Reviews
Not recommended for people who want to drive a new car to Large things.
I had attached the front with 6 pieces of strong double-sided tape.
The headwind on the windy highway took it all away.
In this case, the Parts interfere with the Front Fender.
It caused damage to both the Side cowl and the original interfering Side cowl.
It may look better temporarily, but is not recommended for those who do not want to regret it afterwards.
I have removed this Parts.
View detail
Puch SIDEDownForceSpoiler
In conclusion, it is absolutely impossible to install it properly.
If the pattern paper is Quantity:I also had trouble with only 1pc.
And the pattern paper is not Exactly to match the top?
The location will change by about 5 cm depending on whether you want to adjust it to the bottom or the front or the back
The procedure is different if you refer to the Webike Product Page video for installation
In the video, Plate is applied first, and after 24 hours, Rubber rubber is placed over it.
Product was sent already installed!
This is because the Plate is located behind the Rubber Rubber.
Rubber rubber like Toilet's SUPPON will rebound like Spring and interfere with installation.
I looked it up on the Net and found that those with strong final strength have weak initial strength.
We are a GarageHouse, so our cars and motorcycles are both heated and cooled in the house!
Compress and paste for 1 minute at room temperature above 28 degrees Celsius or
I tried and tried, but it was impossible.
Emon sold separately (amon) Ultra Strong Double-Sided Tape (for Bumper, Spoiler, etc.)
Buy Strong Fixing Type White 25mm×width 2m×length 1.14mm×thickness 1.14mm 3910 for outside of car and
I machined and installed it.
The product is quite straight and is to be mounted on a curved cowl.
It's not so much that it's attached as it is that it's forced to be attached with Strong Double-sided Tape!
The shape does not fit the side cowl of the ZX-10RR at all.
I'm inclined to say that it's a 2021ZX-10R/ZX-10RR exclusive part.
ZX-10RR looks straight but Cowl is quite curved
It doesn't fit at all, especially the Right Side is almost floating.
If this is what you're talking about installing, I'm pretty sure it applies to all other Manufacturer's Motorcycle's.
Whether it is YZF-R1M or CBR1000RR-R, it is possible to paste it!
At the moment, I've driven about 50km to try it out and it hasn't been removed.
It looks cool, so that's good.
View detail
Shape is different.
The shape differs between the photo and the actual product.
It looks quite like bucktooth.
View detail
I guessed it, but … it doesn't fit the shape or anything. If you want to put it on, you have to DIY.
The shape does not fit in the first place, as it is made in Indonesia.
Quantity:Pair (for Left and Right) I think you should be prepared for asymmetry.
The price of 10,000 yen is a bit steep for the
I had an idea of what to do, but I knew I had to DIY if I wanted to install it.
Moreover, the carbon surface was cracked.
(I doubt it's even Carbon to begin with.)
I've repaired and reworked all the installation surfaces in File, but I'd like to write this down so that people don't buy it without knowing.
Well, if you're thinking of pimping it out, you shouldn't.
View detail
Webike really sucks.
You can only receive one of them and ignore them when you contact Support
I'm never going to use this fucking website again.
I've only got half of the Gold amount I paid for.
I've used a lot of shopping websites, but I've never been treated like this, and I've never been treated like this person.
View detail