performance at its best
Installation is not very difficult and can be done by a person with some knowledge.
The sound is a little bit large, but I use it without Glass Wool.
It was well packaged and quick to respond.
View detail
Fits: KAWASAKI Z1000 MkII, KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI KZ1000
Normal handle bar has this
I felt safe ordering from you.
After all, the new Wire is Smooth!
I feel good
Now all we need is some durability and we're good to go!
View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
You can't see it.
This is the Bracket Set for the Emblem. I painted it with Black Spray before installation.
Also, because I wanted to fit the Emblem as close to the fork as possible, the Quantity:I cut and used the color that came with the Set.
View detail
Fits: KAWASAKI Z1000 MkII, KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI KZ1000
This is for the OEMHandlebar
This is fine for the OEMHandlebar.
It is over the price
View detail
Fits: KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4), KAWASAKI Z2 (750RS/Z750FOUR), KAWASAKI Z1 (900SUPER4)
I don't want to ruin the OEM atmosphere.
I bought these when I did the OH of the front brake, because the OEM was discontinued. The length was just right and there were no problems with installation. View detail