Reviews
Recommended
I installed it on a Chinese 90Engine. The installation position is a little bit gap and it interferes with the Brake Arm, so it is necessary to cut it. The exhaust sound is a bit loud, but the sound quality is excellent. The product is beautifully made and I highly recommend it. I think it is a product that makes riding fun. View detail
HOT RAPPTrailExhaust System
The volume of the Image was exactly what we were aiming for.
The sense of power when turning is not quite right.
Product texture is very good.
I wanted to try to remove the Heat Guard on the back side, so I started to loosen the SaraScrew, but the Quantity:I gave up because the head of the Hexagonal Wrench broke off and remained inside.
I am satisfied with the product.
Thank you very much
View detail
Gentle sound and easy to ride with good balance of the extraction.
[How is it used?
I use it about 80% for commuting (city driving) and 20% for touring.
It is a quiet residential area, and the popping sound of the so-called "single cylinder" reverberates and is a situation to be careful about,
This Exhaust System is one that is very easy to use because the tone and volume is comparable to OEM.
Was the one you received as per Image?
As per Image
I thought the weld marks were clean and the buffing on the Pipe surface was very careful.
I thought that if the WireHeat Guard were wider, it would reduce the possibility of passengers touching the SilencerBody.
Was the installation difficult?
I think Torque management/fine tuning of the orientation is essential, though, since the only fixation with the vehicle side is at the suspension mount,
There are few interference points, and I think it is one of the very easy ones.
How was your experience with it?
It has a Gentle sound as rumored and is easy to use regardless of the SCENE.
The low-frequency range is also moderate, so the Torque is very small, even though it feels thin.
The high frequency range is much better than the OEM, and from the reduced vibration when turned to the Top End,
It will be a good way to get a good turnout.
[Included Parts:were they on?
All necessary items are included except for Gasket.
[Was there anything that disappointed you?
Above, it would be better if the WireHeat Guard were wider.
View detail
It is a good Exhaust System
I replaced YOSHIMURA with Large because I felt the Axel was too heavy and it was hard to turn to the top, but this one turns up smoothly. The sound of YOSHIMURA was too loud, so I replaced it with this one, but the sound is gentle, not noisy at all, and the sound is just right. I think it is the simplest and most beautiful exhaust system for CT 110 HUNTER CUB in the world today (except for the wire guard). The only thing is that the Tie Band at the joint ruins the design. (I have removed it).
Total is Large satisfied with this Exhaust System. We recommend it to those who are looking for an exhaust system that is not noisy.
View detail
Crisp Sound
Installation is not so difficult if you read the Installation Instruction Manual.
Side cover and Exhaust System are installed while watching the clearance. [Color] ClearRAN was quite Tight and no more than 10mm.
The Exhaust Bracket is co-tightened with the mounting bolt of the Rear Carrier, and a 14mm deep socket is required (I had to buy one in a hurry).
The OEM silencer heat guard was then installed, degreased and cleaned, and the engine was started and checked to make sure there were no exhaust leaks.
Sound is more solid and crisp than OEM.
The first gear is Torque, so I don't think there is anything wrong with the start of the car.
The Clearance of the Side cover is Tight but did not melt or deform.
What's wrong with Exhaust System Up Type,
1. difficult to change oil (just difficult, but it can be done)
2.U-shaped exhaust pipe area gets dirty due to mud splashing.
(3) Difficult to start the engine by using the kick pedal (note that the hem can easily get caught on the heat guard).
4. it is no longer possible to ride with two passengers (if you ride sideways like in other countries... I think it's a violation of safe driving duty).
Exhaust Gasket is not included and must be purchased separately.
