Reviews
JC75 in ideal handle position
Handle position too high ideally.
I am satisfied that this is one of the lowest Handlebars available for the JC75.
I don't mind but I think the paint job is weak.
The damaged area was Rust.
Exclusive design allows for easy installation.
Locking holes are also available.
Is it because I adjusted it to be as low and far away as possible?
Handlebar Stopper was not necessary.
It does not interfere anywhere.
View detail
The handlebar paint was easily peeled off, which was unfortunate.
I was very disappointed that the Black paint peeled right off.
I could not believe it was a MORIWAKI product.
The peeled areas were repaired with BlackMagic.
Handlebar height became lower and very enjoyable.
View detail
Re-posting for some reason, a little bit sad MORIWAKIHandlebar
[How is it used?
City & Circuit, the Position is quite good.
Was the one you received as per Image?
As per Image.
Was the installation difficult?
Installation itself is easy. However, the paint will peel off, so be careful when installing.
How was your experience with it?
The position and texture are perfect.
[Included Parts:were they on?
No problem at all.
[Was there anything that disappointed you?
The paint is a little easy to peel off, though it would be better if it is installed with care.
Point and hang of installation
The Plus screw on the OEMBar End is hard. I used an Impact wrench to remove it.
Please be careful not to lick it.
As you can imagine, the LeftRight Switch Box hits both SIDE of the tank exactly when the handlebar is tightened.
Measures will be taken in the future.
View detail
MORIWAKIHandlebar, which was a little bit expensive
[How is it used?
Street & Circuit
Was the one you received as per Image?
Street Image
Was the installation difficult?
It's not difficult, but it's tedious, none the less....
How was your experience with it?
It is considerably better than the STD Handlebar.
Even with such a change in position, I don't get tired, especially in town.
[Included Parts:were they on?
All of them.
[Was there anything that disappointed you?
The paint peels off surprisingly easily. It should be installed with more care.
Point and hang of installation
As you can imagine, the Plus screw at the Normal bar end could not be turned by hand; it was removed with Impact.
[Notes]
This was also as you might imagine, but Switch boxQuantity:Pair (for Left and Right) Both are stiff hits.
Since we also drive on the street, we will consider countermeasures in the future.
View detail
It's pretty good.
The OEM Handlebar position is easy and good for city driving, but when it comes to Winding and Circuit, the Handlebar is too expensive.
Compared to the OEM, the handlebar position is almost 5 cm lower, but when you actually ride it, you can feel that it has been lowered by more than 5 cm, and the Race ish feeling has been greatly increased.
However, it is not as if riding on the street has become tougher, and it can be ridden normally. However, if you are taller, you may feel the handlebar position is too low, so your opinion may change depending on your physique.
View detail
Easy to get down
The Riding Position makes it easier to get down and I like it a lot
The brake hose will interfere with the meter case during installation
You might want to think about handling it a little bit
View detail