Reviews
Save money compared to buying at Rose!
The color stands out and gives it a custom feel, and as a manufacturer, I feel secure. I usually use OEM products, but I bought this product for fractional adjustment as well.
The quality and appearance were satisfactory.
View detail
sounding good
I can't do it myself, so the person who did it for me said that FrontSprocket is very good, in terms of material and lightness, etc. Rear sprocket can be attached with either a pure normal thread screw or a taper bolt, according to the specs. View detail
How nice
I had a motorcycle shop take a look at it and they said it really hasn't grown at all. View detail
of good quality
I bought the same one last time to replace it, but the chain didn't seem to be extended at all, even when I measured it. Is it OEM from somewhere else? View detail
Fits: SUZUKI GSX-S1000F, SUZUKI GSX-S1000, SUZUKI GSX-S1000, SUZUKI GSX-S1000F, SUZUKI GSX-S1000GT, SUZUKI KATANA
ChainSprocketQuantity:Set Exchange
The price was considerably lower than those available at mass retailers.
The installation was done by Shop.
I had a hard time removing Grease? on my new Chain.
View detail
Fits: SUZUKI V-STROM250, SUZUKI GSX250R, SUZUKI V-STROM250
Quantity of Front15T:I want the Set to be Lineup.
[How is it used?
The average fuel consumption has dropped below 30km/l, so I thought it was time to look at Sprocket and saw that it was firmly shurikenized, so I rushed to buy it and WebikePit in for a direct replacement.
How was your experience with it?
Since we went from Front 15T to NORMAL 14T, the ride has become very bad.
How did it compare to other products?
With 15T, I felt Smooth even when starting off and not trying too hard in the upper GEAR, but with 14T, it kind of feels like it becomes a hassle to run.
[Points to note]
If you buy Gold unintentionally, you will be somewhat embarrassed, so please be careful about the color.
[ITEMS TO BUY TOGETHER
If you are going to replace them, we recommend that you buy them together.
OEM Parts' Sprocket Washer
SUZUKI:27513-48H00
Watsiya, EngineSprocketts.
Item Number:27513-48H00
OEM Parts Hub Damper
SUZUKI:64651-20K00
Absorber, Rear hub shiots
Item Number:64651-20K00
[Opinions and requests to Manufacturer
As per Title, Quantity of 15T:Set is eagerly awaited.
View detail
Fits: HONDA Rebel300, HONDA REBEL250, HONDA REBEL250
Cold
I don't know much about it since I've only been driving a little bit since I changed it, but I'm Large satisfied with how gawky it looks. View detail
Fits: KAWASAKI ER-6n, KAWASAKI ER-6f, KAWASAKI Ninja650, KAWASAKI VERSYS, KAWASAKI Z650, KAWASAKI Ninja400, KAWASAKI Ninja400R, KAWASAKI ER-6n, KAWASAKI Ninja650, KAWASAKI Ninja650R, KAWASAKI VERSYS650, KAWASAKI Z650RS, KAWASAKI ER-6f
As preventive maintenance!
Love the product!
I still think that improving the appearance of the product is the most important thing.
Chain feels smoother and quieter on the road!
I replaced Front and Rear Sprocket at the same time, but the mileage is 27,000Km.
I was surprised that FrontSprocket was reduced more than I expected....
I thought it was a little early to replace it, but from a preventative maintenance standpoint, I'm glad I did it early!
Just! The exchange was motivated by 'Prices go up in December.' and I bought it at the end of November.
I don't like the fact that as of December 12, it's about $1,000 less than when I bought it.
Therefore, one star is deducted.
View detail
Fits: HONDA CRF250L, HONDA CRF250L, HONDA CRF250L RALLY, HONDA CRF250L RALLY
Quantity:Easy to buy in Sets
Quantities of Sprocket, Chain, and Joint:It is easy to purchase because it is a Set.
The DID Chain is more expensive than at Sale, but I think it is stable and cosmetic.
Sprocket is a reliable SUNSTAR.
The Sprocket for crf250rally also looks exactly like OEM in shape, but is probably aluminum because it is lighter.
The Seal of the Chain is shaped like an xring of DID.
Rivet is also hole punched (Non-Penetrating) The lightweight design of the product has been designed to reduce the weight of the product.
It looks more elaborate than DID's VXSeries.
I thought Chain was OEM, but I don't know because I don't have any information. Maybe it is completely in-house production.
I expect it to be durable
View detail
Runs lighter!
It used to be STD Size RKChain, but this time we Converted it to 520 due to wear of Sprocket.
The lightness when pushing and pulling the motorcycle can be felt as soon as it is installed. Immediately after installation, put the quantity of oil on the maintenance stand to wipe off excess oil.:The weight of the Chain itself is also light.
Well, we replaced the old Chain with a new one, and also performed maintenance around the Axle and Rear brake while disassembling the Chain, so there may be some effect of that.
