Reviews
It is hard to get through Bar End.
It is used to temporarily lengthen a handlebar that has been shortened in overall width, and when combined with the EBB301K Bar End, it returns to the Japanese Vehicle Inspection Correspondence. I was able to get it through by using a heat gun, lubricant, and a rubber hammer. I am afraid I could not pull it out, so I will keep the Bar End and this product in quantity.:It will be used in Set. It's good because it's only for car inspections…. View detail
For vehicle inspection
A few months after replacing the STD Handlebar with a standard BEET Handlebar because it was too wide, I went to the store for an inspection and was told to install this one because it was not wide enough. After that, it was a hassle to take it off, so I just kept using it. I don't mind it and I can grip it without any problems. View detail
Caution.
Used for HURRICANE Conti2 type. The inside diameter does not fit, so the convex part does not fit. Please be careful when installing on non-BEET handlebars. View detail
For vehicle inspections and checkups
Frankly, I don't think many people use it on a regular basis.
It is definitely a convenient alternative that can be easily installed and removed.
I think it can be used outside of BEET.
Used in Musashi Kai.
View detail
Not bad, I guess.
Purchased for Japanese Vehicle Inspection Correspondence when installing BEETHandlebar.
Once installed, it will be about the same length as OEM.
It is easy to install and easy to remove.
View detail