Reviews
![[KEDO] Front Fork Boots](https://img.webike-cdn.net/catalogue/images/56985/JVB0031_TS.jpg)
Massive impression of XSR700
The front fork is an item that changes the impression of XSR700 and MT-07, which may look a little weak.
After much deliberation with the Fork Boots made by Wysskia, we chose these, which look thicker.
There was a concern about the fitting aspect with OEMOption, but there was no problem at all.
If you don't have access to a shop where you can remove the Fork, you should ask the shop to do it for you.
There are three small holes on each side for air to enter and exit the Boots, but they are still blocked when purchased. You can shred them by picking them up with your fingers and pulling, but I think it is easier to shred the remaining BALI after poking them with a thin tip. If the vent hole is not opened, air will be forced out when the Fork shrinks, and the negative pressure when it expands will cause the Boots to cave in, resulting in a very poor parenthesis. (I've done this).
It is also recommended that the pre-2020 XSR be fitted with the OEM ForkUpper Cover for MT-07.
1WS-23121-01/Cover, Attp 1
1WS-23131-01/Cover, Attp 2
43F-23188-10/O-Ring
*O-ring is a Quantity:2pc. Set required
These three items can be purchased together at WeBig.
View detail
![[KEDO] Footpeg](https://img.webike-cdn.net/catalogue/images/56985/30977_TS.jpg)
Exactly on 2015MT-09To Racer
I installed this on my 2015 MT-09 toRacer. The OEM footpeg on the MT-09 is not suitable for long touring, so I replaced it with this footpeg. I feel more stable and it is easier to do ankle grips and standing.
The Left SideOEMfootpeg of the Racer has a crimped pin, so it was necessary to file off the crimped portion before installation, which was also done without difficulty.
View detail
![Kedo] Front Fork Boots](https://global.webike-cdn.net/photo/impression/aa/aaef0e462e7bfb238f655c3f4f884ad4L.jpg)
To SCRAMBLERCustom
These are normal Fork Boots. You will need to remove the fork when installing.
The Boots themselves are easy to install.
More than that, the OEM Fork Guard O-ring is a curmudgeon.
This makes it difficult to re-fit the fork as it can get stuck or twisted.
Caution.
View detail
![[KEDO] Footpeg](https://global.webike-cdn.net/photo/impression/03/03eb30915f75b040dea4cc6845b5e074L.jpg)
Style and comfort are GOOD!
This is the Footpeg I used for the SCRAMBLERCustom on the MT-07.
It will be of EnduroType.
Simply remove and replace the OEM Product.
If you have trouble removing the split pin, you can cut off the butt part with a nipper.
It is very wide so it is very stable with legs on it.
It is moderately toothed, has less Damage to Shoes and is less slippery.
Standing is also easy.
The Knee Slider will be gone, so if you have concerns in that area, give it up.
View detail
![Kedo] Front Fork Boots](https://global.webike-cdn.net/images/reviews/455/00001016455L.jpg)
No Doubt, perfect fit!
It's not cheap but worth As you can see, It's perfect fit for XSR700 By the way I'm not sure is it brand new, becoz it has many scratch on the surface. View detail