Reviews
Easy to use
I bought it at Oilfor Replacement.
At first I used it for Oil replacement, but after that I use it for Chain cleaning and parts cleaning.
It's made of plastic, but it's thick and elastic, so it won't break even if you handle it roughly.
The large size is just right so that it does not get in the way when stored away.
It is convenient to have one.
View detail
Nearly 4 liters of oil tends to overflow.
The reduced height makes it easy to use even for vehicles with low vehicle height, such as the BOLT Shoulder Bag.
However, when the amount of oil is close to 4 liters, the oil level is close to the edge, so a little bit of oil can cause a problem.
Waste oil spills.
I guess it is TradeOff with the height being held down, but I don't think so.
Therefore, it is recommended to use it in motorcycles with up to 3 liters of oil.
View detail
Good product, but expensive.
In terms of usability, I think oil pans such as SIGNET are definitely better. I think it was a mistake to buy it. View detail
250 or more may be a little small.
This product can hold 5 liters of oil, but the plastic is a little flimsy, so if you put in 4 liters of oil, it will probably spill or tip over for sure. I think it is appropriate to use this product. View detail
Very useful for Scooter!
[How is it used?
I bought this for my CYGNUS X SR Model 5 Oilfor Replacement, and the CYGNUS has an exquisite Center Stand in the way.
I bought this product because there is a drain bolt and the Center Stand is too low to fit a large-geometry oil pan.
Was the one you received as per Image?
It's a great product, but I'm not sure if it's the right size for me.
I thought it would be no problem if I could cover the cost. The size is just right for implementation and is easy to use.
How was your experience with it?
It is simple and easy to use. I also use it to change the oil in the circuit of my YZF-R25, which has been converted to a racer.
The only problem is that the sink is still flat, so there is a high possibility of spilling on the Large when you throw it away.
So I'm thinking of either cutting it or intentionally hitting the exhaust pipe to melt it and make it easier to flow.
[Points to note]
As others have mentioned, be careful when you pass the Center Stand through the neck, if it doesn't go in at an angle!
It's fine when you put it in, but after you pull the oil out, you have to angle it to get it out! Then it's a large disaster (laughs).
If the amount you pull out is small, you can go without spilling, but if it's a lot, you will definitely spill.
How did it compare to other products?
I think the square oil pan has a merit that it can be stacked.
If you are using a scooter, the Center Stand will be in the way.
That makes me wonder if it's any other shape than this one!
View detail
It's just waste oil.
I bought this because I wanted a simple and cheap oil catcher.
The plastic boxes at Homsens are too tall and the capacity is too small, and it's hard to find something that fits.
With a capacity of 5 liters, it can also be used to replace oil in large motorcycles.
View detail
Oil change essentials
It's a must-have for Oil changes!
The size is just right and it is very useful.
View detail
Very useful for all my vehicles
When researching the vast variety of oil drain pans available on line at Webike I decided on the style with a spout for easy of pouring the old oil into container for disposal and one with the capacity to not only handle the oil quanity from my motorcycle but also my car. I have used this product serveral times now and can say it is a pleaseure to use and an easy clean up with no mess at the end of the vehicle servicing. The product material is very strong and durable with no signs of weakness. The handles and the spout cap were features I did not consider I needed but make life a lot easier when caring a full pan of oil around the garage. Great designed and manufactured oil drain pan from ProTools. View detail
It's cheap and the Size is just right.
[How is it used?
I use it to catch the old oil when I change the oil, and to temporarily place it when I change the parts with oil.
Was the one you received as per Image?
Simple box shape and easy to use.
How was your experience with it?
Surprisingly, there are no simple box-shaped oil receptacles of this size.
The ostentatious shape of the product is sold, but it is bulky and cannot be stored in the narrow SmallGarage.
This is a great way to stack and store it with other Stainless Steel Bat.
[Points to note]
None in particular
View detail
Oil change
It is enough as a receiver when changing Oil, Cost is cheap, and the usability is perfect.
color (Material) Is this Black? This is the old Black. This color was good looking.
View detail
Quality Oil Drain Pan By PROTOOLS
My original oil drain pan to work on my motorcycle and car was just an old container cut in half to fit into the tight location but would always make a mess when emptying. With this well designed and manufactured oil drain pan I no longer have any issues my old oil into a bottle for recycling. I should have bought one of these years ago as it saves my time and keeps my garage clean during oil changes now. View detail
You can also use it to change oil and wash parts
I bought this for Oilfor Replacement I wanted to get a Nozzle type for this type
In the product photo, there is no Cap at the end of the Nozzle, but the product I received has a Cap, and it is also available for storage Oil does not drip
Nozzle's Cap was a nice miscalculation
It's not inconvenient to use, but it's the same with a wider and less heightened oil receiver It would have been better if there was a product that could hold about the same amount of space It would definitely be easier to use that way
View detail
The position of Drain bolt is effective for special Motorcycle!
I bought it for Oilfor Replacement of YAMAHA SR 400.
Oil of SR is Dry scattering type, so when removing Oil, Main is pulled out from Oil drain of Front Frame, but Oil remaining in Oil pan needs to be pulled out as well.
However, when setting up the Center Stand and accessing the Oil drain bolt, the installation is sideways, and because of the positional relationship with Center Stand, I felt it was difficult to use it with a general circular object.
So I purchased this PROTOOLS Compact Oil Drain Pan!
It was introduced as Scooter and Small Type for Vehicle, but the capacity is 2. With 68 L, Oil Capacity 2 of SR 400. It was decided that it was enough for 1 L.
