Reviews
This makes it easier.
I use it to rub the ROD and it is easy! View detail
At least I could use it.
I used it on a GSX-S1000 FFork.
It may be too thick to fit in some other cars.
I was able to use it on GSX-S1000 FFork for now.
It would be easier to work with if it were a little thinner, but it would prevent scratches on the Cost and Fork side.
I wonder if this is what it would be like if we took it into consideration.
View detail
Replace with a soft one
I have been wanting to change the front and rear springs of my WR250R to softer ones for a long time, so I decided to purchase and replace them myself. if it is just the springs, I can easily replace the rear springs if I have an adjusting wrench, and I can replace the front springs by myself in a few hours. I was able to do it myself in a few hours. View detail
CB250R
I bought this product for Front fork oil level adjustment of CB250R.
There is a little rattling, but it can be used without a problem.
It is convenient to use Torque wrench.
View detail
I'm sorry
I apologize first
I can't write about the details because it's in-play and still unused..
It's convenient to use it because it's obvious that it's a white wire wrapped around a Stainless Steel wire It would be a cloud of difference if you think about the hickeying
But I haven't used it yet... Sorry..
View detail
Sorry again
I haven't used this one either..
But it's absolutely necessary, because I definitely don't want to be covered in scratches with Gold genus Wrench
Cosmetically, it's a good product and not a bad buy
I'm not using it, though
View detail
I was not worried
The ROD of my Motorcycle was too thick to be addicted, I tried to buy it just to be sure but I'm a bit sorry, I think that it can be used with other Motorcycle so it can not be said that it is definitely bad, GSX It is not recommended for -R1000 K3. View detail
I was not worried
My Motorcycle (GSX-R1000 K3) ROD has too thick to be addicted, I was not worried because I can work even if it is disappointing but a bit disappointing. View detail
Required for Inverted Front ForkMaintenance
Used for ZX14 ForkMaintenance. Just until Piston rodNut comes out Color's Clamp bolt will interfere with the Inner Tube and can not be lowered .... It is not a Level that can be picked out even if it is pulled out. Without helping at home center Bolt and Nut (M12 Pitch 1. 25) Purchased and dealt with. View detail