View detail
The polished finish of the stainless looks awesome on the bike
About quality and texture, I can confirm that the quality is great and that the materials used are a mixture of carbon fiber and stainless steel for the muffler and stainless steel for the pipe. About the feeling of use, The polished finish of the stainless looks awesome on the bike and the noise level of the exhaust is too loud for me at the higher speeds with the insert removed so I am leaving the insert fitted which helps generate a much more enjoyable noise level. Products to buy together, Some more carbon fiber parts to complement the carbon fiber muffler would be ideal to also add to your cart. Difficulty of installation, I can say the fitment of the exhaust system was very easy due to the small number of mounting points for the exhaust and the easy acess to these mounting points on the bike. Everything from the muffler mount to the spring retainers lined up perfectly. Cost performance and comparison with other products, The pricing of the product is great. You receive an exhaust system that is made using high quality materials and has high quality surface finishes. Nothing available with a carbon fiber muffler that looks this good. About shipping and packaging, My order was shipped within 24 hours of the product being in stock and I received a few emails advising me of the status up until the order was dispatched. The order arrived within the estimated date range and was extremely well packaged. I found the link supplied to track my order very useful while I was waiting for the order to land in the country. Any concerns, cautions, or advice when purchasing, I have no concerns or cautions when purchasing from Webike. I cannot recommend Webike enough for the majority of your biking needs. They not only sell aftermarket parts and bike gear but also OEM parts for your repairs and servicing needs. View detail
Quality Exhaust for Zoomer!
This exhaust was a perfect fit and sounds very nice. The quality is superb and I'm glad I got this for my build. It looks and sounds good. Highly recommend!! View detail
Installed, one week
It is very quiet when stopped and has a good sound when running. View detail
Such a Highly Polished Exhaust for the Monkey
About quality and texture: I am extremely happy with the quality of the trail exhaust system from Hot Lap. The entire system is made from stainless steel with a hightly polished surface finish. About the feeling of use: I run the exhaust system without the baffle and the sound is very pleasent to hear, while the main attraction is how stunning the trail exhaust system looks when fitted to the Honda Monkey. Products to buy together: A replacement exhaust system gasket would also be desirable to purchase alongside the trail exhaust system to ensure there are no exhaust leak after installation. Difficulty of installation: The process to install took about one hour, I was removing an aftermarket exhaust which is very simple as it was just the two nuts and the front and one clamp at the back but the exhaust port gasket was very difficult to remove and then the positioning of the exhaust to ensure it did not contact the aftermarket clutch cover was problematic but you will not encounter this probelm with the OEM Honda clutch cover Cost performance and comparison with other products: Great costing as you are getting a lovely designed exhaust system that is then outdone by the finishes of the welding and polishing from the boutique exhaust manufacturer Hot Lap at a very reasonable price as compared to a lot of the larger exhaust manufactures that just do not have as much appeal and most are also priced higher. About shipping and packaging: Sea frieght was my preferred method of shipping due to the lower cost but currently this service is unavailable from Japan Post, EMS is much faster which is nice. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged. Any concerns, cautions, or advice when purchasing: I can confirm that you can install the Hot Lap trail exhaust system in conjuction with the clutch covers from either Kitaco and SP Takegawa. It is a tight fit but with the correct positioning of the three parts of the exhaust system it can be achieved. View detail
Attached.
Acceleration is a little longer.
AdRing is very quiet and comfortable to run.
View detail
First HOTLAP Exhaust System purchase
I bought it after listening to the pictures and videos and the opinions of the buyers, but the sound was like a lawn mower.
We have made the exhaust system similar to YOSHIMURA's Exhaust System, but it is not as good as YOSHIMURA's.
View detail
Sounds crazy good.
Design, Sound is the best!
It goes right over the Brake, so it's a good choice for ShacoTanCustom!
CHALY and DAX have a cool HOTLAP Exhaust System!
View detail
good
First, we recommend a muffler-in point that can be installed in both the base type and the swap. The sound is also louder than the existing muffler, but the low-pitched sound is very good to hear. It's a little unfortunate that bracket fixing is a radiator, but I'm satisfied with this quality at this price. First of all, it is good that it is a muffler that can be installed both as a basic type and as a swap. The sound is also louder than the existing muffler, but the low-pitched sound is very good to hear. It's a bit unfortunate that the bracket is fixed to the radiator, but I'm satisfied with this quality at this price. View detail
Anyway, it fits well and is cool.
[How is it used? Used for ZOOMER Replacement
Was the one you received as per Image? Yes
Was the installation difficult? Easy to work with and easy to maneuver.
How was your experience with it? The sound is to taste, but the look is SMART and comfortable.
[Included Parts:were they on? Yes
[Was there anything that disappointed you? There was some rust-like staining on the Silencer welds.
