Reviews
Sound is Large size
The sound is more loud than expected. However, there is no problem unless the throttle is set to a large sound level, so I am careful when driving in residential areas. Installation is easy, but before opening the side cover, it is better to watch how to remove it on YouTube. View detail
Fits: HONDA CROSSCUB110, HONDA CROSSCUB110
I am satisfied with the look and sound of Large.
Installation was very easy.
The instruction manual of Mukawa gives the impression of being friendly and helpful.
There is an instruction manual, so even those who are not familiar with the product can install it.
There are many installation videos on YouTube for your reference.
The Sound has changed a lot with the installation.
The sound is crisp and clear, and you can feel a sense of euphoria when riding it.
I don't think it is bothering the neighbors.
Thanks to the Exhaust Guard, no heat is felt.
The Torque feel seemed to drop a bit at low speeds.
It seems to have improved the outflow.
However, I feel that the extension at high rpm range has increased.
So far I am Large satisfied.
I don't see anything particularly bad about it.
View detail
ZOOMERX
Finally installed.
It is not popo-popo and noisy, which is good.
However, I wonder if it's just me, but sometimes the engine stalls or the plug is covered, so I wonder if I should change the air cleaner or the plug.
Can someone please tell me what is going on?
View detail
Single engine-like sound quality!
I liked the design of the OEM Exhaust System because it suited my MONKEY, but the sound was too quiet anyway! When waiting at a traffic light, it was so quiet that I thought the engine was stopped. I thought that the engine was stopped at the traffic light, but it was so quiet that I decided to use the same up type muffler as the OEM Exhaust System.
From among the candidates, TakegawaExhaust System was selected this time. (I had intended to purchase the OUTEX Muffler, but since I had to wait 3 months for delivery, I decided to cancel the order.) As for the impression after the installation, it is the one that seems to have been right as a result.
I think the style is also suitable for MONKEY (in my opinion!). And above all, the sound is great! I like the single sound. However, the width of the Silencer is a little narrower than the OEM Exhaust System.
There are a few disappointments, such as the gap that allows some of the fl−厶 and wiring to be exposed, and the low speed Torque is comparable to the OEM, but the top speed seems to have dropped a few kilometers (based on meter readings), but the Style and sound make up for it.
The sound is very aggressive at low to medium speeds after starting from Idling, but the sound subsides at cruising speeds of 50 to 60 km or more, so it is a recommendation for those who drive in long & minus;rings. I have installed TakegawaAir Filter this time.
I have ordered an additional one and am looking forward to seeing how it changes with it!
View detail
Fits: HONDA MONKEY125, HONDA MONKEY125
For ultimate self-satisfaction
I like the look of the NORMAL as it is, but I wanted to do something about the quieter (classy) exhaust sound than the postal CUB.
The installation work was easy, and at a slow pace, we were able to complete the work on a holiday morning and test drive in the afternoon.
Exhaust noise is not too loud Pong! Pong! Pow! The GRUGRU under the engine is gone, and I'm happy with the Refreshing look and the extra ground clearance.
View detail
quite
It has a low-speed torque that is comparable to that of NORMAL and is very easy to ride!
The style of the exhaust pipe is also very nice with the silencer of Megaphone type.
To be honest, I was right to buy Large.
View detail
I like the styling, it doesn't fall apart.
The shape is close to NORMAL, and the material has been changed to Stainless Steel for an improved texture. View detail
Fits: HONDA SUPER CUBC125, HONDA SUPER CUBC125
Since we are not on an expedition, please visit ・・・・
Do-it-yourself replacement is not that much of a challenge.
Separately, heat-resistant Gasket agent seems to be required.
I think it is quiet at Idling time.
Noisy at higher RPMs, which is also the case with other exhaust systems.
P.S. I feel the sound is quieter than Y-CYCLONE.
In the city, you will forget about 4th gear. The sound of the backfire is so loud that you will not mind it once you get used to it.
Tunnel noise is a concern since it is not running Tunnel. ・・・・
CYCLONE returned to OEM due to concerns about Tunnel running.
View detail
Fits: HONDA SUPER CUBC125, HONDA SUPER CUBC125
After all, from OEM
I think it is quiet at Idling time.
Compared to OEM, it is noisier at higher RPMs.
View detail
Cabton suitable for CUB
I don't want to be Sporty for CUB, so I choose Cabton. It's cool.
Kiko's is a bit squat, so here it is.
If you don't install them in the order as per the Instruction Manual…
After installing the Exhaust System, be sure to install the Rubber Plate on the Center Stand before raising the Center Stand, otherwise the STAND will hit the Exhaust System.
Torque at low speeds drops slightly, but extension is good. Fuel economy may be down slightly.
Sound is surprisingly loud at low speeds. At high speed? the Cabton characteristic sound fades.
Recommended for those who are unhappy with the design and sound of the Normal muffler!
View detail
Fits: HONDA MONKEY, HONDA MONKEY, HONDA GORILLA, HONDA GORILLA
Large People's Exhaust System
I like it very much because it handles very close to OEM.
The volume is quiet enough, and when loaded, the sound is crisp and clear.
