PROTEC Motorcycle Reviews - Webike Thailand

Filter

Write a review and get Webike Points!

Reviews

PROTEC Clear all

SPI-110DAX Shift Position Indicator Special Kit

DG-S02 Digital Fuel Multi Meter Vehicle Exclusive Kit

PROTEC

29 Mar 2024

DG-S02 Digital Fuel Multi Meter Vehicle Exclusive Kit

Fits: SUZUKI GSX1400

Japanese Webike user

4/5

It would be appreciated if the Instruction Manual was easier to understand.

I was fed up with the GSX 1400's confusing fuel level and bought it before long touring.
Wiring to remove the Right Side Cover and connect the wires is as shown in the photo. (The picture is hard to understand, but …) The Wiring is thin, so I ran it along the Tie Wrap between the Wiring and the existing Wiring without having to remove the Fuel Tank toward the bottom of the Tank. It took less than 30 minutes even for a clumsy person like me.
I have not been able to input the correction data yet because I did not read the Instruction Manual carefully and used the residual amount method from the full tan.
The residual volume method from full Tan, in my case, had an error of about 2 Liter.
It seems that the original error correction method is to display the amount used, then set the full Tan, and then correct the monitoring system. Please do not make a mistake.
However, I am not sure how long my GSX 1400 can run from the blinking of the fuel Lamp due to fuel depletion, and I think quite a few people are running on their own Data somehow.
If you go to Hokkaido, for example . At night, there are many places where even Large urban areas are not STAND. This will give you a good idea of the distance and approximate amount of remaining fuel to plan your touring.
Although not the cherry of Protec, the other day when their Shift indicator would not return from 6th gear, they immediately took care of the problem.
As I said, the customer service is also very strong, which is very helpful.
The product is a bit expensive, but it is trustworthy. View detail

[Optional Parts] Rubber Cap & Headlight Conversion Harness

SPI-JA65 Shift Position Indicator Exclusive Kit

PROTEC

11 Nov 2023

LED Multi Reflector Headlight Kit

Fits: HONDA CT125CT110 HUNTER CUB, HONDA CT125CT110 HUNTER CUB

Japanese Webike user

4/5

Excellent for OEMHeadlight measures that are too dark.

I purchased this product to address a complaint about the CT125, the OEMLED Headlight.

It would not be bad to install a Fog Lamp instead of a Driving Lamp, but the generator output is also equivalent to the Engine Displacement Volume, so it is not possible to install an oversized electrical component. I have just added an Asahi Leg shield, so it's even more difficult to install it in the right position.
And as a compensatory act for not having the usual time to rideω.

Order this kit to convert OEM LED Headlight to H4, which is critical for nighttime rain on country roads, as the visibility is almost ineffective.
Kelvin is color temperature, not brightness.

I think the work itself is reasonably difficult, but there are too many accessories in my house, so it is somewhat more difficult to access and remove them….

Also, I'm so paranoid that I ignore the work as per Manual and processω.
First, we temporarily assembled the tap to check that it works, and then discarded the Electro Tap without regard to the manual.
Good thing good kids never use Electro Tap.
Because Trouble Frequent Cancer

The core wire is exposed by stripping the intermediate sheath, the plug receptacle is cut open with an electric tool to make an improvised splice, crimped with a branch line, and wrapped with harness tape.
With this, the contact failure rate is as close to 0% as possible!

And the rest is usually as per Manualω.
Left Handlebar Switch cut to HandlebarRight from Triple treeReverse side

Body ground is from the base of the Triple treeLeft reflector.

It was recommended to drill holes on the reverse side of the resin case….
I had a woodworking holesaw, so I managed with that.
If you don't have one, I'd use a soldering iron to melt it down.

One last move!
The H4 is a very good solution, but it has a LED headlight that lacks the universal nature of the fine connector with a dedicated cooling fan, so it is not a good solution.

When it becomes impossible to light up in the future….
Branch Wiring to UniversalH4-305Connector for immediate replacement
Bullet Terminal connection in the middle and keep the Connector inside the very narrow Headlight case.
Of course, the Bullet Terminal should be on the Female side and insulated with harness tape just in case.
Incidentally
Kit side Harness
White GND(Earth) − CouplerReverse side Left
Yellow−Lo − same Up
Blue−Hi − the same Right

This way, whether Halogen or LED, Universal Product can be used.
However, the use of High Wattage products such as Halogen etc. should be avoided as much as possible.
I think LED is better for Halogen 35w or so.
Carry H4-305Coupler and spare H4LED
There is also a position lamp in the headlight, but ….
No Wiring because even 5w is too close.

