Reviews
Fits: HONDA dachshund, HONDA Shirley 50., HONDA Dax 70, HONDA Shirley 70
CHALY That!
CHALY I bought it to make a thicker footprint of the I am satisfied with the cheap price. View detail
Fits: HONDA XR100 Motard, HONDA dachshund, HONDA Dax 70, HONDA Ape 50, HONDA dachshund, HONDA Ape 100, HONDA Dax 70, HONDA Ape Type D, HONDA Mighty Ducks (ST90), HONDA Ape 100 Type D, HONDA Ape 50, HONDA dachshund, HONDA Ape 100, HONDA Dax 70, HONDA Ape Type D, HONDA Mighty Ducks (ST90), HONDA Ape 100 Type D
NTN Bearing
About quality and texture NTN always has the quality to trust and buy About the feeling of use It's not used yet. I had to buy two, but I only bought one Products to buy together rubber hammer Difficulty of installation difficult, hard Cost performance and comparison with other products It is the cheapest and has a reliable quality About shipping and packaging It took a week and the packaging is great Any concerns, cautions, or advice when purchasing I did two in quantity, but I couldn't check the quantity because I was purchasing other products first I should buy it again when I buy other products Since it is an old bike that is 10 years old, there are many things to be done, so it is the most important part of it, and the quality of it is also reliable View detail
Fits: HONDA dachshund, HONDA Shirley 50., HONDA Dax 70, HONDA Shirley 70
DAX70.
I wanted to get a matching wheel other than Silver.
It's like a semi-gloss black.
Just because it's Chinese didn't mean that the holes in the Bolt didn't fit, lol.
View detail
Fits: HONDA dachshund, HONDA Shirley 50., HONDA Dax 70, HONDA Shirley 70
To the DAX.
This is used for the DAX during Restore.
Black is semi-glossy.
It's not Black Anodized because the price is so low.
I think common sense would tell you that.
View detail
Fits: HONDA dachshund, HONDA Shirley 70, HONDA Dax 70, HONDA Shirley 50.
To the DAX.
This is used for the DAX during Restore.
Black is semi-glossy.
It's not Black Anodized because the price is so low.
I think common sense would tell you that.
View detail
Fits: HONDA dachshund, HONDA Shirley 50., HONDA Dax 70, HONDA Shirley 70
Excellent upgrade for OEM wheels
Bought to replace factory wheels, finish is a bright anodised silver, no scratches or obvious imperfections. The holes line up nicely and require no filing or changes to fit, came with new M6 screws and nuts. Once fitted there was no necessity changes needed for operation, chain clears the side and brake bracket is fine also. Definitely happy with purchase View detail
Fits: HONDA Dax 70, HONDA Shirley 70, HONDA Shirley 50., HONDA dachshund
Price suitable
Cheap Wheel. Material is unknown
The making was so so, there was a place where the holes were not aligned a bit.
Corresponded by deleting with File.
Large Because it is made of land, the making-in is sweet.
There was a co-wound with paint flaking
The attached Nut might be a little uneasy in intensity.
Because Valve's hole position is different from OEM, I think that L-Type Tube is good when purchasing Tube
With Direct Type purchased and attached to the car body, Rear
It became difficult for air to enter.
Attention required.
Perhaps because we are using four hubs for 3 hubs
There may be no choice.
View detail