Reviews
It's the same color as Babyface's Gold!
I changed to Orange color of KOODfootpeg because GizaGiza of the bar of the Rear Sets made by another company was decreasing in CBR600RR which does Circuit running.
[About dimensions and universality
Screw of M8×Pitch1.25 is cut in the center of footpeg.
These dimensions are common to all manufacturers and can be used to repair, reuse or change the specification of a wide range of manufacturers' rear sets. The length is 75mm excluding the half round part of the end, which is the length from the end face of the GizaGiza Bar End machining.
It was about the same length as the Babyface footpeg, see Size comparison photo.
[About the color]
I combined it with Racing Footpeg made by Bebyface (Babyface).
This is the so-called Large Han Gold Footpeg Kit, and as expected, KOOD is also the same Large Han (laughs).
Orange color = Large Han Gold. This was a happy miscalculation.
And KOODLogo appears quietly in Bar End.
[Knurl processing]
I'm not sure if this is a good idea, but I think it's a good idea.
I don't know the durability of this machined part yet. If it decreases, you can rotate it.
[Caring design]
If the plate is broken from the root or deformed to a large size when it falls down, it will be impossible to run again.
This bar has two cuts in the middle (thin-walled part), and even if you fall, only the tip will be torn off, like the tail of the Lizard. the president of KOOD is a RACINGRider who runs the Suzuka 4-hour race himself, so he knows the importance and ingenuity of this area. It has been made.
【Installability
To hold the bar when inserting the M8 bolt from the back of the plate, insert a bar such as Hexagonal Wrench into the horizontal hole and tighten it.
As a result, the retightening process was a little more difficult than the 2 chamfering process for Spanner, but this structure allows for a longer Knurl section, and the design may be simpler.
Please refer to the comparison photos here as well.
View detail