Reviews
Used as Bracket for Switch on Grip heater
The Bracket that was originally attached was too long and was bent at the Prank, breaking it off at the base.
This time, I don't think it will be tampered with because the base LARGE size and height of the base are just right and not uncomfortable.
View detail
As a Bracket for Super slimStyle RPM Meter.
I don't use it as an ETC Bracket, I use it as a Bracket for additional Meter as the title says.
The diameter of the Bolt is the same as the diameter of the Handlebar Switch, so it's ideal for use with a Digital Tachometer.
However, the Material:Please note that it is aluminum and will break easily if you bend it too much.
Here is a video of the FZr1000 going through an ETC Lane.
View detail
Completely clean
Perfect for JRM-11 made by Japan Radio.
Tighten to Clutch lever holder.
Just because it is too conspicuous, I'm considering moving it around Meter.
View detail
It is a good deal..
I think that the usability is good because it is lightweight and it can adjust the angle.
However, angle adjustment many times (Bending elongation) Then, the surface Anodized (?) It seems Crack is in.
The hole of M6 mm is empty because it is used for fastening with the Clutch lever holder, but if it is 8 mm it can be installed anywhere..
I am satisfied because it is inexpensive compared with similar products of other companies.
View detail
Refreshing around Handlebar
Until now, I was wearing an ETC receiver with my own Stay, but other switches and so on also increased, and the surroundings of Handlebar got stupid. Refreshed by using this product. View detail
Structure and texture are satisfactory. This is although it is a problem of how to use me... In order that bending part might tune finely, when a little angle was changed by hand, the Anodized cracked. So big power was not necessarily put
Structure and texture are satisfactory.
This is although it is a problem of how to use me... In order that
bending part might tune finely, when a little angle was changed by hand, the
Anodized cracked.
So big power was not necessarily put and only a few is also changing the
angle.Is it a problem of the quality of the
Anodized?
For using it as it is, it is satisfactory.
View detail
Cling to a handlebar in combination with the handle clamp of Company POSH. The antennas and indicator of an ETC separated type can be stuck exactly. Since an angle can also be adjusted, a degree of freedom is high.
Cling to a handlebar in combination with the handle clamp of Company POSH.
The antennas and indicator of an ETC separated type can be stuck exactly.
Since an angle can also be adjusted, a degree of freedom is high.
View detail