Reviews
Fits: SUZUKI ADDRESSV125, SUZUKI ADDRESSV125LIMITED, SUZUKI ADDRESSV125G, SUZUKI ADDRESSV125, SUZUKI ADDRESSV125G, SUZUKI ADDRESSV125G, SUZUKI ADDRESSV125
It needed to be processed.
I bought this for a K5 Address for Replacement.
The diameter of the bolt for the brake lever is too small, so I had to use a drill to make the hole bigger.
In addition, when I blew out the air of the brake, the return side of the Master Cylinder was not equipped with a process to prevent the brake fluid from blowing out, so the brake fluid scattered a little.
The feeling of use after installation is that Brake is working normally without any particular problem.
View detail
It could not be used as it was and required processing.
It's a tough grade, but there's a reason.
one. When I tried the delivered product, I found that the joint of Rubber was easily pulled out.
It was useless.
two. If we process it, we can make it usable somehow.
As mentioned above, it is not the large processing, but the degreasing of the joint of the rubber.
I glued it in place, and since my motorcycle has a grip heater, it's a little thicker.
It was a little tight to cover the Grip, so I heated it with a heat gun to widen the diameter.
It can now be used with such processing.
Originally, I thought that if there was a defect like 1., there would be a problem in Large to distribute it as a product.
I had to return it or throw it away as Garbage.................................
I'll give it a 0 for now.
However, the safety and serviceability of the product is unknown because it is processed at our own risk.
I consider it a necessity for Scooters that are not equipped with parking brake.
View detail
Fits: SUZUKI Address V100, SUZUKI SEPIA, SUZUKI SEPIA, SUZUKI ZZ, SUZUKI LETS II (2Cycle), SUZUKI VECSTAR125, SUZUKI VECSTAR150
More accurate product information!
I bought it because it was billed as being compatible with all ADDRESS V100s, but it was basically & let's consider rdquo; you can't pontificate”
Actual Handlebar diameter 19.5mm ProductHandlebar installation part inner diameter about 18mm So, if you tighten the bracket with the bolts, the bracket will be damaged
As a countermeasure, use the OEM Bracket that comes with the actual car and the Washer (which is also (Processing required)
The inner diameter was made closer to 19.5mm by installing a bite of the bite
Also, I tried to install the OEM Brake lever, but the thickness of the lever did not fit It does not enter the MASTER side
I think that there is an individual difference, but it shaves 1-2mm off the Brake lever and MASTER side with File We were able to assemble it by
I felt that the piston part of the Master Cylinder was pushed a little, but it did not drag Lever feels a little distant, but there is no problem in operation
The distance between the Mirror mounting thread and the Master Cap is less than the OEM Product I installed the Mirror through the Adapter because of the proximity to the Adapter I couldn't re-install the Mirror without removing some of the parts with a sander
As for my impressions, if you are not good at processing”MASTER& with Brake lever it is safer to buy the rdquo;
When the Brakes air is blown out, as others have written, the Brake liquid comes out with a good force So take your time to release the air
View detail