Reviews
Bracket is a bit short. Crying
I had to replace it due to a fender bender. (Reflector is Repeat)
DAYTONALicense Plate Holder99662 and Quantity as per the accident estimate made by Motorcycle shop.:I was compensated by Set and did the installation work myself.
Quantity in DAYTONALicense Plate Holder99662:The top of the Reflector square will interfere slightly with the top of the Reflector square when it is set, so you will need to modify it in some way. (The height of the outer frame of the License Plate Holder is less than 2mm higher. Is it compatible with the new standard?)
Reflector is blameless. (Lol)
View detail
It's better than nothing
I've been struggling with sand and rain bouncing up and down since I got the Fender Eliminator
I found this product and bought it to try it on
Active's Fender, not KIJIMA's Fender Eliminator It's a Eliminator, so can I install it? But I managed to get it on
Because it was a retrofit Reflector, it is wobbly because of the Frame strength
In addition, you can install the License Plate Holder and use the Double-sided I used tape to secure it in place
Is the bounce-up a little less than it was before you installed it? That's about it
I think it's a bit expensive in terms of Cost
View detail
Lighting failure due to solder peeling
Because the Tail lamp became hard to see with Carrier equipment, with this LED Reflector
Added auxiliary Stop-lamp.
However, it ceased to light with several rides from the installation.
Occasionally it is not a problem of Wiring, it seems to be poor contact due to peeling of LED solder.
It is troubled because the possibility that the off-the-shelf LED will not be lit by solder peeling is quite high.
If you do Rose and solder it again, you can not fix it, but it is troublesome to be honest.
I would like you to solder more firmly.
There are unavoidable parts because the price is price, but if there is durability in this
It was a satisfactory product .... I'm sorry.
View detail
The square passive reflector type was attached to FZ1 by the reflector kit. The square passive reflector has looked very uncool to a liter machine. Off-road one etc. may suit this. however, also being firmly attached rather than the slender ty
The square passive reflector type was attached to FZ1 by the reflector kit.
The square passive reflector has looked very uncool to a liter machine.
Off-road one etc. may suit this.
however, also being firmly attached rather than the slender type -- intelligible -- appearance -- or it may be divided into judgment of practicality.
But I am peevish without buying this type next...
View detail
Since only this was put on the store, it used. Although it is completely satisfactory and very much satisfied about attachment and the engine performance, a rectangle style is not pleasing somehow. For a while, I had the reflector portion made sma
Since only this was put on the store, it used.
Although it is completely satisfactory and very much satisfied about attachment and the engine performance, a rectangle style is not pleasing somehow.
For a while, I had the reflector portion made small and it has already extorted it.
When collected, I wanted you to make a little smaller a good point, and the bad point and reflector which are not found.
View detail