Reviews
Without it, the Monokey case cannot be installed.
[How is it used?
Mounted on CL250. Small modification is required as it is a non-Manufacturer recommended installation.
Was the one you received as per Image?
Since the material was plastic, I thought it would not be that strong, but I was surprised that it was quite sturdy. I was surprised to find that it was quite sturdy. There was no bending or pulling and the quality was solid.
Was the installation difficult?
Since the installation was out of conformity, it was difficult to align, etc.
How was your experience with it?
The Monokey case is securely attached and can be removed smoothly without rattling or snagging.
[Included Parts:were they on?
Bolt & Nut4Quantity:Set, 4 pieces of mounting hardware, 4 base plate side seat golds, base plate lid, 6 screws for fixing the lid, Instruction Manual
These were included in the package. The lid fixing screws can be installed in the middle two places in addition to the designated four places, but since you have to drill your own holes in the lid before fixing it, I think four places are sufficient.
[Was there anything that disappointed you?
I am slightly concerned about the BALI residue on the Base plate edge. Since overseas products tend to leave these areas as they are, this is to be expected rather than expected, but if you are concerned about it, you may want to treat it.
View detail
It's not Waterproof.
I don't think there's anyone who doesn't know about Kriega products who would buy it….
Only QUADLOC LITE can be attached, less waterproof, SizeLarge fine-grained additional bag.
In case you're wondering, you can install it on just one side.
No waterproof function.
May be a subtle alternative to →Kriega Harness Pocket
There is a slight interference with the recommended installation position of the hose on the HYDRAPAK.
→ This back floats a bit, so it's possible to hide it on the back...? (I haven't tried it.)
There's a little bit of Pad-like substance in it.
→ It seems to be for mold prevention, not protection.
I think the only people who will buy this are people who use Kriega, and the price. Same old, same old. It's like...
I think it's expensive for people who don't mind other products and don't need to unify them.
Since it is made of Codura and Nylon, it is strong and can repel some water.
I don't care if it's damp, just get it out.
I think it's good if you want to put the stuff you always put in the pocket of RiderJacket.
View detail
Fits: KAWASAKI ZX-25R SE KRT EDITION, KAWASAKI ZX-25R SE, KAWASAKI ZX-25R, KAWASAKI Z800, KAWASAKI Z650, KAWASAKI Z250SL, KAWASAKI Z250, KAWASAKI Ninja ZX-6R, KAWASAKI Ninja ZX-10RR, KAWASAKI Ninja ZX-10R, KAWASAKI Ninja ZX-10R, KAWASAKI Ninja H2 SX, KAWASAKI Ninja H2 SX, KAWASAKI Ninja H2 SX, KAWASAKI Ninja 650, KAWASAKI Ninja 650, KAWASAKI Ninja 650, KAWASAKI Ninja 400, KAWASAKI Ninja 250SL, KAWASAKI Ninja 250
Purchased because it is essential for SMARTBack
I bought it because it is necessary for SMARTBack, but I thought it was very expensive. 500 yen is reasonable. View detail
Rose skirt for sewing
Porch, even at Tank Pouch P. A. Since I use SS system, I purchase it additionally.
The part to clasp the back : Sewing of Magic tape (Seam allowance) It is sloppy and can not be stopped by Beauty. (I do not measure individual Length as chitin)
I like cutting it and sewing it again, but it is the worst
From there, it can not be said that Magic does not start to peel off so you have to have it purchased in-kind or checked and shipped..
Because it is for Belt of the waist, so that it can be used for shoulder Belt of Rucksack, it is perfect if it can change the direction of 90-degrees.
View detail
It is a supplement part
Originally, BirdCity has a 30 L box
Assuming to replace SEROW with occasionally
I bought this Parts.
It depends on Carrier, but for installation
There are places where you care very much
It is cheap. (And there is no Rival) only this one
And thinking, I think that it is a good shopping.
Parts of concern whether the attached parts are rust or not
There is, but is this the point that said it is the point of departure
View detail
[Webike Monitor] It will be required if the Mono-lock case of GIVI is attached. Although one Base was attached to the Case, the method of attachment and the Base were usually separately purchased for one Case on two or more set Motorcycle.
[Webike Monitor] It will be required if the Mono-lock case of
GIVI is attached.
Although one Base was attached to the Case, the method of
attachment and the Base were usually separately purchased for one Case on two or more set Motorcycle.
engine performance is common well.
The
thing is not too bad, although evaluation is difficult only for a thing.
It is a problem, if it is called
or the number of points improper at this Base is also one.
View detail