- Home
- Product reviews
- Search reviews
- Maintenance
- Hose Joint
Reviews
Handlebar position changed, brake hose length increased.
The handlebar position of the Yamaha Bolt R-Spec is too far away, so I used the Handlebar Riser 2 Inch and installed the STD Handlebar. (Switch holes in place as they are) 、 2-inches (approx. 5 cm) I brought it to the front, and Position became much easier.
If the handlebar position is moved forward to the 2-inches maximum, when the handlebar is turned to the full Left position, the brake hose (and Accelerator cable) is fully extended and there is no room to spare,
Replace Brake hose with a longer one
・Brake hose joint (this product) Installation
and finally installed this product.
(At the same time, the Accelerator cable was replaced with a 15 cm longer one. HURRICANE:HB6471)
This product is a Joint between Reserver tank and Hose.
Air bleeding of the brake hose is required when installing this product.
This Joint is a Universal Product, so it can be used in a wide range of applications.
I would like to use it in this condition for the time being.
At any rate, the problem is solved and I am satisfied.
View detail
Convenient Hose
Introduced because OEMHose is not long enough for the Clutch master change.
It is a grateful product that lowers the threshold of MASTER exchange at once.
Eventually, I'm planning to redo MASTER to Release, but for now, I'll go with this.
View detail