Reviews
Buy 25mm at Repair
[How is it used?
I'm using a ZETA Pilot Handlebar (45mm) on my Racer YZF-R25.
I bought it from Repair because when I fell, the Handlebar as well as the Handlebar Bracket was bent.
Was the one you received as per Image?
As you can see in the image, the 45mm was too big and bent, so I chose the 25mm.
Was the installation difficult?
It's so easy, it only takes three bolts to stop it!
How was your experience with it?
The Fee Ring is the same as before. Also, since it's now 25mm, there's no more bounce.
As a result, I'm happy with the 25mm.
[Included Parts:were they on?
Included Parts:There are none!
[Was there anything that disappointed you?
There is a little bit of BALI, which is a bit of a bummer, but it's not domestic, so it can't be helped.
View detail
I'm buying for Repair!
[How is it used?
It is used for YZF-R25 of the race vehicle, and Separate HandlebarsBody is also for Repair with Pilot Handlebar of ZETA.
Was the one you received as per Image?
It was just like the Image, of course. It's the same bar that came with the first one!
Was the installation difficult?
Nothing difficult to do, BoltQuantity:Loosen 2pc, replace and you're done.
How was your experience with it?
I bought it from Repair because I fell over and it was bent into a heap.
Even if you don't use ZETA, you can get the bar from many manufacturers.
I chose this Repair product because I wanted to use the same one after all.
[Included Parts:were they on?
There's nothing here! Just a bar.
[Was there anything that disappointed you?
There is none at all! Only the Throttle side is treated smooth and is GOOD.
I also bought the DAYTONA bars, but Quantity:Pair (for Left and Right) I think it should be smooth on all sides and the Clutch Side should be rough like ZETA.
View detail
If you process it, you can pimp it.
Installed in combination with Cut-outSeparate HandlebarsSystem50φ.
You can change the Sauce angle to your liking.
Since it has an approximate Memory, the Quantity:Pair (for Left and Right) Easy to match the Sauce angle of
If you leave it as it is, there is too much length, so you need to Cut it to the appropriate length.
In the photo, I set the Sauce angle to the largest.
As it is, it will interfere with Cowl, so we'll take our time and see how it goes.
View detail
Cospa is good
In Universal's Separate handle that I have, I did not have a Bar End, so I bought it.
It is beautiful Anodized Finishing.
Size is 22. It was 2 mm so I was able to attach it to Clamp which I had.
Just removing Cap removes the hand slightly or only a single cut is slightly distorted.
I caught Bar End, but I am a little concerned about distortion.
Since there is no way to take off unless you apply a strong force, those who do not mind are good.
View detail
The low price and high quality of DAYTONA products are becoming to generate a feeling of reliance these days. And so I had no doubts about choosing this part.Now about this angle bar.It is light and durable. The anodized coloring is beauti
The low price and high quality of DAYTONA products are becoming to generate a feeling of reliance these days. And so I had no doubts about choosing this part.
Now about this angle bar.
It is light and durable.
The anodized coloring is beautiful.
The angle can be adjusted finely.
You should adjust the angle to where your wrist settles all right!
Still, I will rate it with 4 stars, for I had been expecting more!
View detail