Reviews
Fits: HONDA Today, HONDA Today, HONDA DIO(4Cycle), HONDA DIO(4Cycle)
Repair is completed at a low cost!
Installed on ThirdMotorcycle's Today that goes to the nearby Convenience, replacing an OEM OEMRear Suspension that had been scuffed up and deteriorated. The price is very low, but I have had no problems with it! I am Large satisfied with the low price and the refresh! View detail
Cowl mounting holes do not fit
Paint quality is good. It makes it look like a new car! I had to force it on with Tie Wrap or re-drill the holes … I think it may have been an individual mistake, but … I drilled the holes with a Drill and installed it. If you can install it, you will be supremely satisfied. View detail
fitment issues
I was excited to recieve this poduct. There are a few fitment issues with these plastics for my af27 dio. The front piece the 4 bolts on the back side only two line up the other two are so far off would need to enlarge holes to make it work. The top headlight piece does not fit well pops out on the one side and on the middle. The rear pieces seems to fit alittle better but not the best. View detail
neither good nor bad
I purchased this for my RC42. However, I could not install it as it is because it was a driving school spec. I modified it and installed it. However, it became Fixed Type which cannot be folded. View detail
Long tailDuck Tail Helmet
I was worried at the time of purchase that the size might be too large, as I had only chosen L Size, but it fit surprisingly well. View detail
Fits: YAMAHA jog, YAMAHA vino, HONDA DIO (2Cycle), HONDA DIO (2Cycle), HONDA LIVE DIO
Mounted on VINOsa-26j
I installed it on my VINOsa-26j, but I thought it would be easy to get dirty, so I went with Black.
I thought it would be easier to clean with Brown if it were this hard.
View detail
Fits: HONDA Today, HONDA Today, HONDA Giorno, HONDA DIO(4Cycle), HONDA DIO(4Cycle)
How durable is it?
Restore TODAY after many years of neglect, 4 years.
Will the Fork Boots break off from age?
I couldn't cut it out of my mind…
I noticed a tear and replaced it.
I thought OEM would be better in terms of texture. I thought so.
How long do you think it will last as a consumable?
I would like to verify this.
The protrusion for fixing the drum brake on the LeftFork was quite fiddly.
View detail
The price
Tucker required as a Large premise. not just a product to be covered.
Good fabric look and feel.
I'm not sure about the durability of this product.
View detail
So so
I guess it's okay…
The hole position is different or…
Fitting is subtle des…
It is good if you are not particular.
View detail
Normal is
This is a Universal Type Air Filter that you can cut yourself with Scissors or Cutter.
No particular problem. Normal The product is a product of Naturally, there is a time-consuming process to cut, so those who have trouble with this process
It is not possible to Recommendation to the
View detail
General Hose Band!
[How is it used?
I purchased this product as a FOR REPAIR because the Oil cooler hose band I use has rusted over time.
How was your experience with it?
The type is tightened with a slotted screwdriver, so it was difficult to apply Torque when tightening.
I think Phillips Screwdriver is easier to tighten.
How did it compare to other products?
It gives the impression of being cheap compared to other products, but since the use is for the Hose Band, there is no problem if it is considered a consumable product.
[Points to note]
Screw part is steel, so it rusts easily.
However, it is rare to find a Hose Band that is all Stainless Steel, even in other products, so this is not an option.
View detail
Leg shield LITTLE CUB
I bought this leg shield for SUPER CUB knowing that it needs some modification because of its low price. I installed it by shaving only the part near the handle. I was disappointed with the position of the bolt fixing holes at the foot. I wonder if this is a defect of only the product I received? View detail
So bad
I am disappointed that it could not be used on my mid-size car.
The description commented that it could be used for Large type cars, but due to the tire width, it could not be used.
View detail
high quality
Solid Spring and durable.
It is convenient to use as for Repair and is inexpensive but of high quality.
View detail
easy to stick to
I put it up and it looked good and I liked it, but despite careful degreasing, some of it started peeling off after about a year. I used the MDF ones for about 3 years before I bought the new ones and they never peeled off. It was cheap, so if it lasted for a year, it would be a good thing. It's cheap, so it's possible to change it regularly. View detail
Seat is brand new.
I used HandTucker to reupholster my Seat. The only difference from the OEM Seat cover is that the back of the Seat is not covered. "Honda" There is no Logo mark in the View detail
Not bad, huh?
Used for YamahaJOGSA39J.
WaterproofRubber rubber on the back side of the seat and Hinge part were used without replacing.
If you do not replace the waterproof rubber on the back of the seat, the seat will not come up by itself because the rubber is too thin when you open it.
What if the durability doesn't go?
I think the price is high for this.
View detail
UniversalLamp
The Meter Bulb was out, so I bought this for Replacement.
It lasted 6 months, but I would buy it again.
View detail
It can be used normally
I think it looks good.
I've been using it with leds in it.
It can be used normally
I use it as an OEM substitute because it is easy
I haven't measured the optical axis, so I don't know.
It's good enough to use if you don't have a car to inspect.
View detail
Fits: HONDA LIVE DIOZX, HONDA LIVE DIOZX, HONDA LIVE DIO, HONDA LIVE DIO
External Piston may not be used.
I bought it to replace the piston ring, but when I removed the piston ring, it was already changed to an external piston, so I couldn't put it on. View detail