- Home
- Product reviews
- Search reviews
- Maintenance
- Oil Tray / Oil Tray / Oil Pan
Reviews
full capacity
I bought an extra Large capacity Drain tank for frequent oil changes.
After all, Items that can be stored and put away when they cannot be thrown away immediately are convenient.
View detail
Nearly 4 liters of oil tends to overflow.
The reduced height makes it easy to use even for vehicles with low vehicle height, such as the BOLT Shoulder Bag.
However, when the amount of oil is close to 4 liters, the oil level is close to the edge, so a little bit of oil can cause a problem.
Waste oil spills.
I guess it is TradeOff with the height being held down, but I don't think so.
Therefore, it is recommended to use it in motorcycles with up to 3 liters of oil.
View detail
It's just waste oil.
I bought this because I wanted a simple and cheap oil catcher.
The plastic boxes at Homsens are too tall and the capacity is too small, and it's hard to find something that fits.
With a capacity of 5 liters, it can also be used to replace oil in large motorcycles.
View detail
good [ to make the kana lid which should just narrow the crevice between it and the saucer on which the Oil which carries out warmth of the Engine and came to be alike of the Engine smoothly bounds ]
good [ to make the kana
lid which should just narrow the crevice between it and the
saucer on which the Oil which carries out warmth of the Engine and came to be alike of the Engine smoothly bounds ]
View detail
He wanted the small suspended tray used at a Garage, and it purchased about three. as Oil Drip pan -- the capacity 2L -- since it is a few, does a just right work load receive the Engine oil of small displacement volume vehicles, such as an abou
He wanted the small suspended tray used at a Garage, and it purchased about three.
as
Oil Drip pan -- the capacity 2L -- since it is a few, does a just right work load receive the Engine oil of small displacement volume vehicles, such as an about [ 0.5L~1L ] Fork oil, a Gear oil, and Cub, at most?
Since
BMW K1200RS has a Drain of a Transmission per Pivot of a Center stand.
Although the catchphrase which can let between the Center stands of a Scooter pass was expected and he bought it with eye aim -- It was a disappointment for a while in the state where an Oil will fall if the portion which the end extracted twists by an Exactly at the gap of a Center stand and it will twist when [ at which it puts and puts ] = Removing.
In fact, the direction of uses other than an Oil Drip pan is user-friendly.
As for the portion which the end extracted, a crevice is made between the floors which are raised bottoms and were placed, and since it is good for holding by hand exactly, it is used conveniently to carry out every [ of the tool in use / temporary ] by the floor of a Garage, or once receive dirt parts.
The imitation is put on the market also from the
DAYTONA, and on a nominal-cost Base, since it is practically equal, I think whether stock, a Sale discount rate, etc. are seen and the more suitable one should just be chosen.
View detail