Reviews
Used with BURGMAN 200
Used with BURGMAN 200
I lost the clip nut that holds the lid of the battery case under the foot board, so I was a little anxious about the size, but I bought it.
There was a 0.5mm hole gap between the battery case and the case, but I was able to install the case without any problem.
View detail
For Cowl installation.
I bought this for Cowling installation on my CYGNUS X2 model.
I bought this as a spare because the clip nut gaps or falls off when I repeatedly remove and install the cowl.
Since it is only plugged in structurally, there is nothing to hold it in place if the bolt is removed, and the clip nut will be pulled and moved when the cowl is removed.
If it falls out and falls into the inner cowl or into the depths where it is difficult to remove, it may never be removed again, so I always keep a spare of the right size for my motorcycle.
This is an Image that is used a lot, especially on Scooters. Push rivet is often used for single vehicles.
The M5, M4, etc., may differ not only for each car model, but also for each cowl position.
Without the clip nut, the cowl cannot be fixed and may break or fall off due to wind pressure, so it must be installed on all Bolts.
View detail
For fixing plastic parts such as cowl
Grom's exterior is all Material:This clip nut is used to fix these plastic parts in place There are many There is a hole in the resin body and this clip nut is placed on top of the large body Since the screw thread is cut, the other side of the wood to be fixed to the screw has been cut into the screw thread You put the Screw in and receive it with the Nut over here
After all, the fixation only pinches in, so it shifts frequently The worst thing that could happen is that it comes off and you lose it So I wanted to get a part in advance in case I lost it Then I found out that KITACO provides them They are very conscientious
View detail
Is good
KITACO and ConvenienceParts, which offers a wide range of unlikely items, are Large Helpful
Again, I was able to fix the unavailable Nut
View detail
Ripi buying
I purchased because the thing attached from the origin rusted.
The shape is almost the same as OEM. Nevertheless, I could buy it at a price that is close to half.
It is a good item to keep stock.
View detail
I am saved!
The hands reach the itchy place, KITACO such a fine product is really appreciated.
You can also order OEM, but by examining the ProductNo section, collecting information with Net, it is troublesome to society.
The commodity itself was similar to OEM, and the installation was not problem at all.
I will continue to support KITACO.
View detail