Reviews
Universal Product
I bought it to clean the parts that were soaked with oil.
It may be a little soft, but I will adjust it by cutting it a little.
View detail
Fairly soft
Purchased to quickly wash Tire and Wheel.
If the hose is connected, it can be scrubbed while water is running.
The hair is quite soft and is recommended for a smooth flow around the feet.
The hairs are likely to be defeated by mud, etc.
I received what I was looking for in Brush, which is a good system for this kind of thing.
View detail
For Wheel and air-cooling fins!
I have not used it in a car wash yet, but I think it is just right for cleaning fins on wheels and air-cooled engines because of the tautness of the Brush. The handle is long, so it will be useful for places that are hard to reach. I think the price is high, but it seems to be durable. Therefore, I give it 4 stars for texture and 3 stars for cost performance. View detail
Just right for disposable
[How is it used?
Used to clean parts during Restore of TZr50R.
I bought it because the price was low and the tips of the hairs I had before were becoming stiff.
How was your experience with it?
It was easy to hold and use.
The small size also makes it easy to clean the smallest of areas.
However, it may not be suitable for cleaning Large objects.
How did it compare to other products?
Although the quality is much lower than the slightly more expensive Brush, it was great for a simple cleaning of the Sunday mechanic. Especially when it comes to Restore, these supplies are cheaper and larger in quantity than in quality.
[Points to note]
There are three types of bristle tips, but use them with caution, as they may damage parts if used incorrectly.
View detail
War for Vehicle
MINIBrush, wash for Vehicle and the price was cheap so I bought it to try it out.
It helps that it can wash small areas and is inexpensive.
If it goes bad again, I would like to purchase Repeat.
View detail
For cleaning
Quantity:1 Set of 3pcs. and the price is low, so you can use it without worrying.
The Plastic section is also easy to hold and has a nice elasticity.
It is cosmetically good, so it is enough if you can hold it at some level.
View detail
Brush hardness is just right
I had been using a Nylon brush, but the length of the brush was not long enough and I could not wash it deep enough.
This product, Malbrush, has a thin handle that is easy to insert into gaps between Engines and Wheels, and has surprisingly many uses.
The other one is also easier to use because Brush is longer and softer.
There is no substitute for Home center.
Great for cleaning fins of air-cooled Engines.
View detail
For Parts Cleaning
[How is it used?
Used to clean Engine Parts of vehicles under Restore.
When I watch Restore videos, they all use a similar Brush, so where do they sell it? I was wondering, but when I went searching I found a few that are normal.
We purchased this product, which was relatively inexpensive among them.
Was the one you received as per Image?
It is just the right Size as shown in the picture.
Also, although the bristles are firm, I personally felt that they could be a little firmer. I personally felt that it could be a little firmer.
How was your experience with it?
The PVCNylon bristles, however, are not as firm, so it is somewhat difficult to remove stubborn dirt.
I think it is sufficient to remove ordinary dirt.
The hairs did not fall out during use.
[Points to note]
If you do not choose the right place to use it, you may scratch your car.
How did it compare to other products?
I used to do my best with Tooth Brush, but it was small and sometimes took quite a long time.
I felt that this product would be more suitable for use in non-narrow areas, etc.
【Review】
It was easy to use and inexpensive and necessary and sufficient for cleaning Parts.
Personally, I thought the hair could have been a little firmer.
View detail
Fine car wash good
It seems to be suitable for fine car washing.
Will use for next car wash.
View detail
Works great for washing narrow crevices!
[How is it used?
This cylindrical Car Wash Brush is useful for washing narrow crevices when washing a car.
Was the one you received as per Image?
The total length was longer than I expected.
Considering my carrying and storage situation, another 5 cm shorter would have been perfect.
How was your experience with it?
I forget the Manufacturer, but the diameter of the Brush is thinner than the similar product I used to use, making it easier to insert the Brush into more detailed areas.
