Reviews
Fits: BMW R1250RT, BMW R1250RT, BMW R1200RT LC water-cooled
I'm generally satisfied
I bought it because I was worried that there was little ground contact of the Side Stand I chose a product that is less thick than I expected As a result, when I put in and out of the Side Stand at the time of getting into and out of the car, it became easy for my toes to catch However, you should be careful about the looseness of the mounting screws Regardless, one of the screws was loose in one of the three places after about 300 km of installation View detail
Fits: BMW K1600GT, BMW K1600GT, BMW K1600GTL, BMW K1600GTL, BMW K1600GT, BMW K1600GTL
It will not collapse.
As my motorcycle was very heavy at midsummer hot days Asphalt was depressed with a good chance when using Side Stand. After attaching this Side Stand End, it does not collapse at all. However, because the getter is somewhat high, attention is required when the road is a road with a lowered Right and a road with a high Left. There is a danger that Motorcycle will collapse to Right Side. View detail
It is too thick!
Maybe it depends on the type of car, but the geta was too expensive for our vehicles.
It is indeed the primary objective of this Items "It is not buried in Left Side" Has been achieved, but if you mount and stand on Asphalt or Concrete, the Motorcycle stays upright as it falls to Right even if the wind blows.
I was disgusted by searching for earth and grass on the road and stopping it..
View detail
Fits: BMW R1250RT, BMW R1250RT, BMW R1200RT LC water-cooled
I felt a sense of stability when I stopped..
Installation Instruction Manual also instructed us to use "Screw lock", but since we did not have any hands, we installed it for the time being. When I noticed the installation Screw was dropped by 1 pc.
I bought Screw lock agent and Stainless Steel dish, Screw at Homsen and reinstalled it. Engine is easy to loosen because there is vibration in BoxerTWIN.
Out on the upper side of the photo is the self-made extended Bracket. The position of STAND is in front of Cylinder, so I tried to attach it because it is hard to get on with my feet.
Since the area became wider, it is stable, but I wonder if I need to pay attention to the pull and pull on the road surface.
View detail