- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Handles & Control Parts
- Other Handle Options / Repair Parts
Reviews
This is a good one!
I bought it because the one I had on two years ago was getting ragged.
I used to put it on with a Gas burner to burn it at a distance, but I still prefer Heat gun.
Dryer would have to be very powerful to make it work.
I use it to prevent deterioration of the Grip heater from UV rays and to reduce vibration of the Handlebar.
When I ride my Motorcycle in the middle of winter, I use light gloves because I am a Grich + Cover.
Even in that case, many are more than warm enough to both protect and warm the grich!
View detail
To prevent Grip wear and tear.
I've used it on other vehicles, but installed it in case of Grip wear and tear.
I couldn't find a heat gun so I shrunk it with pod warm water.
View detail
Protect Grip
Grips are consumables. They wear out unexpectedly. You can replace the grips when they wear out, but the cost of a grip heater, an OEM product of a European car, is high. Therefore, Heat Shrink Tubes are used to protect them from wear.
For fishing rods. However, I am using this product, which is a Motorcycle product, because I am concerned about the appearance of the product.
To install, simply heat it up with a commercially available heat gun. The overall length is 105mm and fits snugly without cutting.
It may depend on the Gloves, but with the Gloves I use, I don't notice any slippage.
The grips are thicker, so people with small hands may feel some discomfort.
View detail
It's a very ordinary Heat Shrink Tube.
Used to fix a wrap-around Grip heater.
I used to use a common Heat Shrink TubeTube that is also sold at Home center, but I was a little concerned because it was slippery or compatible with Glove.
It's in the product description.
The surface is designed to be non-slip and secure.
I bought this book because I was attracted by a sentence that says
In conclusion, it is the same with Large. Rough operation, if you are not careful, it will slip.
If you don't care about the manufacturer or the pattern, Recommendation is not for you.
I bought a cheap heat gun from Amazon for installation. (It's not that hot) I worked with it, but this product was easier to shrink and I had the impression that it was less loose when I heated it up again using the Grip heater.
Overall, I don't recommend it, but I think it can differentiate itself from other users who use Heat Shrink Tube. The price is a little bit high.
View detail