Reviews
Greater scope for adjustment
Replaced the mirror at the same time, which was a bit tricky since I had to position the Offset and Mirror at the same time, and since the Brake Side was going to interfere with the Cable, I used the OEM Spacer. I used the OEM spacer because the Brake Side was going to interfere with the Cable. View detail
To prevent interference
No interference with Mirror replacement at height. View detail
Offset
Good to move Mirror forward. View detail
For Radial pump master installation
I used this product when I changed my MT-09 to YZF-R1 Radial pump master cylinder. There are only a few Mirror Brackets that are compatible with Opposite Thread Screws, so I am glad that this product is available.
It would have been better if Bolt was in Black.
View detail
Mounted on Right SideMirror
The entire Mirror seems to stick out a little more than in Normal, but this is good because it makes it easier to see the lane behind you and the passing lane. View detail
Mounted on LeftMirror
It is attached to LeftMirror.
I couldn't see the back of the Large half of the Mirror because it was hidden by my arm.
Now it is in full view.
The entire Mirror will be more protruding than in NORMAL.
If you drive without VANVAN of slip-throughs, you're good to go.
View detail
completely visible behind one's back
Installed on LeftMirror.
Although there is a slight sense of protrusion from the vehicle body, it allows me to see the rear of the vehicle, which was difficult to see with my own body, and it makes it easier to see how close the following vehicle is in town and to check on my companions when touring.
View detail
If you don't care about Logo and so on.
When I changed the Clutch master to brembo Radipon, I used this instead of the Mirror Bracket.
If you don't care about Brand logo etc., it is functional enough.
View detail
Used to install YZMASTER on a SEROW250
It is used to install YZMASTER to SEROW250
It is not so unnatural to combine it with the silver-colored YZMASTER
The Handlebar has been replaced with ZETA's MX-123 and it works fine
The bolts are also solid with Stainless Steel
View detail