Reviews
It's a very good idea…
I bought this because I was worried about it coming off when I lifted up in the V by myself.
Since the Hook and the receiver are fixed, the sense of security is perfect, but the moment I lifted up, it was torn off.
Did I use it incorrectly?
But I understood how it works, so I bought a slightly thicker Rubber Band at 100 yen and wrapped it so that it would be fixed in the same way.Rubber Band is cheap even if it breaks, so I started using Rubber Band after that.
View detail
welding failure
I have welding quality control qualification WES. There are two defective weld pits, and it is painted without repair. The company name and "made in Japan" are written proudly. I wonder if they are not ashamed. View detail
easy
Used for ZrX1200R.
Shaft bent easily.
Disappointing
View detail
It broke on the first try
It's a cantilevered vehicle with 230k miles on it, and it broke on the first lift up
I was worried that the shaft is too thin to be threaded through, but it was no good
I bought it after seeing a review of my use of cantilevered and 270 pounds Was it bad?
View detail
It's hard to know what kind of car it's for
I bought a body and V receiver for maintenance on my CB650F
After purchasing it, I noticed that the body of the car does not have the for Swing ArmHook mounting screws
I didn't check myself enough, so I gave up
I have now purchased the L-Shaped Receptor
So, here's the problem again..
Use for 400 CC or less on the product you received in the mail It says
Then I think there should be an explanation to the L-Shaped Receptor before ordering! But what do you think? I bought it with high expectations because of the good reviews from everyone on Maintenance StandBody! But I'm disappointed 。 It's a shame that I can't send it through WeBike's exchange or contact page, no matter how many times I enter the information
sad 。 I think it would be better if you considered a more detailed response
View detail
It is not usable
When using with GSX 1300 R HAYABUSA, Shaft is twisted by one shot. I bought another one but another one broke up with one shot.
When I talked about the situation via dealership "How to use" is bad
We also use GSX 1300 R HAYABUSA for explanation of how to use it, and we used it by using Axle Shaft for freeing a single finger, but we used it, but it is useless.
Considering the correspondence of Manufacturer, it is one of items that I can not absolutely buy.
View detail
Danger! Unstable! Purchase well thought out
I used it attached to Hazimete STAND
Anyway it is dangerous, unstable
When raising the car body the aim is not settled at the receiving part of the letter L.
As a result, the Gold genus of the L-letter touches the Motorcycle
Originally, I made scratches on the part that could not get scratched.
Also, I myself hurt while raising and lowering myself several times.
Manufacturer says that even if one gets used to the movie alone, it is said that it can be done alone, but in the case of using this L letter receiver, it is different.
This advertisement itself is an act of fraudulent act.
Large If you do not want to scratch your motorcycle
Anyway buy carefully!
View detail
Maybe I did not need it
Attention is necessary when using with Small Motorcycle.
The width of Swingarm is small and it can not be used unless it spreads quite inside like the attached picture (Using Jtrip's Short Type STAND) It is slightly unstable and scary.
With some Size Motorcycle, it will be useful under the condition that Hook bolt can not be used, but I do not think so much such a stuttulation.
The thing itself is solid and solid Cover of resin is considerably thick, I think that it will play a role in preventing Wound, and the sense of rigidity is also moderate.
View detail
It is not available for ZrX1200.
Because I could not use it, I returned it, but I can not return Gold. I have been waiting for about a week to get in touch with me to send back the returned item, but it does not reach one way. I was sent earlier when I contacted you from here - -. In other models, JTrip's Wide Type Rear stand was also on sale, so if you can also sell for ZrX 1200.
I asked for it.
View detail
It was unusable for ZrX 1200.
It is expensive for ZrX 1200, but I bought it intentionally. But I can not use it anyway. After confirming JTrip's Homepage, contents that it does not conform unless it is a Wide Type. I was allowed to return it.
It was a product that we could not use for ZrX 1200.
View detail
It becomes impossible to have borne the weight of FZ1 and has bent.Although it checked with the Manufacturer whether they were inferior goods, it was rebuying it, since usage's was bad. Since it bent and height on either side was specifically dif
It becomes impossible to have borne the weight of FZ1 and has bent.Although it checked with the Manufacturer whether they were inferior goods, it was rebuying it, since usage's was bad
.
Since it bent and height on either side was specifically different, it used, having changed height on either side, but."music -- the time of sending the kept picture -- it is thought that considerable load was applied only to right-hand side, and it has bent" on it -- "-- you have a use stop carried out promptly, and the product concerned can newly purchase a Maintenance stands -- as -- " -- there is a reply and,Dissatisfaction remained not only in goods but in correspondence.
It was unavoidable and replaced with the product of the other company.
View detail
the Front stand was [ br ] borrowing although the Rear stand had its own thing until now -- it is very convenient if you are too. This product was easy-to-use. It is also good to be able to perform height control. It could correspond to variou
the Front stand was [ br ] borrowing although the Rear stand had its own thing until now -- it is very convenient if you are too.
This product was easy-to-use.
It is also good to be able to perform
height control.
It could correspond to various Motorcycles in an attached color.
Front-fender Brake-lever Bikini-cowl Blinker from which the metal fittings which are made to raise the STAND which
, however I bought, and are fitted over the hole under a Stainless in about 12 hours broke, and the Motorcycle broke down is damaged,
Crack countless in a right-hand side side ... Is it
individual specificity (?)? is it better ? and to seldom keep raised for a long time?
It is the minimum for the time being.
View detail