Reviews
Fits: YAMAHA VMAX 1200, YAMAHA FJR1300, YAMAHA DRAGSTAR1100
V-max 1200 rear brake disk
I was very satisfied with the delivery sooner than expected. Product quality is also very good. Compatible with Brembo calipers. View detail
Fits: KAWASAKI KLX125, KAWASAKI D-TRACKER125
Exchange from OEM
[How is it used?
Used on D Tracker 125 (vehicle equipped with KLXOEMWheel).
I chose this product because it was the only option other than OEM.
How was your experience with it?
The quality is satisfactory, with no impression of inaccuracy.
How did it compare to other products?
It was a replacement from an OEMRotor that was reduced to the limit, so I can't compare, but it is working well.
The image is a comparison with OEMRotor.
Seems to have better heat dissipation compared to OEM? Weight was about the same.
[Points to note.
Install the Rotor so that the letters on the surface of the Rotor face outward.
View detail
Fits: YAMAHA V-MAX, YAMAHA FJR1300, YAMAHA XVS1100 DRAGSTAR
Exchange with Design priority
I don't know about performance, but I replaced it with a design priority. View detail
Fits: KAWASAKI KLX125, KAWASAKI D-TRACKER125
There was only this
[How is it used?
Attach to D Tracker 125.
I haven't put it on yet, but the design looks good.
I think it is a Material similar to OEMRotor because it feels heavy in the hand.
At least it is not Duralumin.
There is no indication that BALI is left behind or anything.
View detail
Fits: KTM 125DUKE , KTM 200DUKE , KTM 390DUKE , KTM RC125, KTM RC200, KTM RC390
I like it quite well.
It is lighter than the OEM and the design is also good.
Although Rotor and Pad's hit does not come yet, it still stops very well.
View detail
Fits: KAWASAKI D-TRACKER, KAWASAKI KDX220SR, KAWASAKI KLX250, KAWASAKI KLX250ES, KAWASAKI KLX250SR 93-97, SUZUKI 250SB
The former Owner had equipped and the Floating part was worn out, and since it was rickety, it re-purchased. What is necessary is just to exchange Floating pins, before wear becomes severe, and if it must be good, he is trying for durability to have
The former Owner had equipped and the Floating part was worn out, and since it was rickety, it re-purchased.
What is necessary is just to exchange Floating pins, before
wear becomes severe, and if it must be good, he is trying for durability to have uneasiness, if
honesty and a former state are seen, but to be convinced to effectiveness, since it is a diameter DISC of
large.
Since it becomes difficult to remove the
Caliper, maintainability worsens.
View detail