View detail
Fits: HONDA CROSSCUB110, HONDA SUPER CUB110, HONDA SUPER CUB110
SCRAMBLER Exhaust System used for JA42
[How is it used? In use for city driving
Was the one you received as per Image? Satisfied as expected
Was the installation difficult? Gasket on Pipe connection is a little difficult
How was your experience with it? The volume seems a little too Large, but the top is now spinning.
[Included Parts:were they on? no problem
[Was there anything that disappointed you? nothing special
Other items that would be helpful
Installation Point or hang It is easier to remove the OEM Exhaust System by removing the footpeg instead of doing it horizontally.
important point Gasket at the Pipe connection should be inserted without haste.
View detail
Parenthesis good!
The primary motivation for replacing the exhaust system was to improve maintenance of the rear axle shaft, which is out of reach of the normal muffler.
This is what we expected without question and makes Puncture repair and Tire replacement easier.
I also like the CLASSIC design and the Large change.
As for the sound, the sound quality is to my liking, but the volume may be a little loud for an old man nearing his 60s. It is not so loud as to be an explosion.
I cannot feel any difference in power, but I feel that Torque in the mid-speed range has increased a little.
View detail
Fits: HONDA GORILLA, HONDA MONKEY, HONDA monkey, HONDA gorilla (Gorilla spp., esp. western gorilla, Gorilla gorilla), HONDA monkey, HONDA gorilla (Gorilla spp., esp. western gorilla, Gorilla gorilla)
Although only the exhaust pipe only for DOHC can be used, if compatible with the muffler of each company, I will feel that he can enjoy himself more.
Although only the exhaust pipe only for DOHC can be used, if compatible with the muffler of each company, I will feel that he can enjoy himself more. View detail
Exhaust pipe dizzying
[How is it used?
The YZF-R25 is now being racerized with a BEAMS JP250 exhaust pipe.
O2 Sensor is no longer needed due to the introduction of RapidMotorcycleRACING, so this product was introduced.
Was the one you received as per Image?
It was exactly as shown in the picture. I felt that the length was a little long.
I think that the protruding part of the Bolt may be too exposed on an exhaust pipe with a low boss height, which may cause exhaust resistance.
Was the installation difficult?
Gasket is also included, so be careful not to forget to install it.
How was your experience with it?
Gasket is included and is working well with no exhaust leaks.
I am happy with the price because other Manufacturer's products are ridiculously expensive.
The O2 Sensor Blind Screw is loose in the Large body. Therefore, it was necessary to be able to do Wiring.
When you install it, don't forget to retighten and wiring.
Also, since Size is not mentioned in the product description, it is included for reference.
Screw Diameter:M18
Pitch:P1.5
Length:23.5mm
Wiring hole diameter:1.5mm
I don't know what the Material is, but it is something Brass-like. (Laughs)
[Included Parts:were they on?
One Gasket is included. Is this also something that is not sold by Repair?
[Was there anything that disappointed you?
None in particular. As a precaution, it is recommended to apply Thread compound before installation to prevent galling. Especially in the case of stainless exhaust pipe, it is better to apply it because it is easy to bite.
View detail
Normal look is good
It looks NORMAL, and a good SOUND resonates when you turn it.
Embellishments are poco-poco? Bobo-bo? tive Sound.
There are no exhaust leaks, and Idling is so quiet that it doesn't bother me even early in the morning.
The installation was easy to understand with detailed instructions, and if you have replaced an exhaust system before, it should not be difficult.
The downside is that you end up running it too hard, which of course lowers fuel efficiency...
(a little). You can think of it as Total.
View detail
The design is subtle, but the sound is good and Response up.
The sound is not too annoying, but you can enjoy the pleasant bass sound and the goodness of the single shot. I compared it with the OEM one, and it is clear that the pickup is better from the lower rpm range, and I don't feel the torque drop. I live in the countryside and there are a lot of up and down roads, so it is easy to keep the power band with less stall on the uphill.
My only complaint is the design, it's designed like an on road motorcycle so it doesn't have the feel of a trail bike.
View detail
Satisfied with the quality and price!
Purchased as a replacement from the OEM
The sound is a little larger than OEM, but not a blast
It was my first time installing it and it took a little over an hour
I like it because it looks great
View detail
Dad, Dad, Dad
Compared to the OEM, the sound quality is much better
even if it's not "… Peke-Peke-Peke, And against an OEM that sounded slightly delayed and jammed Daddy-pop! and the crisp sound under acceleration is very pleasant to drive on country roads
But it was quite noisy than I expected it to be, so it might be a little annoying & hellip; if you're riding in town The sound was amazing at the start The sound level was about 70% of the volume without the exhaust system
Also, because the exhaust pipe is short, the heat from the butt and thighs on the Right Side will come considerably It's a good idea However, because the appearance under the Engine is considerably Refreshing, I'm personally satisfied, and I'm not a fan of it Exhaust System Up Type's OEM design is not too disruptive, and The appearance of Dual Silencer is above all unique and I like it
It's simple and inexpensive
View detail
It's a reasonable price and I'm happy with the sound
As part of the Power up, Takekawa's Cam and Piston, F Icon, Power Filter and Quantity:Purchased as a set
It's a fun motorcycle with good acceleration and a light blow up
View detail