Reviews
poorly made
Installation is easy enough for anyone to install without any problems.
However, the air intake netting is just popped on with Bond and comes off with just a touch of the finger.
Even though it is made in Japan!
I was disappointed.
As shown in the image, the Bond installation of the netting can be taken off loosely.
View detail
Maintenance around the rear suspension is easy.
When modifying the rear suspension area, removing and installing the OEM air cleaner duct (?) is quite a hassle. When modifying the rear suspension area, it is quite troublesome to remove and install the OEM air cleaner duct (?).
[How is it used?
daily use
Was the one you received as per Image?
Slightly cheesier (PeLePera + a little less molded)
How was your experience with it?
no problem
[Points to note]
nothing special
How did it compare to other products?
The ones from other manufacturers are quite expensive, but this one is reasonably priced!
Point and hang of installation
Hexagonal Wrench and +Driver are required for OEMDuct removal.
The process takes about 15 minutes, of which about 14 minutes is for OEMDuct removal (it's pretty tricky).
Installation is only by tightening 3 ScrewScrews.
It looks neat and makes it easier to replace the Rear suspension and install the Side bagBracket.
View detail
high level of cost performance
I was concerned about small dust particles because it was an inexpensive product, but once it was installed, there was no problem. I think the cost performance is good because it is definitely cheaper than other companies' products.
It was easy to work with and required no processing. I am generally satisfied.
View detail
It looks better.
When I changed carriers, I was using the AirFilter Duct in the opposite direction, but it didn't look good, so I bought this product.
I thought it was a bit expensive, but there were no alternatives and this was the only choice.
The adhesion of the net part came off when the screw was tightened, but it was repaired with adhesive and used again.
View detail
Installed after Carrier replacement
I purchased this product for post-processing of air filters as they were replaced from OEM Carrier.
It is very simple to make and costs almost 4,000 yen? But it may be inevitable because the quantity is not available.
It is fastened with three screws, but when fastening, there was a snapping sound and the mesh part came off.
Since they are only attached with glue, the initial glue seems to dry and peel off easily.
Now that it looks cleaner, I'll use it for a while anyway.
View detail
It was installed without any problems.
Originally, this product was designed to be used without the OEMRear Carrier, but I was considering purchasing it to remove the OEMAir Filter Cover because the OEMAir Filter Cover was in the way when I loaded luggage in the front with the OEMRear Carrier, and it was difficult to attach the luggage strap for fixing the luggage. I was considering purchasing this product to remove the OEMAir Filter Cover.
There are other similar products, but they are more than twice the price of this product, and there are also some impressions that the position of the mounting screw does not fit, so I hesitated to purchase this product. We purchased this product because of its reasonable price and Webig's product conformity guarantee.
The installation was done without any problems, with no misalignment of the screw hole positions.
The mesh for air intake is bonded under the right side of the product, but it is a little bit messy, and when I lightly touched the mesh with my hand, part of it peeled off.
When the filter is installed, there is a gap between the motorcycle body and the upper back side. Rainwater and insects may come in, but water will escape through the mesh and insects will be blocked by the filter.
Compared to other existing products, it seems to be better, including the price.
View detail