I think it is because the weight of the ChainBody has been reduced, but I also feel that acceleration has improved.
Installation requires specialized tools and solid knowledge. One wrong move and you or someone else could be killed.
If you are not confident, you should leave it to the Pro shop.
If I had to say, I would have preferred a more subdued gold color for the ChainBody, but that's just a matter of taste in this area.
View detail
Fits: KAWASAKI Z1000, KAWASAKI Ninja1000SX, KAWASAKI Ninja1000, KAWASAKI Ninja1000SX
Chain and Sprocket 3-point exchange
Cost is also low, and the three Quantities:I replaced the entire set after 30,000 km and the play and squeaks are gone and the ride is better. View detail
Fits: HONDA VFR800F, HONDA VFR800X, HONDA VFR800X, HONDA VFR800F
There is rattling in the FSprocket.
It was a replacement from OEM Parts.
Chain、DrivenSprocket (Rear) The "A" and "B" are fine, and there are no problems with installation or drive.
DriveSprocket (Front) Even when tightened at the specified torque, there is a slight rattling in the direction of the thrust.
Is it thinner than OEM?
The OEM was fully fixed by tightening the fixing bolt, so I am not sure. Therefore, I changed only the DriveSprocket back to OEM.
I will look for a washer with a compatible diameter and reassemble it at a later date.
View detail
Fits: HONDA CB250R, HONDA CB250R, HONDA CB300R
Quantity:Set is cheap
I like Driven Sprocket by SUNSTAR and Quantity:I bought it as a set. The DrivenSprocket is light and I like the color Champagne gold, not too flashy. The color of the Chain is Silver and it matches the color of the Sprocket. View detail
3 pointsQuantity:Set Exchange
[How is it used? Street riding + Winding
Was the one you received as per Image? Looks like it was OEM Chain + Rear sprocket so you can feel the change.
Was the installation difficult? I bought a SpinnerHandlebar and it came off without a hitch. The painting of the Wheel+Swing Arm was the most large strange.
How was your experience with it? I couldn't feel it that much.
Items to buy together I also bought a device to crimp the chain, and I used the Grinder.
It's easy, I've had no problems with anything not that expensive.
Opinions and requests to Manufacturer For GPZ900R, only 530 is available. If you want to change it anyway, you can get 525 or other tooth setting for Quantity.:I wish it was in Set.
View detail
Fits: KAWASAKI NINJA250, KAWASAKI Z250
Replace it regularly!
Quantity:I was able to buy a set at a discount. By replacing it regularly, you can enjoy riding with peace of mind. View detail
Fits: KAWASAKI ZEPHYR400X
Please note the difference between the photo and the real thing
In the picture, I think the Sprocket of Rear is Silver
I want to make the NORMAL-like appearance of the Large cutter, so I prefer the Black one if possible I bought it in silver to trust the quality of SUNSTAR, and it was a good choice for me It was In fact, the product I received, Rear sprocket, was Black
I was originally happy with the black ones, but the motorcycle parts are not good for appearance I think a lot of people are obsessed with it
I thought some people would be upset if the Black arrived expecting Silver
I think it's better to improve it to prevent Objection
The price will be more expensive to buy here and bring in labor, or buy it at the Shop for a fixed price and get a regular labor rate I think it's cheaper to compare the
I don't know the performance because I haven't used it, but it's a large hand-made manufacturer, so I trust it I think it can be done I'm giving it 3 stars for uncertainty
View detail
Fits: YAMAHA MT-07, YAMAHA XSR700, YAMAHA XSR700, YAMAHA MT-07
Quantity:Set for peace of mind
The front and rear Sprocket and Chain are the Quantity:It's a good thing that it's a set, so you don't have to worry about it as long as you don't make a mistake in choosing the right car
I like the look of Sprocket's Gold and Chain's Black gold!
View detail
Fits: HONDA CB400SF, HONDA CB400SF, HONDA CB400SF
It's not the same as OEMs! by RANRose Le
When I finished the exchange and turned the Tire around, it was light! So light!
Smoothness at the start of the ride is also very different
Pricey but satisfying!
View detail
Fits: HONDA CRF250L, HONDA CRF250L RALLY, HONDA CRF250L, HONDA CRF250L RALLY
Chain length is specific to each model of car for ease of use!
From the beginning, the length of the Chain is specific to the type of car you're driving, so if you don't want to deal with the hassle, this is the way to go
SUNSTAR's Driven Sprocket is also super light than the OEMs, and the Driven Sprocket is also very accurate
I just replaced it, so I can't Impression the durability yet, but I also have a few thousand? Impression if I haven't forgotten it after a few thousand? miles
View detail
Fits: YAMAHA MT-09, YAMAHA MT-09 TRACER, YAMAHA XSR900
It feels lighter at the start
The installation was done by the PRO at the time of inspection and maintenance
It looks better, starts out lighter and runs smoother
The future ChainMaintenance is a Large thing!
View detail