Reviews
To change the angle
Takekawa's dry method (Hydro) DAYTONA's Clutch from (Hydro) The angle of the release was changed with the change to the 17RHydroClutch, so the angle was adjusted with Mukawa's Fitting. The 17RHydroClutch from Mukawa is the same as the Slim line, so this fits. View detail
Also in Universal Product
I purchased this clutch cover to install an oil cooler on a Special clutch cover.
I thought about using a universal product, but since the oil cooler is also made by Takegawa, I decided to use this product to unify the two.
The degree of curvature is moderate and I am satisfied with both the quality and fitting.
Although it is slightly more expensive, I am satisfied with the fact that it is made by Mukawa.
However, it would be better if other colors were available.
View detail
Also in Universal Product
Installed on TakegawaSpecial clutch cover for APE.
I thought about using a universal product, but since I had prepared an oil cooler made by Takegawa, I decided to purchase the product in question anyway.
Naturally, there were no problems with quality or fitting, and the installation process was smooth.
However, I have heard Small ear that color fading occurs after long-term use, so I am concerned about that.
It would be better if other colors could be selected if possible.
View detail
Nice quality red anodizing not pink like some other brands
Nice quality red anodizing from Special Parts Takegawa not pink like some other brands. Light weight aluminium banjo bolt beautifully machined and finished to give my Honda Monkey 125 motorcycle that high end finish I am looking for. Pricing maybe slightly higher then a few other brands available here on Webike but like they always say, you get what you pay for. When working with anodized bolts like this I like to use single hex sockets to minimise the chance of damaging the coating and keep them looking as new after installed on my motorcycle. View detail
It's angled.
It's not Straight Type. It is angled. It seems to be able to be used when you want to change the handling. View detail
It's a bit expensive
I think the price is a bit high, but I have no special complaints. View detail
Be careful not to overtighten.
The Material is Material, so be careful not to overtighten.
I've done it myself.
I was lucky enough to get it at Single Body.
View detail
If it's a little cheaper:・・・・
My GROM with more heat since I replaced it with a NEOHead.
Takekawa:I installed KITACO:New superOil coolerKit 5-stage CoreCondenser in the Compact cool because I could not control the heat quantity increased by the head replacement.
However, in order to avoid hydraulic clutch and overcooling, Takekawa:Special clutch cover Spec. To get the best of Special clutch cover and KITACO:New superOil cooler, you can install Oil cooler repairParts Mukawa:Banjo set (30 degrees).
Before the installation, I was anxious whether the length of the oil hose attached to the New superOil cooler kit was enough, so I purchased the oil hose (1M) of Repair Parts separately. As a result, the length of the oil hose attached to the New superOil cooler Kit was enough for about 5cm extra.
When the head temperature reaches around 105 degrees, the engine heat content makes the hot oil flow to the oil cooler core. Oil cooler core inlet and outlet become hotter and hotter, and the oil that passes through the oil cooler core goes through the oil hose and comes back to the engine. Check this operation to see if there is no oil leak etc. Check.
By making the inner diameter larger than the Compact cool oil line, the flow rate into the oil cooler core increased and the load on the oil pump could be reduced. It cost us a lot of money to adopt the good points of both companies, Takekawa and KITACO. However, the cost effectiveness was good, and the result was Yes! and
View detail