Also, if the Wiring fixed Band in the Case was still used, it was not closed and was not established, so it was disconnected and the internal Wiring was set to "Quantity".:Pair (for Left and Right) allocated to
GreenWiring to the Controller is also a + line, so I ran it through the MeshWiringProtective Tube.

By the way, processing will likely make the warranty ineffective, but ….
For me personally, as long as I make sure that there are no problems with the initial operation, I'll be fine.
I honestly don't care.
I'd rather have my hands tied
I think it would be much better to customize it in a way that makes sense in front of you.

I've only assembled and lighted test.
It is a world of difference from OEM daylight lamps!
It's triple the number of Watt ….
I'm told the Tester figure is 29,800 candela.

It doesn't look so bad either….
It's an internal Wiring or Headlight, but it's an Aluminum ultra-thin wire.
I have some concerns about the quality of the product.
I'm an old person ω. View detail

DG-H13 Digital Fuel Meter Vehicle Exclusive Kit

SPI-S48 Shift Position Indicator Exclusive Kit [for 2001- GSX1400]

SPI-H40 Shift Position Indicator Exclusive Kit

PROTEC

30 Apr 2023

CS-550M Motorcycle Theft Alarm

Fits: Others

Japanese Webike user

4/5

Retrofit burglar alarm that can be operated only with Ignition key

It is very convenient because it can be set and released using only the Ignition key.
In addition, everything except the Indicator Lamp could be installed out of sight, so there is no sense of retrofitting.

[How is it used?
Since I park Blue empty, I use this burglar alarm in addition to multiple Wire locks.

Was the one you received as per Image?
Yes, it was approximately as per Image.

The feeling of security is priceless, and there is a large difference between having an alarm and not having an alarm.
○Siren's sound is sufficient for your needs (122dB), and if you are in a place with low noise level, you will not miss it!
It is great to be able to set and unlock it with just the Ignition key!
The standby current is less than 0.9mA, which means that the battery is not overloaded.
The alarm body is Compact (W36×H70×D19), so it could be installed inside the Seat Cowl.
The Body and Siren alarms are not waterproof, so installation locations are surprisingly limited.
○Not a dedicated product, so it is necessary to consider the installation location, wiring routing, extension, etc.

In the case of YZF-R125,
All the lamps except for the Indicator Lamp could be installed out of sight, so there is no sense of retrofitting.
When the Indicator Lamp was placed around the Meter unit, the Wiring did not reach the unit.

How was your experience with it?
It has been about a year since I installed it, and it has been working fine.
It is really easy to use, as it can be set and released with just the Ignition key.
Fortunately, not once did the alarm go off.

[Points to note]
When I intentionally set off the continuous alarm sound, it sounded a few minutes later, even though I had not moved it.
Since the battery is weak, could the voltage fluctuation of the battery be mistakenly detected as vibration?
Furthermore, when the battery weakened to the point that the Cell stopped turning, the alarm was misrecognized as having been set (Ignition key turned OFF→ON→OFF within 5 seconds) when the Cell was turned.

So when it malfunctions, Battery may be weak. View detail

PROTEC

14 Oct 2022

CS-550M Motorcycle Theft Alarm

Fits: Others

Japanese Webike user

4/5

If you want to buy a little peace of mind, add Security.

When looking for a theft alarm for motorcycles, Large Land products that can be operated by batteries with a REMOTE CONTROLLER can be found for as little as 2,000 yen.

However, motorcycle is a vehicle that has a low carrying capacity, so you want to carry as little as possible. (Is it just me?)

In such a situation, only the key (key) of Motorcycle is turned ON/OFF, and the alarm Quantity:I found a product that can do Set, and this is what I found.
Security includes alarms for tilt and vibration sensors.

Installation only requires wiring to the battery and ACC, so it takes only 5 to 10 minutes, and even if you add the time to find a place to install the alarm itself, it takes less than 20 to 30 minutes.

Motorcycles are vulnerable to theft.
Parking on the road and daily storage management are also necessary, but for about 10,000 yen, it is inexpensive if you think you can handle it with a little ease and buy peace of mind. cH000000} ( *´ω`* ) /

Merit for this product (personal opinion).

? No REMOTE CONTROLLER required, can operate with Motorcycle key only.
The alarm and Alarm are also small, so it is hard to find a good location for them. The small size of the alarm and alarm system makes it difficult to find a suitable mounting location.
? Installation tool is only a screwdriver.
? Easy to handle with no detailed settings.

Demerit for this product (personal opinion).

? No volume control for alarm sound.
? No alarm sensitivity adjustment function.
? Price around 10,000 yen.
? The startup sound uses Siren sound, so it doesn't feel like it's started…. "Peweeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee!" It is a high-pitched sound.
? The double-sided tape for installation that comes with the alarm, Alarm, and LED is cheap…. （You should replace it with a stronger one.) View detail