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
View detail
Type 520 High Exhaust System from Hot Lap
* About quality and texture, Hot Lap products are made to order and hand crafted in Japan. The type 520 up exhaust has beautifully finished stainless steel piping and utilizes carbon fibre on the muffler sleeve. * About the feeling of use, When this exhaust was originally installed the rest of the Monkey 125 was still stock. The exhaust woke up the little 125cc motor giving the feel of a little more power and the exhaust note was now able to be heard and it is a marvellous. * Products to buy together, Shortly after installing the exhaust I also purchased the up style air filter for the Monkey 125 that Hot Lap also manufacture, due to the wait time do yourself a favour and order the exhaust and air filter at the same time. * Difficulty of installation, Due to the exhaust being made up of 4 main pieces the aligning of the exhaust was tricky along with tightening the nuts on the head due to the loop shape on the front pipe. The process was completed in 60 minutes with a little difficultly. * Cost performance and comparison with other products, The pricing of the Hot Lap exhaust is very far as the materials used and quality of the workmanship is outstanding. You are receiving a high end product at an affordable price when comparing to other available exhaust for the Monkey 125. * About shipping and packaging, I am happy to wait 6 weeks on average for my parts to arrive in Sydney Australia via Webike's sea freight which comes with tracking and insurance so I know I'm covered in case something was to go wrong but with there outstanding bubble wrapping and boxing there have been no problems plus there is an extra wait time for the part to be manufactured so be prepared for that. * Any concerns, cautions, or advice when purchasing, Before placing your order ask Webike for the next delivery date so you know how long you will be waiting. Use the product reviews to assist in making a decision on your purchase. View detail
HOT LAP Trail Exhaust System for Honda Monkey 125
About quality and texture - Top quality. All stainless steel and handmade to perfection, the bends and welds are just beautiful. About the feeling of use - By fitting this exhaust it doesn't turn the 125cc into a 1000cc motorcycle but it sure does make the 125cc sound awesome and makes the Monkey even more fun to ride. Products to buy together - Hot Lap also make air intakes to suit the Monkey which would pair nicely with their exhaust system. Difficulty of installation - I found the removal of the OEM exhaust system easy as it didn't have many kms on it so all the bolts come out without a problem and the installation of the Hot Lap exhaust was a little time consuming getting the three pieces together and lined up to my satisfaction. Cost performance and comparison with other products - Great price for an exhaust of this calibre, you will be hard pressed to find one as good for the money. About shipping and packaging - I think Webike are doing their best with shipping pricing, so I'm happy. Due to these exhausts being producted on order there will be a significant waiting time before it dispatches Any concerns, cautions, or advice when purchasing - If you are considering this exhaust system and also thinking you will be adding an aftermarket clutch cover, beware there is very limited space to have both of these fitted. View detail
Trail Exhaust System
About quality and texture - Excellent quality, the poilished finish on the stainless steel pipe work is outstanding. About the feeling of use - The styling of this exhaust system is something diffierent and I really like how it makes my motorcycle standout. Products to buy together - Good idea to replace the gasket on the engine head, lots of options to choose from here on Webike but you can not go wrong with an OEM replacement. Difficulty of installation - Easy to remove and install an exhaust on the Monkey, I did not rush the job to avoid any scratches and got everything lined up perfectly in an hour. Cost performance and comparison with other products - Pretty well priced for a Monkey exhaust in general but you are greatly great value for money when you consider the design and the quality material and workmanship that goes into these. About shipping and packaging - There is a delay on shipping due to these being made to order but once shipping your order will arrive on time and safety. Any concerns, cautions, or advice when purchasing - The heat sheild is not included so you will need your OEM heat sheild and fasteners to complete the installation, the exhaust system does not look good fitted to the motorcycle without it. View detail
Beautiful exhaust
Great fast delivery with fedex. Everything was well packed and very happy with my order. Hotlap exhaust is worth it :) Great fast delivery with fedex. Everything was well packed and very happy with my order. Hot lap exhaust is worth it :) View detail
Quiet and excellent Style
I was looking for a CT110-look exhaust system.
I also don't like large sound, so I chose this exhaust system. The volume is a little larger than normal. The volume is a little larger than normal.
It is no problem to run an engine in a residential area, even early in the morning or late at night.
It is also very well made.
I am very happy with it
View detail
The construction is beautiful.
Beautiful construction and overpriced, but the sound is annoying. View detail