Motorcycle Bag / Box Attachment Bracket Reviews

Filter

Write a review and get Webike Points!

Reviews

Bag / Box Attachment Bracket Clear all

GIVI

05 Nov 2023

Fitting for Monorack [5137FZ]

Fits: BMW F900XR, BMW F900XR

Japanese Webike user

2/5

RearCarrierQuantity:Pair (for Left and Right) The bracket does not align with the base mounting holes on the top case.

I purchased this product to install GIVI's Mono-lock case 47 on my F900XR. I would like to comment on the installation process and the state of use.
(1) RearCarrier's Bracket is LeftOnly Right and Quantity:Pair (for Left and Right) Since there is no Bracket to link the Quantity:Pair (for Left and Right) There is some difficulty in determining the horizontal state of the Bracket.
The ?Instruction Manual is somewhat confusing.Quantity:Pair (for Left and Right) It would be good if the distinction between Bracket and the reverse side is clearly indicated.
(3) Base plate hole and quantity on the bottom of Top case:Pair (for Left and Right) Bracket holes are FrontQuantity:Pair (for Left and Right) Two of them fit, but not the Rear. However, the Rear hole was not inserted, and since the Bolt hole was shifted from the normal position, I am not sure about its strength.
Also, the position cannot be adjusted back and forth.
?There are no strength or other problems so far in using Top case, but the position of Top case is quite high.
I would like to see the Bracket extending to the rear of the vehicle reshaped so that it is lower. Also, the Top case is slightly further rearward than the rear wheels. View detail

HEPCO&BECKER

27 Oct 2023

Top Case Holder Easy Rack

Fits: YAMAHA FZ1 Fazer

Japanese Webike user

5/5

Can be installed as per Instruction Manual

I wanted a RearCase for my FZ1, and when I searched for one, I found either Hepco or GIVI, but GIVI requires a little modification to the cowl, so I chose Hepco, which I was told can be popped on.
The delivery time after placing the order was about a month. This is as advertised, but I think they probably ordered it from Germany.
The Carrier's bar was sticking out of the step ball when it arrived, which was not acceptable, but there was no damage, so I installed it as is.
I don't need Special Tool, but it is surprising that I needed 13mm Spanner. It is a size that is not often used.
The only part that was a bit difficult was removing the pin that holds the Tandem Footpeg. I managed to remove it by making full use of the radio pliers and pliers I had on hand.
The Instruction Manual is only available in English Version and in German, but there is a PDF version of the Manual on the ManufacturerSite, so if you download it and write a translation, you can see the translation (you can see it by typing here, but it's not that difficult). It is not in English version, so I think you can read it as it is.
If you are a beginner, it is better to work with two people. One person could hold the Carrier and one person could tighten the Bolt.

The accuracy of the parts was fine and came on Beauty. There was no particularly bad Gap or Bolt not closing.

As a precaution, when attaching the mounting plate of the Case, there were cases in which the Plate lid would not fit depending on the position of the Bolt, so it is like looking for the position of the Bolt while thinking about how to close the lid.
If the Bolt is not oriented as per the Instruction Manual, the tool will hit the Body, use a Spanner where the Wrench will not fit, etc. View detail