Reviews
Fit feeling is good.
Installed on a PCX125.
We have used NeopreneType before and were very comfortable with it, so we decided to use the same Material this time as well.
However, the thickness of the part that operates the Blinker switch (left hand thumb) has been increased to improve durability.
I preferred the previous thinner one for ease of operation.
View detail
A must-have!
I bought it as a side purchase. Material without permission:I thought it was Rubber but it was made of plastic. It is thick and solidly built.
The cord, which I thought was a bonus, is quite solid and would be an Advantage for similar products not included.
The bicycle parking lot is full of STAND marks and will be used as soon as possible.
View detail
Easy Touring
Installed on CYGNUS X.
After all, long distance (It's 125cc, so it's about 300Km.) It was really easier to run than I had imagined.
I was afraid of damaging the Accelerator grip because it was very hard when I installed it on the Accelerator grip.
View detail
price-worthy
It cracked within two months of being put on.
Too bad
View detail
To avoid damaging the floor with the Transporter
I purchased this as a Side Stand receptacle when transporting a vehicle by Transporter.
This is not a problem if the vehicle has a well-machined floor, but when Tie Down is applied with Side Stand on a carpet floor, if the Tie Down is applied too tightly, the STAND will again dig into the vehicle floor, damaging the floor.
To prevent this, the floor is less likely to be damaged because the pressure is dispersed when such a board is laid down. Also, it is possible to apply a firm "Tie Down" even on soft floors such as carpet.
Basically, I leave it loaded in my car and use it when I use Transporter.
View detail
Currently being utilized in a gravel parking lot at a Touring destination.
If it is available, we will use it, if not, we will devise a way to stop it, but we can stop it without much concern.
A conspicuous color is recommended to prevent misplacing them.
View detail
I can feel the effects!
It's thick, windproof, and EXACTLY for the cold!
A Grip heater might be a good idea to keep the heat in better.
Visual is … I don't mind if you use it like this ….
View detail
Stretchable Fit
This product is relatively stretchy and can be installed safely through the thick part of lever if it is sprayed with parts cleaner to make it slippery. If you spray it with parts cleaner to make it slippery, it will pass through the thick part of the lever and can be installed safely.
Also, since it is not Sponge, it does not contain water even if it rains, and materially, it has an excellent non-slip effect, making Lever operation easier. Since it is not very thick, it is a little insufficient for preventing the coldness of Lever in winter, but it is much better than nothing, so I recommend it to those who endure the coldness of Lever without anything attached. I have been using this product for some time now and the durability is perfect.
View detail
Touring essentials
I think it is a necessity for long touring, etc.
The hand fatigue after touring is completely different with and without this.
I have put this on all my cars in the past.
I can no longer go Touring without it.
I recommended it to my wife and she was delighted.
View detail
Fallen cannibals
When I am out on the road and the ground is gravel, or in Asphalt where the ground is softened by exposure to high temperatures, the STAND may sink and the motorcycle may tip over, so I keep it in my bag at all times. It is like an insurance policy, but it gives me peace of mind. View detail
Expect durability!
I used to use Poshu's Sponge type, but it broke after about a year.
I know this type of product is consumable, but I liked it because of its non-slip and thermal protectionMaterial:I bought this one from Rubber.
It's cheap, but the above two points are effective, and the only thing left is durability.
View detail
I use it for long touring on highways.
I use this product for long touring at high speed. Sometimes the Axel comes back out of alignment, so I adjust it by adding Tape. View detail
For those who are feeling the cold limit.
SR400 has a small battery capacity, and I was worried about using a grip heater, and was hesitant to use electric heating gloves because they are expensive.
So I bought this product to try it out and was impressed when I used it.
First of all, it keeps my fingers cool because they are not exposed to the driving wind, and it is waterproof, so a little rain is no problem. (However, it will soak through the cracks a little, so that the fingertips will be a little damp after 30 minutes of driving in the city).
The design is also cute, just like the Mitten that Red-chan does.
View detail
Short Maybe too short for lever.
Installed on the short lever of NisshinHorizontal TypeMaster Cylinder.
The fit is a little worse with the short lever.
However, I don't mind using it because it doesn't make me gap.
It is functional.
View detail
To prevent Lever from slipping.
In the winter, I use Heated Gloves, but the Gloves do not have non-slip fingertips, so the Lever slips.
I used to put textured anti-slip tape on the reverse side of the lever, but now the leather of the glove has become rough.
That's when I found this product.
I sprayed a bit of perc on the inside and slid it onto the Lever and installed it.
If you use Silicon spray, it will shift even after you put it on.
The feeling of use is Large satisfaction.
You can now do subtle semi-cracks with electric Gloves.
View detail
for use at home
Purchased to park for Vehicle on the road.
I've only used it a few times, but so far no durability issues.
View detail
warmth first
As the title suggests, I tried many things, but it was the warmest I could stay in the Single Body It is
The windproof Warm Gloves without the Handlebar Cover will also keep your fingertips on the edge for an hour below zero I don't think the Lever Cover and Windproof Cover are perfect for sub-zero temperatures It is
With the help of electric heat, you can prolong the time a little, but if you can't completely prevent the wind from blowing, it will gradually cool down It will come
In that respect, the old Handlebar Cover has evolved in terms of material and usability You will need to change from Winter Gloves to All Seasons ones In addition, there were cases, not perfect, but in case of ordinary rain, Waterproof It's very comfortable and the Gloves don't get wet
I think that the extreme cold spec. can go quite well if you use Grip as an electric heat source, I think that the severe winter season is a necessity I think, it's a bit of a hassle and a bit of a drag, but it's the best countermeasure against cold It is
It's easy to put on, less expensive than other winter clothes, and provides good wind and winter protection
The operation of Blinkeretc. will be a little difficult, but I think that you have to get used to it I'm using it
View detail
It's the worst.
This product is in the Lever insertion part before use and defective at the time of molding (Rubber's poor running) There is
I will rip at the same time I put it in.. I did return processing earlier, but what will happen.
View detail
Essential items in winter
Once you start using it, it is equipment that you can not stop.
Because there is no core, in CUB without Clutch lever, because it is recessed by wind pressure, it is used with Handlebar Guard.
View detail