Reviews
Repair Parts was a great help!
I broke and obtained the already discontinued Square LCD Speedometer & Tachometer's Gold Genus Reactive Speed Sensor.
I am glad to hear that you are now safely posting speeds.
View detail
Replaced due to poor contact
This is a regulator to protect Digital meter. Recently, the power supply of the meter was frequently turned off, and we traced the problem back to this Mini regulator. I replaced the Mini regulator because it had been used for more than 15 years and seemed to be causing poor contact due to age-related deterioration. After the replacement, the event that the power supply of the Meter falls did not occur anymore, but it is only confirmed in Idling state, so I would like to confirm it by running the Meter. View detail
bright
If it was so bright, I wondered why I hadn't put it on sooner.
The brightness is perfect, but I had to buy a Crimp Tool for the Bullet Terminal, and the Crimp did not work well, and I am a novice at installation.
It would be even better if Wiring would sell it complete, even if it costs a little more.
View detail
Fits: HONDA CT125 CT110 HUNTER CUB, HONDA CT125
Simple and multifunctional
I purchased the car before delivery of my JA65 and had it installed at the Shop and delivered.
I guess the Tachometer will increase the Tension.
Gear position is still displayed with a 1TEMPO13 delay, but once you get used to it, it doesn't bother you so much.
The Temperature Sensor is currently used for air temperature, but I would like to buy a dedicated Drain bolt to measure Oil Temperature Meter eventually,
Overall, I am satisfied.
View detail
Fits: KAWASAKI KLX125, KAWASAKI KSR110, KAWASAKI Ninja250R, KAWASAKI KSR110, KAWASAKI D-TRACKER125, KAWASAKI KSRPRO
Can be attached to VULCAN400S.
Installation
Dedicated to a few comrades, the VULCAN400S Blinker is a ninja250r (2008-2012) The same parts can be installed without any modification.
However, it takes some time and effort because you have to remove Headlight and Rear Fender after all.
Also, I was troubled that the Bullet Type Terminal of Sub harness was very hard. Is it like this?
[Regarding the clarity of the Instruction Manual.
There were some impressions that the Instruction Manual was difficult to understand, but I think it is easy enough to understand compared to the ones that only show pictures of foreign countries. I didn't have any particular problems.
[Try it.
I am satisfied with the look of the product, as it turned out almost exactly as in the Image.
Well, after all, if you're going to go through the trouble, wouldn't it be better to use LEDs? I can't really argue with that.
View detail
Fits: HONDA Dio110, YAMAHA CYGNUS X, Others , YAMAHA BWS125
For VSTROMSXBlinker Valve replacement
I purchased SP Mukawa's Plating Valve to fix the orange bulb that I could see through the OEM Clear Lens. The only thing I was worried about was the amount of light, but it is sufficient and looks Refreshing! View detail
Fits: HONDA CROSSCUB110, HONDA CROSS CUB50, HONDA SUPER CUB110, HONDA SUPER CUB110, HONDA SUPER CUB110, HONDA SUPER CUB 50, HONDA SUPER CUB 50
I have tried to install it on the CUB but...
I was given a pair of Smoke Blinker Lenses and installed them, so I purchased these lenses for a sense of unity and dress-up.
When the car stops, everything is [Color] Smoke gives a sense of unity and enhances Parenthesis.
However, unlike the Blinker, the Motorcycle's BrakeLight lights up along with the Headlight when the key is turned on and the Engine is ignited.
Although it was darker than OEM, it wasn't as disappearing as the car, so it was half as effective...
In the strong light when I put Brake on, it looks more like Pink than Red...
I guess I was a little disappointed for the price.
However, since it is a Mukawa, the texture and precision of the objects are unquestionably good.
View detail
UniversalBlinker.
I purchased the Jixxer 250 for rounding Light.
I wanted to create a Retro feel, so instead of the sharp Type of LEDs.
We went with the old-fashioned Light Bulb Type.
I felt the kindness of the Manufacturer in the 10W and 15W bulbs included.
View detail
Takegawa super multi TFT meter
The installation manual is in Japanese, so it requires some interpretation, and the photos in the manual are blurry and difficult to distinguish.
It is not very difficult to remove and install the existing product on the actual bike.
I think even beginners can install it on their own.
Among Monkey 125 instrument panel products, its performance is expected to be by far the most overwhelming. -------------------------------------------------- -------- There is a manual for mounting in Japanese, which requires a little interpretation, and the photos of the manual are blurry. It is not very difficult to remove the existing product from the actual bike. It is thought that even beginners can be equipped with self. Monkey 125 dashboard products are expected to be overwhelming. Powered by Google Translator
View detail
Shipping costs are high.
The shipping cost was 500 yen for an item that could fit in an envelope, which is a rip-off. I wanted to buy it somewhere else, but I had to buy it because there was a Point that was about to disappear. There are some air bubbles in the corners, but they are easily removed with Microfiber Cloth. Place it where it will not be disturbed. Takegawa. I like the logo. I think it is better to put it on as soon as you buy Motorcycle, like a protective film for your cell phone. I had to wait two weeks to get it, but I can recommend this product. If you can buy it cheaper from other companies, I think it's better to avoid buying it here, where they charge 500 yen for shipping. View detail
Fits: SUZUKI ADDRESS V125, KAWASAKI KSR110, HONDA PCX125, HONDA MONKEY, HONDA APE 100, HONDA GORILLA, YAMAHA CYGNUS X (FI), HONDA APE 50
Used for CUB90
CUB90 is equipped with external Tachometer, various sensors, USB power supplyCoupler, and LED on the Tail to reduce battery load.
