Reviews
Can also be installed on SUPER CUB110 JA59
Installed on SUPER CUB110 JA59.
The work itself can be easily installed with no problem at all, but it is too long for the SUPER CUB and the body will stand up a little.
View detail
Delivery date undecided, huh?
I ordered in August 2023 and was told that delivery was scheduled for mid-February 2024, but I canceled the order at the end of February because it showed "delivery date undecided". It arrived the next day after I placed the order on Amazon.com. View detail
I wonder if the Spec. has been changed.
I was interested in this product, but I saw many impressions that it had a " mysterious protrusion " and could not be stored completely, so I hesitated to purchase it. It is true that the protrusion has been removed and it can be stored properly. (The vehicle in which it was installed is a 23-year MODEL JA60) However, I think it can be attached to the previous MODEL as well. View detail
Installed on JA10CROSS CUB
I was told that it was not compatible with JA10CROSS CUB, but I was able to install it successfully.
We have slightly modified the STAND, but there are no problems.
View detail
DRC DRC Side Stand installed.
When using the Side Stand on the CROSSCUB110, the vehicle is tilted too much, so there is some anxiety when parking.
The width was necessary, but by replacing it with the DRC DRC Side Stand, the degree of improvement is satisfactory for the tilt.
However, was the spec. changed to the photo in the product introduction? Is it the Rose tree of the manufacturing process? The ground contact area is welded to the large front side, so it sometimes hits the foot (shoe) when starting off (it did not happen in NORMAL). Also, it rubs the road surface when corner ring is used.
If the ground plane is to be widened, it is safer to protrude behind it, out of the way.
(I would like to see the photos always Up-dated, as the only confirmation of the items will be the photos in the product introduction).
View detail
Required replacement when using ZETA Off-roadSuspension kit
Required Tools
17Spanner and Glasses
・Tension Spring Tools
(I substituted a longer slotted screwdriver *Self-responsibility)
good point
Stable parking.
The film is thick and seems to be resistant to stepping stones.
A bad point
...It was scratchy from the start… (Individual differences?)
Must be used with ZETA Off-roadSuspension kit.
It can be parked in OEMSTAND, but I am afraid of too much tilt and load.
I think the product itself is good, but I was surprised that the one I purchased was covered with scratches from the beginning.
I didn't return etc. because it was going to get scratched up soon anyway.
View detail
It doesn't fall down even if it is full of luggage.
When I went camping touring with my ja45 CROSS CUB, the OEMSide Stand would sometimes fall over on the left edge of the road or on a sloped surface when it was full of luggage, but after replacing it with this product, it no longer falls over.
In addition, the part that touches the ground is wide, and even if the ground is soft, it doesn't sink in and is good.
On the opposite slope, the inclination is too small and it may fall on the right side…
I'll use it for a while and see how it goes overall.
View detail
It arrived quickly.
I was concerned about the tilt of the Motorcycle, but it was resolved. View detail
Purchase with Off-roadSuspension kit
I'm not sure if this is a good idea or not. View detail
Don't lean too much when you stop
Just replace it with the OEM and it takes less than 10 minutes When we put a lot of luggage on it, it looked like it was going to tip over when we stopped, so the Center Stand I was only using it, but I think I can use the Side Stand easily now Some people seem to hit the Center Stand when they pay the Stand, but I hit the It wasn't View detail