Reviews
Alternative to Fork Boots
Cannot be installed without removing the Fork.
It was longer than I expected for XT250X, so I cut into the bottom to lower it.
It's been six months since installation and so far it's working.
View detail
Fork Protection
I thought if I was going to buy one, I might as well buy one that looked like a Parenthesis. Installation was easy. View detail
be tightened
The Inner Tube is a protective tube for the Inner Tube, which can be installed with a fastener so there is no need to remove and install the Fork. After installation, the Inner Tube is less dirty and clearly effective. The maintenance reduction in cost will be achieved in the long run because the dust seal is less likely to be attacked by fine sand and gravel. View detail
It is quite good.
Installed on CRF1000L.
Gold Outer tube can be hidden.
It turned out to be as good as the Image.
The rest is durability.
I hope the price is a little lower.
View detail
Highly effective products
I used to use DirtSkin Fork Gaiters on my DT200WR, but although they extended the life of the Fork Seal, the durability of the product itself was a drawback. I decided to install it on my DT along with the Fork Guard.
Fork gaiters have been sold by various manufacturers, but DirtSkin and other companies have been using the idea of adding a Dust Seal to their products, which inevitably causes friction and therefore wear and tear on the product. This product covers the entire surface of the Inner Tube to prevent friction, extending the life of the Fork Seal and protecting the Inner Tube from flying rocks and other debris.
View detail
Parts that work better than you can imagine!
Dust Seal was hardened and we wanted to ask Shop to replace it, but we were waiting for 2-3 months for maintenance! 。 For dust control, we hung the Stocking from the Fork with Magic tape. 。 Installed to check for leakage from oil seal. (And if you wash it, it will come off. W) In fact, the effect of dust on a motorcycle is large, and the life of a motorcycle is several times longer with or without a sealed chain and fork boots like a cub. 。 As long as you do the dirty → washing, I consider it a necessity that works quite well in bad weather and Dirt, as well as on dusty public roads. View detail
Excellent texture. Easy to install and expected to have Protection capability.
The anodized front fork was peeling and shabby, and to prevent further deterioration, a DirtSkin cover was used, but it too was worn out, so it was replaced with this ACERBIS cover. The Fork gaiter made by ACERBIS is also used.
The size is just right for the DirtSkin, which is a little shorter than the DirtSkin, and it seems to provide good protection from flying rocks, etc. The Velcro is divided into 4 sections for easy installation.
Color is Material:I chose Black because it is Carbon Style and I did not like the Red color of this product. I am satisfied with the very intrepid appearance coupled with the high quality.
View detail
Fork leaking after 10 hours or so! 70 hours no maintenance!
Used in Enduro race.
Before the installation of this, the oil was leaking after about 10 hours due to small scratches from dirt and gravel, even though there was no contact with rocks, etc. The leakage stopped immediately, and there was no leakage for 70 hours.
The top part is made of black cloth which is easy to stretch by itself because it rubs easily.
Installation requires a bit of hang, but if you first pull the top rubber cloth extra tight and fasten it with magic tape before starting to close the bottom fastener, it will close to the top with ease.
My YZ is ForkInner and 30mm Lowdown, so in NORMAL, the bottom of the Inner Tube will be fully visible about 30mm below the Inner Tube.
The Cover part is made of PeLePera cloth and is easily torn, but even with a few holes, there are no problems with functionality after 70 hours of use. There is no Trouble such as roll-in, drop-out, or Gap.
It is machine washed in Net after each run and shows no deterioration due to washing.
View detail
Texture, durability, and the Exactly feel to the YZ250FX are all good!
'I am using it on a 21YZ250FX.
When used with the company's Fork Gaiter, it can be installed Exactly without gaps.
I bought it because as soon as it becomes an Enduro race, the Fork outer will be covered with a number of flying stones.
Installation should be easy for most car models due to the 4-part Magic tape.
It is not a mere rubber board, but has a three-dimensional woven pattern that gives it a high visual quality. However, if soil gets into the weave and dries out, it is a little strange to wash Large. It can be kept clean by scrubbing with water and Brush after each run.
I remove it every 20 hours or so, put it in the Net and wash it in the washing machine, but there is not even an atmosphere of damage.
I have used it for 90 hours and so far it has not peeled off during use, there is no deterioration or damage to the Rubber part or the Magic tape.
It's a reliable product
View detail
Stylishly.
[How is it used?
I was riding with Headlight Mask + BellowsBoots on my RM250 with upright suspension, but I often get mistaken for an RMX and BellowsBoots looked tacky, so I replaced them with this product.
I had worn them when I was riding my RM125 a long time ago, and I knew that they were very durable for the price, which was also a Point of my choice.
Was the one you received as per Image?
As per Image
Was the installation difficult?
It is not a magic tape fastening type, so you need to pull out the fork once and put it back on.
How was your experience with it?
Parenthesis is great.
[Included Parts:were they on?
Not particularly
[Was there anything that disappointed you?
Not particularly
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
I have not yet taken it to a course where I would do Inner Tube like White well, so I don't know how well it protects it, but it is quite thick, so I think it will protect it.
View detail
Great
Carbon fork guard was broken or drilled, so I made it here.
I think that it will not be torn by a little thing because there is thickness.
ACERBIS has long been a reliable ItalianParts.
View detail
It looks like Sharp.
The Fork of the TT 250 R RAID was degraded and replaced.
Installation was also easy with the included Tie Wrap. Appearance improved Parenthesis.
I heard that deterioration is earlier than Bellows, but because it is cheaper than Bellows, it is good.
View detail
Since the Suspension is reached although a Wrinkle is caused if it is running, it can do what. It is very a Cool, and appearance deteriorates like a sushi Fork boots, and does not become scattering.
Since the Suspension is reached although a Wrinkle is caused if it is running, it can do what.
It is very a Cool, and
appearance deteriorates like a sushi Fork boots, and does not become scattering.
View detail
Since the pure Fork boots had been cracked, this product was used at the exchange occasion. Since a authentic positive one was a form with quite a many Volumes, he thought whether change here and to carry out a few slimly, but he has a feeling w
Since the pure Fork boots had been cracked, this product was used at the exchange occasion.
Since a
authentic positive one was a form with quite a many Volumes, he thought whether change here and to carry out a few slimly, but he has a feeling which became a Sharp rather individually, and it is pleasing.
However for using for the Inner Tube of a DJEBEL, it is a place [ want / to a slight degree / die length ].
In the touch with which it equipped, it is the last die length truly.
View detail
"I purchased when changing the image of the exterior of DT125R. Since I thought ""to make an OFF vehicle (trail) image light a little more"" I decided this!! It is recommended for who ride on the OFF vehicle for commuting or a run in the street. I don't c
"I purchased when changing the image of the exterior of DT125R. Since I thought ""to make an OFF vehicle (trail) image light a little more"" I decided this!! It is recommended for who ride on the OFF vehicle for commuting or a run in the street. I don't carea bout it although it does not immediately get dry after a car wash. it is very fashion. " View detail