The bulb power consumption of the NORMAL is 15W/8 and the LED is 21W/5. The LED is not labeled in Lumen so I did not know how bright it was but I trusted Brand.
The large size is a little smaller than a light bulb, the bracket is in good condition and the tail lens has not been hit.
I read that it was a little dark in the impressions, so I cleaned the tail lens and put aluminum tape on the tail case, which is an old-fashioned way of doing things.
The Tail Chica-Chica is a little bit when the Idling is on. Stop-lamp is powered by battery, so it does not ChicaChica. The light is bright enough to pierce your eyes at some angles.
When the Lens is turned on, the ChicaChica of the Tail is not felt. The brightness of the Tail is about two-thirds that of the bulb, and the Brake is about the same or slightly stronger than the bulb, which is fine.
Tail is AC so ChicaChica is not an option but I don't know how it is for the life of the LEDs. I have been using it for about 6 months and so far no problems. I remove the Lens every once in a while, but it is not burnt or deformed.
After installation, the charging voltage did not change during idling. Battery load seems to be decreasing. I think it can go as it is.
View detail
Good flim
It's a really good product. Both the finish and the design are excellent. Thank you for your prompt delivery. I recommend this product to others, too. View detail
It's a good one, but the cad has been yadda yadda.
MeterThe name "Mukawa" is on the place where it might be hidden if it were attached.
Material:Stainless Steel, a little rough cut, might bother some people?
I was worried about the curds, so a little yas yas.
Sticker is also available in the contents.
It's just that you can't find it anywhere in Site, and that's why it's dimensional.
No overall length because I think it's a bending assumption. (Don't tell anyone that I didn't include it because it was ambiguous due to Caliper's Size.)
I'm sure it varies from person to person, but just as a guide ….
Hole diameter 10.6mm, hole circumference 17.8mm
Meter paste position
Width 43.9mm Height 27.9mm Thickness 1mm
View detail
Blinker Bulb of a bygone era
Ordinary Blinker Bulb being eclipsed by LEDs View detail
Easy installation with pon
I had a hard time to make it fit nicely because the connecting Cable is too long to store the Wiring from Coupler to Meter which is connected to OEMCable. View detail
Fog Lamp installation.
I installed it to supplement the Headlight. This is a Large Variant value for money product. It is bright and reliable. I am very satisfied with the product and the workmanship. View detail
Fog Lamp installation.
I installed a Fog Lamp on my CT110 HUNTER CUB to help with the lack of Yellow dragons in the headlight. This is a great deal for the Large size. It's great! It was good for safe driving and peace of mind. I am glad that I found the installation manual. View detail
An Appreciating the use of the Tachometer on the CT125
About quality and texture: I am happy with the quality of the small DN tachometer kit from SP Takegawa. Stainless steel housing with a black instrument face, analog RPM needle and white LED backlighting. About the feeling of use: This tachometer displays so much more then just the engine speed. A compact unit that allows you to continue to use the OEM Honda speedometer. Products to buy together: The SP Takegawa engine drain bolt would also be desirable to purchase alongside the small DN tachometer kit so you are able to display the engine oil temperature from this location and should really be included in the kit. Difficulty of installation: The process to install takes about about two hours. The mounting bracket needs to be attached to the speedometer mounting point, the headlight bezel needs to be removed to access the electrical connectors, you needs to run wiring for the engine speed and temperature signals and then mount the tachometer and connect the wiring. A little difficult to do. Cost performance and comparison with other products: Good costing as you are getting a well featured and stylish design tachometer but not quite matched to the CT125 as compared to the tachometer from Daytona that is cheaper to purchase and looks better fitted to the CT125 but lacks features. About shipping and packaging: Sea frieght is my preferred method of shipping due to the lower cost and it is fantastic that it has returned as an option once again so I can put my money toward parts and not high shipping costs. Webike kept me updated on the status of my order up to when it shipped. The parcel arrived within the expected date range and was well packaged with no chance of the part being damaged. Any concerns, cautions, or advice when purchasing: One feature that you may like to have but it missing from this product is a gear indicator which can be had with the super multi DN meter from SP Takegawa but at a higher cost and removal of the OEM Honda speedometer. View detail
Bright!
I thought I didn't need it because I don't run at night. I have two 6.5W lamps, but they are bright! I am satisfied with it, although I use it infrequently so far. I am not sure about the durability yet. View detail
Fits: HONDA CROSS CUB50, HONDA CROSS CUB, HONDA CROSSCUB110
Tachometer is not enough without it!
I wanted a Tachometer, so I bought it. 3 types of Meter are sold by SP Mukawa, and I was not sure which one to choose, but I am glad I bought the one without LCD because the MeterSize is too small. I think the LCD part is probably too small to see. I asked a motorcycle shop to install the meter because I needed to remove exterior parts for wiring and there was a possibility that I might put a wounder on the meter if I did it by myself. I could see how many revolutions the car was making and I could rev the car higher than before I installed the wiring. I think I can now pull with more confidence. View detail