- Home
- Product reviews
- Search reviews
Reviews
Fits: Others H4 Valve,HS1Valve DC12V lighting Minus common car
Like others, I can't get High beam in 6 months.
The company's HID (55w) and a fan of Halogen for many years. In that vein, I purchased the company's LEDs, which are more expensive but have higher Quality and self-satisfaction
Installation.
Note that the screw for attaching the heat sink of the ribbon is small and easily licked.
Ribbon is deformable to some extent, so if the volume is contained, it will be contained.
Controller and Ribbon are quite Large.
Wiring is thick and does not bend tight.
when using
For brightness, Kelvin is terrifically satisfied.
High beam is about 6 months old, and then it stops lighting up.
Low beam also disappeared after about 200 hours total!
I'm an amateur so I don't know what broke, but it's disappointing because I was hoping for a more durable life than HIDs.
View detail
Design and quality are good but squishy
I think Vibration is effective, but it is too Kunikunashi and very cumbersome to install and remove the phone. View detail
I don't think this is the best shape.
Quantity the phone:Set will deflect by its weight. To begin with, the BUnit determines the angle between A and C. The BUnit is used to determine the angle between A and C, and the squishy Unit is used to make it difficult to position the BUnit. I wish it was easier to change the angle. If the angle is close to horizontal, you can operate the phone just fine, but if you angle it, you can't operate the phone as you want. For such an expensive product, the feel of the product was terrible. View detail
Whether it really works is a mystery.
Vibration is mitigated by sandwiching the Rubber plate between the front and back of the three feet.
It tilts under the weight of the phone, so it may be doubtful how much vibration mitigation capability it actually has if it is tilted by a heavy phone.
The Rubber board is said to be a PARTS that needs to be replaced in about 2 years, but given that the Beacom 5X Speaker is disappearing from bulk sales, it is doubtful how long it will be sold individually.
I hope SYGN HOUSE will not try to sell the same parts even if improved products are released in the future, because it is doubtful that they will be made into the same parts.
If the Rubber plate is hardened, it is still OK, but considering the possibility of deterioration such as tearing off, I wanted the front and back to be connected by a wire to prevent falling off.
Since this is a Type product that mitigates rather than suppresses vibration, it is likely that some Motorcycles will have RPMs that increase the amount of vibration that makes it difficult to see the phone as much as it decreases the amount of microvibration that can be fatal to the phone that is not visible to the human eye.
It can be used for the old product, but it is troublesome because the place to fasten it with Screw adhesive has to be removed.
View detail