Reviews
periodic replacement
I installed it to prevent foreign matter from entering the tank, and it is about time for regular replacement. The price is not that much, I can see how dirty it is, and it is easy to replace, so I think it is easy to use. View detail
Small Type
Small type as a fuel fliter, and since it is a paper base, it is the one that you should be most careful about in terms of narrowing down the flow rate.
However, because it is a Small Type, there are many cases that are convenient for placement.
View detail
Select the carburetor to be used depending on the flow rate.
When I use this filter on a Motard 115 with PE24, I don't get any air bites in the filter if I don't open it all the way, but if I pull it all the way, the gasoline supply can't keep up with the filter and it's completely useless.
It is not suitable for the car that uses the fuel cock of the fuel hose of φ6, so it is necessary to pay attention.
View detail
Filter
I've installed it to prevent garbage from getting into my car, and I don't have any problems, but it's a bit large. I think it is a little large;
This is a spare, next purchase for Replacement.
I would like to buy something else next time and try it.
View detail
Oil Resistant Rubber Type Gasoline Hose
Fuel Hose. I don't remember why I bought it. Well, I can use it around Gasoline, so I thought it would be useful if I had it in case of emergency. View detail
Difficult to use for the ELIMINATOR 250
"The OEMCook on the ELIMINATOR 250 got clogged, so I replaced it.
It's a non-negative, natural Fall Type Cook, and since the Hose bore was the same as the OEM, the Gasoline flow rate is probably the same as well.
There are not many Main, Reserve and Out three-port types, so these Third Party products are useful.
Because it was not possible to install normally, I put Bracket of Emon on it, but there was no rattling or shaking and I could use it without any problem.
Cook's placement is generic, ↑Reserve, ←Off, ↓On.
But there is one problem. Because the mouth of Out is on the Right Side, it interferes with the Frame in the case of the Eliminator. I think that gasoline flow rate is reduced because of this.
If you have a car model with Space on the Right Side of Cook, you should have no problem. "
View detail
Easy to use, but the price tag?
Smallish paper disposable fuel filter (Part number 96452) 。
For some reason, this one is more expensive than the Large Kisa one, which is easier to use than the Large Kisa one, so I feel the manufacturer's intentions.... It is installed between VT Normal engine and OEM cap
This type is to be discarded and replaced with a new one after a certain amount of use
I used it in a reasonably good tank after the rust removal treatment and it stopped running after 16,000 km because it got clogged I did Not just rust, but Gasoline scum? The eyes seem to get clogged up with For your information
There is also a larger size type, but if the flow rate is higher than this, you can use the It's in the Instruction Manual, so you can install the Big carburetor, etc If you have concerns about fuel shortages, please be aware of them
Also, it has been functioning well by removing the fine rust that came out of the tank little by little It is Definitely recommended if you have an older vehicle and are worried about Tank rust
View detail
It is safe.
I bought it is Hose with inner diameter φ8, I use it for negative pressure Hose of Fuel Cock. Previously I used ordinary Fuel Hose but due to the heat of the Engine, it has become Cha Chi a few years, this time I purchased this item for durability. View detail
used for the VT250 SPADA of a Honda -- since it was an old vehicle type, there is hardening -- a measure -- since it was a Type cut by it although considered and exchanged, it could exchange by required die length and was saved [ who was able to use
used for the VT250 SPADA of a Honda -- since it was an old vehicle type, there is hardening -- a measure -- since it was a Type cut by it although considered and exchanged, it could exchange by required die length and was saved [ who was able to use having felt easy without the leak etc. ]
View detail
It was large beyond anticipation. However, since an inside can be seen clearly, exchange time is likely to be known immediately. A filtration function is [ high ] also so, and since a price is also cheap, the direction which thinks that it will ex
It was large beyond anticipation.
However, since an inside can be seen clearly, exchange time is likely to be known immediately.
A filtration function is [ high ] also so, and since a price is also cheap, the direction which thinks that it will exchange an authentic positive ones recommends you here.
View detail
It purchased to the carburetor breather pipes of RZ. The breather pipe which became old becomes hard, and if it bends, it will break. It does not return to origin, with a terminal area with a carburetor spread. When two or more vehicles are ow
It purchased to the carburetor breather pipes of RZ.
The breather pipe which became old becomes hard, and if it bends, it will break.
It does not return to origin, with a terminal area with a carburetor spread.
When two or more vehicles are owned, since it can be cut and used for required die length according to a car, it is convenient.
A breather pipe is OKed although it has written that it cannot be used for a gasoline? I will hear that it is good if not always exposed to the gasoline.
View detail
The former owner had attached two-piece Sakka's tank to DASH125 of me, and when the original tank was not using it for the blind cork, having carried out, and it enabled it for two tanks to use in order to lengthen flight range, it used this. Small Ho
The former owner had attached two-piece Sakka's tank to DASH125 of me, and when the original tank was not using it for the blind cork, having carried out, and it enabled it for two tanks to use in order to lengthen flight range, it used this.
Small Ho's tank was connected with the larger one to a main, and RES, and piping from two tanks has been suitably arranged at the easy-to-use place.
Since it was as the kana ? without saying like this was thought, bolt-on could be carried out and it was saved.
quality does not leak and is satisfactory -- it is .
View detail