Reviews
It's safe to use
We have just purchased Male and Female at the same time, as the stock of Bullet Terminal was running low, in order to review the Wiring of the Motorcycle's retrofit electrical components.
I try to stockpile these frequently-used materials in large quantities because I don't like to be interrupted when I run out of materials during a job.
Some of the No Brand products were shoddy, but I can buy Emon products with confidence. There were no defective products this time either.
View detail
crimping
This is used for re-crimping due to Cable disconnection from the terminal construction part.
Single Item sales, not too expensive, so it is good for purchasing only the quantity you need.
View detail
Construction
Wiring is missing and used for re-installation.
Single Item sales are inexpensive, so you can buy only the quantity you need.
View detail
Connection
It is used for redoing Wiring.
Just Right Quantity:It was just the right number of pieces to reASSY in a set.
View detail
Safe and DAYTONA products
I purchased this product because the handling of the Brake switch has changed due to a change in the Braking system.
We chose DAYTONA because we thought it was not the part to go out of our way to buy OEM.
It is a safe part that is neither too good nor too bad, but it would be surprisingly useful if there were a lineup of parts.
View detail
Used in Horn's Flat Terminal
The Wiring for the car Both Sides was short and was used to extend it. View detail
I needed it so I bought it with Female
If only it were cheaper …! I thought it would be cheaper, but I needed it fast, so I bought it.
Good quality!
View detail
Very ordinary Hira terminal
It is a very ordinary Flat Terminal.
I think it is rather expensive in terms of unit price.
However, if unit price is the priority, there will be too much left over and it will be hard to place Quantity.:If you search for a small quantity, you will find only products with "1 Set of 100pcs." and if you search for a small quantity, you will find only products with "Quantity:1 Set of 3pcs. etc., which is too small.
In this regard, this product is available in packs of 30 pieces, allowing you to choose just the right amount of salt.
Later, it is also a high Point that it is in a Plus Chick Case.
View detail
It's solid.
We decided to replace the 3-pole and 9-pole coupler on the Speedometer side, which had deteriorated significantly over time. Since I did not touch the body side, I purchased only the female coupler without the terminals, so I also purchased these terminals. All you need is 1Quantity:2pc. I had only a set, but I thought I didn't need a lot of it, since the price was so high for a small number of items, but it was a good value for money.:I chose this one with 1 Set of 100pcs.
As for the product, although some of the bends were not so good, it was firm with appropriate thickness, and it fit into the coupler tightly.
There are still quite a few of them left, but the 110 coupler is used in various places, and there may be times when you want to modify it, so if you have it, it will come in handy sooner or later.
View detail
Simple functions
It is the switch of the simple function of only On and Off that omits an extra function. It is a switch that is easy to handle by DIY because the circuit is simple because it is only the switching function of the On and Off of the electric equipment. The appearance is also very simple. View detail
SilverPlating has arrived.
I received the SilverPlating one, which is different from the product picture.
The finish is good, but the Male terminals I bought with it were GoldPlating, so they are not aligned.
View detail
It's an itch I can scratch Target components
For the GSX-S125's Attachment power supply, it is used in conjunction with the Failure Diagnostic Connector to I bought this Connector to pull it in
(Take the Yoshimura's Temp meter power supply out of this Connector)
So-called 090 Water-proof type of terminals and general 0.5sq Response
Quantity:1 Set of 10pcs. so there's plenty of room for failure to a certain extent, and if there's any left over, you can save it for future use The amount that can be kept
The product name is Quantity:Set, but this is just a "Terminal + WaterproofRubber That means
Hence the "Male and Female Quantity:Please note that it does not mean "Set"
(Specify "Male" or "Female" at the time of purchase.)
And, of course, just because you bought this "With a pong is not possible
Crimp work using Electric Works Pliers is required, so this point Also note
View detail
Fits: KAWASAKI Universal, KAWASAKI Universal
When attaching an external blinker to a kawasaki vehicle, if Colet has, it is not necessary to process pure wiring.
When attaching an external blinker to a kawasaki vehicle, if Colet has, it is not necessary to process pure wiring. View detail
If an electric system, especially the parts which secure a power source from a battery are attached, it may be good in purchasing about 1 set of mulberry type terminal set corresponding to the bolt size of its own battery. If the housing in which the
If an electric system, especially the parts which secure a power source from a battery are attached, it may be good in purchasing about 1 set of mulberry type terminal set corresponding to the bolt size of its own battery.
If the housing in which the size of a bolt may not suit depending on the purchased parts, it will become waste of energy if it goes to buy it then, and the battery is stored is narrow,
It is because this work is unexpectedly troublesome, not being made to bite with the terminal currently attached to the bought goods from the beginning.
Moreover, it will be found useful if you set and buy the exclusive pliers for the crimps of a harness (shielding wire), etc.
View detail