- Home
- Product reviews
- Search reviews
- Tools
- Hand tools
- Bearing Pullers
Reviews
Great tool, highly recommend
This way is much more precise. Works like a dream. Bought this tool for removing the small KTM Bendix bushings. It worked perfectly. Great tool for the price, was able to remove all of my bearings from my transmission in my KTM plan to rebuild my KTM with it as well, didn't have an issue with any of the small sizes, you just have to be sure that you are setting it up properly. Note that you'll need up to a 26 mm wrench or a crescent wrench. Seemed a little pricey for a tool you do not use that much but it will serve generations of riders in the family. Tips: Don't forget to grease the sockets, center them exactly and tighten them. View detail
It's essential to remove the Bearing!
[How is it used?
I bought this to replace my wheel bearing.
Was the one you received as per Image?
For a DAYTONA product, there were many detailed images and it was as Image.
How was your experience with it?
I was afraid because I used it for the first time, but I was able to remove it firmly because the Instruction Manual was written on it.
There are many ways to remove the bearing, but I think it is quicker and cheaper to use the proper tools.
This time, I bought a product made by DAYTONA because I bought it together with other products, but I think that the source is probably the same as Bearing Puller sold in Astroetc.
Now it's just a matter of how many times you'll use it in your lifetime.
It's a good price.
[Points to note]
A case has arisen where the legs are not long enough to remove the Bearing.
This was also written in the Instruction Manual, but it says to use it as an extension.
So I was able to stretch and take the Nut I had lying around as an Extension.
Also, it seems that the contents are not sold separately, so if it is damaged, it will be sold again in Quantity:You will have to purchase a Set, so it is a good idea to read and use the Instruction Manual carefully.
How did it compare to other products?
This is my first time, so I haven't compared them, but I was able to remove them easily.
Other items that would be helpful
It is written in the Instruction Manual that it is good to apply Molybdenum grease to the moving parts.
View detail
Price suitable
I purchased it for Wheel and hub's Bearing exchange.
Put Puller in the hole of Bearing, spread out the cracked part, wear a steel bar with Slide hammer, then grab Hammer and thrust up with GunGun! At first, however, Puller slipped out of the hole of Bearing. Apparently, the impact of Hammer caused the Screw of each part to loosen and the expanded cracked part seems to return to its original state.
So, when inserting the Puller in the hole, it is necessary to firmly fix the cracked part using Wrench etc..
Although it may be difficult to reuse Bearing after unplugging it, I think that there is no problem if it is used as an exchange premise.
View detail