Reviews
Fits: KAWASAKI Z250 (2013-), KAWASAKI NINJA300, KAWASAKI NINJA2 Helmet50R ABS, KAWASAKI NINJA250R, KAWASAKI NINJA2 Helmet50RR
Axle Shaft Replacement
OEMShaft was shaved off due to a fender bender and replaced.
The first difference with OEM is that it eliminates the need to use Split Pin.
This will lead to a MechanicalAdvantage when changing Tire later on.
Next, reduce Damage to Axle Shaft and Handlebar in the event of a fall.
Slider itself is an expensive consumable item, but it is a small expense considering the damage to the handlebar, footpeg, exhaust system, etc. when it falls over.
The 5mm hex Cap bolt allows for quick replacement.
Demerit is that there is no Instruction Manual for handling.
I am not sure about the Torque for tightening the Cap bolt and Axle Nut.
I had no choice but to tighten the nut side with the OEM specified torque and the cap bolt with 10Nm, but I am not sure if it is correct or not.
Next, Cap bolt must be visible.
There was a scattering of imprints that pointed out a few things, so it is possible that rust will occur over time.
If this is the case, please purchase a separate Cap cover.
When installing, be sure to apply grease to the shaft.
I applied Bell Hammer Grease No.0 to the wheel side and No.2 to the nut side to prevent rust, lubrication, scratches, and friction loss.
Unlike hollow shafts, the most outstanding feature of this product is that it can be easily installed and removed, but the lack of a handling instruction manual is the minus point.
The Ninja 250R and Ninja 250 are compatible with this model. (EX250L/M・EX250P) Therefore, it is recommended that you make sure that your motorcycle is compatible with the system.
View detail
Fits: KAWASAKI ZX-10R, KAWASAKI Ninja H2, KAWASAKI Ninja H2 SX SE+, KAWASAKI Ninja H2 SX SE
I love the texture!
First of all, the texture is very good. The shaft to fix the shaft is also black and looks tighter. (Although it is hidden by the Axle Shaft...)
It is very easy to install and takes only a few minutes.
I don't know how much protection it has, but I'd like to avoid having to take care of it if I can.
View detail
Fits: KAWASAKI Z250 (2013-), KAWASAKI NINJA300, KAWASAKI NINJA2 Helmet50R ABS, KAWASAKI NINJA250R, KAWASAKI NINJA2 Helmet50RR
[Webike Monitor] Since the Frame slider was purchased with Mr. Trickster's goods, the Front axle was also made into Mr. Trickster. As comment, it was not conspicuous too much and was a good feel in nonchalant touch. It is a charm in case of emer
[Webike Monitor] Since the
Frame slider was purchased with Mr. Trickster's goods, the Front axle was also made into Mr. Trickster.
As
comment, it was not conspicuous too much and was a good feel in nonchalant touch.
It is a charm in case of emergency like the
Frame slider.
View detail