Reviews
Fits: YAMAHA FZR400, YAMAHA TDM850, YAMAHA FZR400, YAMAHA SRX600, YAMAHA TT-R250, YAMAHA TT250, YAMAHA T225, YAMAHA TW225E, YAMAHA TW200, YAMAHA XV250 Route 66, YAMAHA FZR400RR, YAMAHA XJ400S, YAMAHA XJ400L, YAMAHA XJ600S, YAMAHA FZR600R, YAMAHA RZV500, YAMAHA XTZ750, YAMAHA SRX400, YAMAHA RZ250R, YAMAHA FZX250 ZEAL250
At R1-Z
It was used as a thermal countermeasure product for R1-Z.
The mounting pitch did not fit even after shaving and could not be installed with two screws, so it was fixed with one screw.
Coupler's Flat Terminal was also slightly thinner than the OEM one, and the couplers were not inserted properly.
I have reworked it.
I think heat dissipation is improved.
View detail
Fits: KAWASAKI Z1-R/Z1-RII, KAWASAKI Z1000 (air-cooled), KAWASAKI Z1000 (air-cooled), KAWASAKI Z1000
Bolt holes
The Mounting Bolt hole did not fit and I had to cut about 1.5mm off the long hole side.
The RegulatorBody is also very large, so I installed the Connector side upside down.
It's in good working condition, 14.6V, and it's charged.
If you think you can replace the battery with a sealed MFBattery with a little modification, this product will be large and durable.
View detail
Fits: HONDA CB-1, HONDA CBR400RR, HONDA CBR400RR, HONDA CBR600F, HONDA NSR250R, HONDA NSR250R, HONDA RVF400, HONDA VFR400R, HONDA VTR250, HONDA VTR250, HONDA VT250 Spada, HONDA jade, HONDA CBR600F, HONDA foresight, HONDA CBR600F, HONDA CB600, HONDA CB400FOUR (water-cooled), HONDA CBR600F, HONDA VFR750F, HONDA CBR250RR (MC22)
somehow not quite right
I still think OEM is the way to go. View detail
Fits: YAMAHA YZF-R6, YAMAHA FZ400, YAMAHA TRX850, YAMAHA SR400, YAMAHA SR500, YAMAHA VENTURE(XVZ1300), YAMAHA VENTURE(XVZ1300), YAMAHA VENTURE(XVZ1300), YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR1100Classic, YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR400, YAMAHA FZS600FAZER, YAMAHA ROYALSTAR1300, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1700R100 ROADSTER, YAMAHA XV1900AXV1900
Harness extension is required.
I installed it on the TRX850, but the Harness length was insufficient. But if you put it in the opposite direction of normal installation, it can be reached somehow. I drove about 700km after installation, but there is no problem at present. If there is something, I will add a note.
Honestly, I wish I had bought the OEM Product as normal.
View detail
Fits: YAMAHA YZF-R6, YAMAHA FZ400, YAMAHA TRX850, YAMAHA SR400, YAMAHA SR500, YAMAHA VENTURE(XVZ1300), YAMAHA VENTURE(XVZ1300), YAMAHA VENTURE(XVZ1300), YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR1100Classic, YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR1100, YAMAHA DRAGSTAR400, YAMAHA FZS600FAZER, YAMAHA ROYALSTAR1300, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1600 R100 ROADSTER, YAMAHA XV1700R100 ROADSTER, YAMAHA XV1900AXV1900
I'm done after 400km.
I thought it was time to replace it with a new one because of the OEM's ageing and it was 19,000 yen when I checked the OEM.
I checked and the H.Craft products were almost half price, so I bought them.
Even though it was touring in the heat of August, there was nothing special about it, nothing wrong with it.
The lamps are off or the MainFuse is turned off suddenly while driving.
Replacing it with a spare Fuse will cut it off, check Wiring but can't find it on the spot, first Wrecker move
When I came home, I took off the Regulator and found it was Crack and Puncture on the back.
Puncture in just one touring session, and then the OEM was immediately reapplied.
After all, cheap is dangerous, especially for other brand products related to electricity
It was the same as throwing away $8,000.
View detail
I think it's a real MOSFET
I'm using a single-phase AC-powered motorcycle and I'm getting 14.6V at Idling
It was virtually unchanged when running and the body was only slightly warm However, it is single phase so it was missing one Dummy cap There are no instructions
View detail
Fits: YAMAHA FZR400, YAMAHA ZEAL, YAMAHA TZR250, YAMAHA R1-Z, YAMAHA FZR250, YAMAHA TT225, YAMAHA TT225, YAMAHA TW200, YAMAHA TT-R250, YAMAHA TDM850, YAMAHA SRX600, YAMAHA FZR400, YAMAHA SRX400, YAMAHA TDR250, YAMAHA 350R, YAMAHA DRAGSTAR250, YAMAHA XTZ750 SUPERTENERE, YAMAHA SEROW225, YAMAHA XJ600, YAMAHA VIRAGO250(XV250)
I think it's good
I used it on an old 2ndYamaha car
The original parts can be carried as a spare so you can rest assured that you will not have to worry about them breaking down on the road
I think it's a good idea to replace it in conjunction with Battery replacement
But Screw should be 30mm
Also, since it's an electrical part, it's best not to use stainless steel screws
View detail