Reviews
Used for diversion
Installed on NINJA Long Side Stand
Installation is no problem, but if it's not a hassle, it's better to weld it one-off tightly.
View detail
Recommended for vehicles with no Assist if price is fine
Wr250x does not have Stand Assist and it has difficulty in dropping It purchased and installed a gold tool that is likely to fit at home center but it will rotate with the power of the lowering it will be removed and it will detach in terms of appearance and hesitate in terms of price Although it was finally purchased, 22, 2 Size of Pi is just like to our vehicle and I like the texture of the product well, but even if it is attached directly to the STAND it is necessary to paste Film to prevent large mortgage Considering things, I think that it is good if the Screw mountain part of the bar should be 5 mm longer, but since the part where the Screw is fitted opens a little, when Screw is tightened, the Screw mountain part of the bar is insufficiently tightened If you do not enter the full Bolt part, if you tighten too much, I feel like it will break because M6Size and tighten up to where Body does not move so that Screw will not fall off
Body is wound and fixed with Film. I'd like Manufacturer to improve this neighborhood a bit but the inconvenience that I have had is resolved. In addition, Size is the same as Handlebar 22, 2 pie. If Size is a little thin, I think that we can deal with thin inner Rubber sheet etc, but if it is a little thick Size it will not enter Mounting Hardware For reference.
View detail