- Home
- Product reviews
- Search reviews
- Tools
- Electric Tools
Reviews
I didn't think you could even get Grinder from Mr. WeBig.
It can be used for a variety of purposes, such as cutting a bracket, removing paint before re-painting, or cutting a block or tiling in a bicycle parking lot.
The price was the lowest on Net if including Point.
I think the product itself is cosmetic. There is no Drill when you look at the top, but it is enough for general Users.
View detail
It's useful for what it is.
[How is it used?
I purchased this product as a replacement for a hexagonal shaft Drill that I had on hand that broke.
I chose this one as a consumable because I couldn't help but shake and break it when hand-held with Makita's Impact Driver.
Was the one you received as per Image?
It was just like the picture.
How was your experience with it?
This is a Level that has been used a few times on a tanned Screw head yet, so it has not broken off.
I wondered if the previous Drill was not good enough, or if this product seemed to have less blurriness, as if it was firmly axed. (Brush - maybe...)
The cutting speed was not as fast as the manufacturer's claims, but I think it is usable in its own way.
However, there are only 8 pieces between 2-6mm, so you can use a little finer or more frequently used pieces in Quantities.:I thought it would be more useful if there were 2pcs.
[Points to note]
Be careful not to apply too much force, though this is not limited to this product.
If used in a blur Large tight situation like Impact Driver, it will break immediately.
How did it compare to other products?
Until now, we have been using Chinese drills and unknown manufacturer's products available at home centers.
It is not dramatically better than that one, but I think it is usable in its own way.
【Review】
I'm not sure if you can experience it as much as Manufacturer claims, but I think it can be used there.
However, I felt that the number of pieces was small and I would like to see up to 8mm pieces included if possible.
View detail
I used it for Chain cut!
[How is it used?
Currently used for Chain cut.
How was your experience with it?
Although I was looking for an Offset that can be used for Chain cut, I bought it with the feeling that the performance was good and the price was comparatively cheap because I did not understand this kind of consumable until I used it.
I only use it for chain cut, but it grinds well. It took me about 5 minutes to grind one part with the Large.
The wear is normal, not extremely worn out, and it will work for the foreseeable future.
How did it compare to other products?
It is a domestic Manufacturer and the price was relatively cheap.
[Points to note]
For safety reasons, it is recommended to run a test run for about 60 seconds before use to make sure there are no abnormalities.
If you keep the contact angle of 15-30° in mind, you won't get bounced.
Other items that would be helpful
Whether there are Included Parts:/ Items that should be purchased together/Opinions and requests to the Manufacturer
View detail
Confined space
I bought it for corrosion, dullness and polishing of aluminum.
It is useful for polishing narrow places, but it is not efficient for wide area. It's good that you can switch the rotation speed, but Buffing has to be applied lightly to get a good load.
It would be nice if it came with a few more polishing tools, but it's subtle in terms of Cost performance.
And it limits the opportunities for you to play a role.
View detail