Reviews
It's going to look good.
Transparent Tube.
I wanted to extend the hose of the Reserver and decided to make it transparent anyway! I bought it with the idea of making it transparent.
It uses Project mu's Green Fluid, which looks Skeleton-like.
It is also useful for air venting because it allows the user to see air bubbles that have accumulated in the hose during air venting.
View detail
Babyface Reservoir Tank Hose
When replacing the brake master cylinder, replace the black of the Reservoir Tank Hose. [Color] I bought it to change to Clear. I am happy with the look and feel of the KRear hose. View detail
I'll just swap it out.
only after ... is it ... [Color] I bought Clear.
Not sure yet if I'm going to sweat it out, so we'll see.
View detail
Hose while replacing Master Cylinder. [Color] Clearly.
Hose while replacing Brake with RadialType. [Color] Cleared.
I bought it because I heard it was hard to sweat.
To bend it, you need to soak it in hot water, but once it is bent, it is fixed, so that is convenient.
[Color] Clear, so it's easy to check the air bleed.
View detail
Note the curvature
Since it is so much effort, I used it with Green Light color Fluid, which is more White than pure transparent. [Color] It's like Smoke.
You should not use a vehicle with a tight handling due to poor flexibility, or you should buy a longer Size and make it go around Large.
The inside is a little dented due to the way the picture was taken, just installed, so durability is unknown.
There was another part number for Rear, so I bought it, but both front and rear were this size.
View detail
Skeleton
ReserveHose was sweating, so I decided to replace it with a Skeleton one if I was going to replace it.
It's nice
View detail
Emphasis on appearance.
As mentioned in other reviews, if you insert a thin hose and dip it in hot water, it will turn a little better. View detail
Used as an alternative to the Non-master cup kit
I used to use KITACO's Non-master cup kit, but the surface became slippery with perspiration and I physiologically disliked it, so I diverted this one, which does not sweat as much. (The cap is reused from KITACO.) So far, I don't sweat at all. So far I have not sweated. However, the price is a little bit expensive for 30cm/3000yen. View detail
the most unlikely
Just a transparent Hose.
It's totally just for looks lol.
When dipped in hot water, it bends straightforwardly and retains its shape memory.
Ka Eraserd and is Outclassing!
View detail
It takes some ingenuity to bend it.
I bought 30cm and used it for H2SX's FBrake and Clutch, GSX-R1000 K7's FBrake, but there is a little too much.
If you put it in hot water around 60 degrees and bend it, it will memorize the shape when it cools down, but if you do it normally, the hose will be crushed.
I'm worried about durability, how many years it will last.
http://onaka-ippai.cocolog-nifty.com/blog/2021/11/post-efd372.html#more
View detail
I think I could have used a regular BlackHose…
I bought this product to try it out to see if it was available.
I think it looks better with Active's with Color and Fluid (I use Yamaha OEM).
There is a description in the instruction manual that it is possible to use it without changing that much with normal Hose, and conversely, there is thickness and hardness as much as normal BlackHose, but it is possible to bend it while heating it with hot water of 60°C.
However, I thought that BlackHose would be safe when I thought about whether it would come with YellowHose.
I'll continue to look at it and add to it if I hear anything.
View detail