Reviews
Fits: HONDA CB250F, HONDA 400X, HONDA CBR400, HONDA GROM, HONDA CBR250R (2011-), HONDA CB400F (2013-)
Rattling occurred on ours.
Rattling occurred on ours.
I looked for a washer, but even the slightest difference causes the problem, so I have to put up with it without an ultra-thin washer.
View detail
Fits: HONDA PCX HYBRID, HONDA PCX150, HONDA PCX150, HONDA PCX, HONDA PCX150, HONDA ZOOMER-X, HONDA PCX, HONDA PCX, HONDA PCX
There is a dress-up effect
The installation itself went without a hitch.
It is convenient to be able to adjust the width of the grip in six steps, but I don't adjust it often and I don't need this function.
The overall length of the Lever is long and difficult to grip.
I'm wearing a windshield, so when I cut the Handlebar to the locked position, it hits the windshield.
After using it for a while, I couldn't stand the discomfort and went back to OEMLever.
View detail
Fits: HONDA VFR800, HONDA CBR1100XX SUPERBLACKBIRD
Adjuster is too far away to adjust
OEMLever of CBR1100XX is far (Small hands) I bought it because.
Adjusting the position with Dial's Adjuster (6 steps) is possible, but the Position closest to Lever (6 levels of "1") But it's far in the "middle" or so of the OEM adjustment range.
Therefore, other Position cannot be used, and it is no different from fixed Lever. (As far as my hands go.)
Too bad, because the texture is good.
It would be nice if the Adjuster had a wider adjustment range.
(Quantity:Pair (for Left and Right) (At first, the LeftLever of the "Mere Old Man" was shipped with a non-conforming one. Later, we were able to replace it with a compatible one)
View detail
Fits: HONDA Forza Si, HONDA PCX125, HONDA PCX150, HONDA CBR250R (2011-), HONDA CBR125R, HONDA CB250F, HONDA glom, HONDA PCX125, HONDA PCX125, HONDA DIO110, KAWASAKI NINJA250R, HONDA CROSSCUB , HONDA Forza300
It does not correspond to the thickness of Les Bar End.
As I saw that I was out of impregnation before, I put water in Parts and Lever according to the instruction manual and as a result the Brake side finally succeeded after installing on a day when the temperature was high , Clutch side has expired. The cause is due to the fact that the elasticity is small, but it is forced into the thick bar end.
As a result, we attached a thin double-sided tape on the inside of the Parts and fixed it in a form to fix it in such a way that it made it inconspicuous. When considering purchase, I think that it would be better to prepare for it to expire.
View detail
Fits: HONDA EM1e, HONDA CROSS CUB50, HONDA CROSS CUB, HONDA Dio110, HONDA CBR125R, HONDA GROM, HONDA GROM, HONDA GROM, HONDA PCX eHEV, HONDA PCX HYBRID, HONDA PCX, HONDA PCX, HONDA PCX, HONDA PCX, HONDA PCX, HONDA PCX, HONDA PCX150, HONDA PCX150, HONDA PCX150, HONDA PCX160
I have run out when installing.
Since there are times when Lever is hot such as summer, I bought it. I included ample moisture and installed little by little, I was surprised it was torn down. Because it is a high item, please give me a more rugged product. View detail