- Home
- Product reviews
- Search reviews
- Helmets
Reviews
Standard Handlebar (22.2mm) Mounted on
Since MOTOCOMPO did not have a helmet holder, I added it to the appropriate place in the Handlebar.
Similar ones are sold on amazon for similar prices, but the Bracket is thinner and more flexible for installation.
However, the Fixing Screw on the bracket is exposed, so if you are concerned about it, you may want to replace it with a special screw. (I think the attached screw is just a Hex Screw.)
View detail
It's worth the price.
[How is it used?
The XJR1300C doesn't have a helmet holder, so I chose this product which is cheap and looks easy to install.
Was the one you received as per Image?
The product images were well posted and were as Image.
How was your experience with it?
The price is right. It does its job well, but the key body sticks out unexpectedly, and it's a bit of a pain.
It is difficult to use because the key does not come off when you turn it...
At least I hope I can pull the key out when I open the key.
[Points to note]
There are no special requirements, but it is not recommended to install the key hole pointing straight up.
There is a risk of rainwater entering the cylinder and causing the cylinder to stop turning.
How did it compare to other products?
The KIJIMA Universal is more troublesome to install because you have to make a bracket.
This is difficult to use, so I will switch to KIJIMA.
View detail
Because it is an OEM Product...
I installed it in ZZ (Right Side) Can be used without problems
However, the stick which the product is hooked is likely to drop Helmet due to angular problems
You had better be careful with opening and closing
View detail