Reviews
PRO TOOLS D-type carburetorTool
I purchased a similar product from CHINA, but it was not only inaccurate but unusable, so I purchased this one.
It is a little expensive compared to similar products at 770 yen, but I wish I had purchased this one from the beginning because it would have been useless if I couldn't use it.
I had the impression that it was not in the category of high-end tools Brand, but I was satisfied because it had a good texture, was comfortable in my hand, and above all, the precision was neat.
View detail
Frankly
[How is it used?
I had been doing my best with the tools I had on hand when tinkering with the carburetor, but the driver I wanted to use sometimes went somewhere, and I thought it would be more efficient to have a dedicated tool for the job.
Also, a certain degree of Small Type is used for Quantity:I chose this product that became a Set because it seemed easy to use.
Was the one you received as per Image?
The size was just like the Image.
How was your experience with it?
It can be used so-so when tinkering with carburetor.
Since the tip is reasonably strong and well-made, you should be a little careful when removing adhering Jets.
Small Type is easy to use with a good Point and does not take up much space for storage.
I think it is better to put it in a bag to avoid losing it when storing it, especially since it does not come with a bag etc.
[Points to note]
Be careful not to lose it, as it does not seem to be sold in Rose.
How did it compare to other products?
We use KTC's driver for carburetor for Pilot Jet, but KTC's tip is still better made.
But, well, I thought this product would be sufficient unless you are working on an abandoned car, etc.
【Review】
If you are new to carburetor for now, you can use the Quantity:I thought it would be good to be a Set.
I am happy because I no longer have to select and prepare several Drivers for it when I play with carburetor.
View detail
It was easy to use.
When adjusting the Screw, it would be nice if the Driver had a sills. View detail
A must have in CVcarburetorRestore
The CVKcarburetor, which is commonly used on kawasaki vehicles, has a press-fit Valve seat and cannot be replaced by the SeatSingle Body.
However, it is too stupid to replace the body just for that purpose, but once the tank is rusted, the motorcycle will be damaged by the rust powder and the seat will be damaged.
I used to cry myself to sleep, but when I found out about this product, it changed my world. It actually polishes well and looks like new.
The hang should be of the right size. The large size will not fit in the valve seat and the small size will hit the slant and distort the seat.
View detail
It's cheap
It works just fine!
this [Contents] Longer Slotted for easy to use throw adjustment of the quadruple carburetor to If the screwdriver is a Quantity:Set would be even better! I have one, so I didn't really need it
Those who buy from scratch buy additional tools as a matter of course they need to buy additional tools, and
View detail
Although an end part may be notched and it may be good for cleaning up, is a hole extended if it uses too much? Using a thin wire and 1000-sheet through now also by will be lost.
Although an end part may be notched and it may be good for cleaning up, is a hole extended if it uses too much?
Using a thin wire and 1000-sheet through now also by
will be lost.
View detail