Size is also Exactly, it fits in the gap of Center Stand, and it seems to be active in the future Oil replacement work.
Actual size is outside, height 40 cm, side 23 cm, height 7. 5cm. The inside is a deep place where Oil gathers, there are 14 cm in length, 20 cm in width, and 6 cm in depth.
The narrow part that catches the Oil of the tip part is the widest part on the outside is 17 cm and the narrow part is 15 cm.
Besides that, in the inside of a place with grooves vertically, it has a slope of 16 cm in length, 20 cm in width and 13 cm in width..
The feeling put on the floor has a sense of stability and it is very reliable!
Well, it is said that Large doubles as Small, but again "Appropriate material right place, proper use" It is necessary.
Since this time PROTOOLS Compact Oil Drain Pan is newly added, it seems to be able to enjoy Oil replacement work efficiently.
In the photograph, the PROTOOLS Sticker is stuck, but I tried to peel off what was attached to the packed bag.
View detail
Can be Compact
I bought it to Oilfor Replacement of SUPER CUB 90. It is good in shape that is easy to use in shape with Compact as Large tincture. It is even better if the price is a bit cheaper. View detail
It is a bargain in [ Drain pan / of a DAYTONA / same ] COSPAR!
It is a bargain in [ Drain pan / of a DAYTONA / same ] COSPAR! View detail
Although processing of waste oil was put into the pale can and taken out to the contractor, it thought it difficult to put into a pale can using a funnel. Since there is no fear of spilling since waste oil can be poured out from the mouth at a
Although processing of waste oil was put into the pale can and taken out to the contractor, it thought it difficult to put into a pale can using a funnel.
Since there is no fear of spilling since waste oil can be poured out from the mouth at a tip if it is this bread, he can feel easy.
It is pleasing that the
handle is also in a good position.
View detail
good [ to make the kana lid which should just narrow the crevice between it and the saucer on which the Oil which carries out warmth of the Engine and came to be alike of the Engine smoothly bounds ]
good [ to make the kana
lid which should just narrow the crevice between it and the
saucer on which the Oil which carries out warmth of the Engine and came to be alike of the Engine smoothly bounds ]
View detail
He wanted the small suspended tray used at a Garage, and it purchased about three. as Oil Drip pan -- the capacity 2L -- since it is a few, does a just right work load receive the Engine oil of small displacement volume vehicles, such as an abou
He wanted the small suspended tray used at a Garage, and it purchased about three.
as
Oil Drip pan -- the capacity 2L -- since it is a few, does a just right work load receive the Engine oil of small displacement volume vehicles, such as an about [ 0.5L~1L ] Fork oil, a Gear oil, and Cub, at most?
Since
BMW K1200RS has a Drain of a Transmission per Pivot of a Center stand.
Although the catchphrase which can let between the Center stands of a Scooter pass was expected and he bought it with eye aim -- It was a disappointment for a while in the state where an Oil will fall if the portion which the end extracted twists by an Exactly at the gap of a Center stand and it will twist when [ at which it puts and puts ] = Removing.
In fact, the direction of uses other than an Oil Drip pan is user-friendly.
As for the portion which the end extracted, a crevice is made between the floors which are raised bottoms and were placed, and since it is good for holding by hand exactly, it is used conveniently to carry out every [ of the tool in use / temporary ] by the floor of a Garage, or once receive dirt parts.
The imitation is put on the market also from the
DAYTONA, and on a nominal-cost Base, since it is practically equal, I think whether stock, a Sale discount rate, etc. are seen and the more suitable one should just be chosen.
View detail
[Webike monitor] The box type oil pan (5L) was conventionally used for the receptacle of an oil change. However, when it was an oil pan of 5L, was a large-sized motorcycle, and it moved and threw [ having entered with ordinary considerably, and ] away
[Webike monitor] The box type oil pan (5L) was conventionally used for the receptacle of an oil change.
However, when it was an oil pan of 5L, was a large-sized motorcycle, and it moved and threw [ having entered with ordinary considerably, and ] away into a milk carton, and it did not do quite carefully, it might spill.
Then, by the motorcycle shop which is going in and out, it saw using this product and opted for purchase.
Since there is capacity of 7L, and the shoot of oil sticks and there is also a canopy top, there is no fear of spilling.
Rather than former, it became very easy to throw away oil and it also shortened time substantially.
By the way, this oil pan height is about 13 cm.
Since old 5L oil pan was 8 cm in height, when removing a drain bolt, a margin decreases for a while rather than a former oil pan.
Probably, it will be easier to use a center stand or a stand on hand in the case of a motorcycle with a low ground clearance.
From the first, in my case, since the stand was used, although there was no trouble in particular, before purchasing this oil pan, it considers that it is better to see the higher vehicle of its own motorcycle.
View detail
Although the pack which can be thrown away as it is till then was used, he spilt in many cases and bought the trial. Since a jack is not used usually, it will spill inevitably only by space grip in case of a pack. Since it spilt and exchanged when
Although the pack which can be thrown away as it is till then was used, he spilt in many cases and bought the trial.
Since a jack is not used usually, it will spill inevitably only by space grip in case of a pack.
Since it spilt and exchanged when it was this, to me, I think that this one is suitable.
It is not necessary to inhale the accumulated oil enough with the milk carton into which the newspaper was torn and put, and it does not need to buy an oil pack.
Origin can be taken if it is used several times!
View detail