- Home
- Product reviews
- Search reviews
- Motorcycle Parts
- Handles & Control Parts
- Other Bar End Options / Repair Parts
Reviews
Note that it is not a common Bar end cap.
I bought it to fill a hole in the bar end, but I was under the impression that the actual product was smaller and exclusive.
I think there are probably many people who would do the same thing, so you should check the Size carefully before you buy.
View detail
as expected (as opposed to expected)
Since the ZETAHandlebar was installed in MT-03, I tried to make the Bar End also ZETA I did
It's the same Manufacturer, so the fitment is perfectly fine
Other Manufacturer's Tightening Rubber Spreads Type, Not Spreads I think there is little worry about it falling out because the part is aluminum
It is so light that it is useless as a weight, so be careful Note that I don't have any problems with the MT-03, especially with the vibration of the Handlebar
View detail
Cap of Bar End
I installed it because I care about the hole in the Bar End. I think that it is good that Cost performance is good, and that it does not protrude.
Manufacturer of Handlebar is unknown, but it was installed normally.
There is a sense of security for those who fit a bit harder and get stuck, but they will not be able to take while running.
View detail
Even if the price was cheap and it failed, good kana was thought and it purchased, but it attached firmly. It is good kana even if had as reserves when the Handlebar end is used and use becomes impossible in an unexpected accident. oneself -- CR
Even if the price was cheap and it failed, good kana was thought and it purchased, but it attached firmly.
It is good kana even if had as reserves when the
Handlebar end is used and use becomes impossible in an unexpected accident.
oneself -- CRM -- the pure right Handle (22 or 2 mm of outsides) has been equipped satisfactorily 250 Rr.
View detail