- Home
- Product reviews
- Search reviews
- Motorcycle Gear
- Protectors
- Spine Protection
Reviews
Hard looking Image and actual defensibility is questionable?
Used for the company's Jacket. The company's claim to fame is that it has become a buy Kit Lack. "Competition only." Spinal Pad's top-of-the-line MODEL. Lightweight design The only thing I thought when I got it was that it was designed to be lightweight. The reverse side was also dented, but the surface was still exposed, so I put a cushion material with double-sided tape on it at the home center. The plastic board BALI was also there and I thought it might catch the mesh netting and tear it, so I cleaned it up with Nipper and installed it. But I was worried about the shock absorbing power of the original Cushion, so I cut the original Cushion a little and put it on top of it. As a result, the shock absorption was improved by the double layer, and although I thought the thickness of the pad would be noticeable from the outside, it was not a problem as long as I did not hunch over. View detail
When the number of these Pads was one, they were thin and uneasy, but by piling up two sheets, he thought that it became required sufficient thickness and the protection engine performance, and it purchased. It becomes the thickness considered to be
When the number of these Pads was one, they were thin and uneasy, but by piling up two sheets, he thought that it became required sufficient
thickness and the protection engine performance, and it purchased.
It becomes the thickness considered to be enough required to put two sheets on
up to its expectations, and since it is a product made from a Urethane
, it is good not to interfere with a motion.
-- since it is mesh state and the heat in a Jacket can be given off outside also with hot time, such as summer, again --
-- from this to time, it is likely to be found useful.
I think that I will divert to a Mesh jacket besides
.
View detail