Brush's hair is quite firm.
I don't think anyone uses it, but it should not be used on Tanks, Screens, or other areas where fine scratches caused by car wash are a concern.
As the product name says "Engine brush", it is designed to be used on areas that do not get scratched or bothered by washing.
I use it in places that are difficult to wash with Sponge or regular Brush, such as the gap between engines, the gap between spokes, and the gap between exhaust pipes.
It was a pleasant realization that not only can hard-to-wash areas be cleaned, but it is also much more efficient than washing with Dustcloth, etc., so the time spent washing the car can be reduced.
As shown in the product image, the needle Gold of the core can also be bent gnarly.
The needle Gold in the core is quite hard, so it can be washed well even when bent.
[Points to note]
Rubber cap is attached to the tip of the Gold needle, which is the core of Brush.
In the unlikely event that this is not noticed coming off, it is likely to cause serious damage to the vehicle body.
Does it have a rubber cap?" and it is safer to look at it from time to time (a similar product I used in the past had a rubber cap that came off).
*Parts that cannot be used
It cannot be used for areas that must be bent internally, such as the inside of a Handlebar Pipe.
As mentioned above, the core needle Gold bends, but it is quite stiff. It does not bend flexibly to fit the other side while inserting it into a gap.
View detail
Easy to use
I use it to wash the engine fin. The minus shaped part of the handle is used to clean the gaps by applying Dustcloth.
The Brush section is prone to heaving, so care should be taken.
View detail
Convenient for cleaning hard-to-reach areas.
When you wash your car, the inside of the engine, etc., you can't use your brush.
I bought this to clean areas I can't reach.
Flexible, so you can use BrushBody in the right place.
It can be bent.
Brush is hard, so Engine fin, Suspension, etc.
It is useful for cleaning hard-to-reach areas, but Frame
If you rub a painted surface or a shiny resin part such as
Be aware that polishing scratches may occur.
View detail
You can wash a lot at once.
The long grip and long sponge make it possible to wash a lot of areas at once, which improves the efficiency of car washing. It is especially useful for washing the roof of a high roof car, because the Sponge is soft and easy to use. View detail
Convenient for tight spaces.
The small size of the brush makes it convenient for cleaning areas that are difficult for fingers to get to, and it is ideal for removing dirt from the mesh of grills and the base of aluminum wheel spokes. The tip of the bristles is not so hard that it will scratch, so you can use it without worry. View detail
It's expensive, but... this is the way to go for foil washing.
It's expensive, but it's easy to wash the wheel with water.
For oil stains, first "A certain man, a certain man, 556. etc., and then lightly pour off the oil with detergent.
View detail
This Brush is easy to wash.
This brush has a good hardness and is useful for cleaning Aluminum Wheel. It is not easy to be scratched and the length of the brush is just right to get into the crevice and scrape out the dirt. Because it is easy to hold and polish, Wheel cleaning can be done efficiently at the time of the car wash. View detail
Convenient for cleaning the undercarriage.
You can wash off the dirt on wheels and underneath the SIDE sill panel that you don't usually wash, and you can wash off the dirt as well. View detail
You can clean the Engine area with ease!
You can wash the Engine area easily.
It goes into the Engine fin and cleans up well.
The price seemed high, but it is well built and will last a long time.
I also like the fact that it is Wound-proof and has a Rubber cover.
View detail
Perfect for washing your Engine fin
I purchased this for a Motorcycle engine wash for Vehicle
Cleaning the engine fin is now easier
I just happened to find this one in Harley's Motorcycle magazine It was available
View detail
The stuff is good But how do we use them?
You can connect the Hose and scrub it while letting the water out
… but if you have Sponge, you could have done without it …?
THE CAR WASH! I bought it because it looks like a good idea, but I don't get much out of it There may not be many places to use it for car washing
The quality of the brushes is good and distinct from the $100 Shop products
View detail