Reviews
Although there is a high degree of freedom
The flexibility is high, but the number of mechanisms is large, so it can be a bit of a challenge to install without thinking about it.
Texture was appropriate for the price, and visibility was not much different from OEM.
With a single cylinder, there is a certain amount of vibration.
The hardness of the moving parts can be adjusted by you, giving you peace of mind.
View detail
Good vibes
It is a little difficult to adjust the movement, but I am satisfied. View detail
Fits: HONDA CC110, HONDA CC50, HONDA CT110, HONDA CT125, HONDA CC110, HONDA CC50, HONDA CT110, HONDA CT125
Very cool under the buttocks.
After parking under the blazing sun, it is sometimes uncomfortable to sit on the Seat because it is so hot, but this Mesh cover helps a lot. The MeshMaterial itself does not hold that much heat, so you don't feel it as hot.
Besides, once you start running, you will feel very cool under your buttocks because the wind will be blowing through the 3D MeshMaterial in a nice way. It is too cool when the temperature is low. It might be better not to use it in spring and fall (Lol) Of course, you'll have to leave it off in the winter.
Note that MeshMaterial is more slippery than SeatMaterial, so the holdability of the buttocks will be a little lower. Also, since it is 3-D Mesh, it is thicker and the seat height is about 2 to 3 cm higher, so please be careful about the footing.
Also, Seat shape and the shape of this product. (circular) is not Fit, so some may be bothered by the feeling of doubling up at the aperture on the front side of the Seat when it is covered.
View detail
It looks good
Installed on an Off-road motorcycleRearSeat.
Size Cushioning Breathability with Mesh Good feeling.
View detail
I have no complaints about the performance, but the price is too high.
At the time of purchase, TL125, which was considerably customized for off-road (JD06 TLR125) I put it on a Actually, I used to have a TrailTEC1, but it was damaged in an off-road crash. At that time, TrailTEC1 was discontinued and TrailTEC2 was not yet available, so I used Cat's-eye for Motorcycle speedometer instead. I was using Cat's-eye for Motorcycle speedometer as a substitute.
It is very helpful to be able to check the speed at night when driving on public roads, because it is not practical to check the speed by pressing the button.
However, the CycleComputer for Motorcycle is a Smaller scale. (Less likely to be damaged by falls) The price is cheap, so I think it will be a problem for those who frequently enter Off-road.
In my case, since I am TRIAL, it would be nice if it were a little easier to remove the Bracket, since I do not travel long distances Off and want to remove it in places where I might fall over. I remember that in the first model, I had to remove the handlebar and the grips to install the bracket, so this is also a significant improvement. I was able to fit it by pushing it into the handlebar.
My TL is disced, but there is no gap with Fork and I used Magnet for Motorcycle and it is working fine.
View detail
Satisfied
I installed and used it on ninjaZX14R during overnight long touring (over 1,000k in 2 days) on August 12 and 13, 2023 on a very hot day.
Riding Pants of Denim (part mesh), but even under direct sunlight during a break. My butt is hot." I did not feel like jumping up and down. Even while driving, there was no Breathability is Outclassing." I did not really feel it to the extent that I would say that I was in a good position to do so, My butt steamed and sweaty." I think it was effective because I didn't have any problems. Compared to other companies' products, this product has a thinner finish for a three-piece structure, so there was no discomfort in the riding position and it was comfortable.
View detail
High grip tires scatter stones.
CBR1000RR-R stepping stones as Cowl goes Wound
I put this product on it. It was Large strange to mold it.
I struggled. I managed to put it up, but my clumsiness made it difficult.
It suffered and looked considerably worse.
Large areas were better to be put up in sections.
The Curve surface was also watered with a misting spray, but Beauty
Cannot be done. Areas with a small area are finished well.
I did.
View detail
Mirror, the standard for off-road vehicles
I have been using it for many years on my off-road vehicle, and if you grease up the universal joints and retighten the nut regularly, it will last for a long time. The Image is a long-established product from RoughAndRoad.
Vehicle:2022 RIEJU MR250 Racing
View detail
Fits: SUZUKI Jebel 250XC, SUZUKI DR250R, SUZUKI DR-Z400S, SUZUKI DR-Z400SM, SUZUKI DR250R, SUZUKI DR-Z400S, SUZUKI DR-Z400SM
Very easy to use and good looking, but...
The shape is good and easy to use. However...I have trusted this manufacturer's parts, but unfortunately, this one is not good enough. No matter how good it looks and feels, there is a safety issue. As others have posted, the positional relationship with the brake switch is different from the original, and even if the brake lever is not pulled, the switch is open, so it is misrecognized as brake activation and the stop-lamp is left on. This will not pass vehicle inspections and cannot be driven on public roads. This is a problem that can be solved by adding fat in the car by using a fat controller or a metal lock, but I am sorry to say that ROUGH & ROAD is no better than many other manufacturers of parts with inferior modifications. It's a shame that this part is as bad as many other poorly modified parts manufacturers. It's been a long time since it was released, but I doubt the manufacturer's attitude if they haven't even fixed this important problem. Other Material:I have used AluminumCarrier and other manufacturers and like them, so I expect good designs from them in the future. View detail
Fits White Motorcycle
It fits my White Motorcycle. Before purchasing this product, I was afraid that my fingers might get frostbite, but I am satisfied with this product. As for the operability, in the case of the Rebel, the switch on the RightHandlebar is operated to turn on the emergency stop light, but I can't see inside so it is a little difficult to operate, so I gave it 4 stars. I have not used it in the rain yet, so I don't know, but I thought it was a good product for protection against the cold. View detail
Windproof performance is high, but WaterproofRib is tight
Mounted on SEROW250 over ZETA's ArmourGuard.
Although a slight draft enters, the windproof performance is high because it fits completely up to the wrists.
Although the opening is Large, the waterproof rib is Small, and it is in the way when inserting/removing hands or operating the blinker.
View detail
A little hard
It is easy to install. and good, but I would like to improve the area around the Brake lever, it feels like my fingertips are jammed, it is comfortable and works well with the Grip heater. View detail
Recommendation for TRAIL vehicles
It can be installed over the Handlebar Guard of TRAIL vehicles, and because of this, the Cover is not affected by wind pressure and has a spacious interior, so we recommend that you hardly feel any discomfort in lever operation. View detail
Is it difficult to find the right amount of tightening?
The product comes in a corrugated ball, so there is no problem, but the product packaging is very simple.
I haven't run it yet, but I feel that if it is not tightened enough, it will fall down due to wind pressure.
I don't think it will break if it is over-tightened, but it may be difficult to adjust the angle and tighten it so that it does not fall down.
I like the look of Parenthesis because I think it looks good.
View detail
Carrier Extension!
RALLY591 has a good design and is EXACTLY like the atmosphere of SEROW, but it lacks a bit of loading area for camping touring, and we were piling up more and more luggage. I was thinking of DIY countermeasure to load the beauty if I could load a little more in the back if possible.
I have not loaded it with Camping equipment yet, but I think the area is as per Image in terms of Size.
The Standing bar can no longer be installed and is being considered for modification.
View detail
There is only a bestseller, on a cinch, a visual field is also large and the price of a retractable type, 3D, and a function surface is also cheap. Is only the increase of weight a difficulty?
There is only a bestseller, on a cinch, a visual field is also large and the price of a retractable type, 3D, and a function surface is also cheap.
Is only the increase of weight a difficulty?
View detail
Waterproof effect exceeded my expectations.
I used it every day for one season while commuting and touring, and it is durable enough to last for the next season.
The windproof and coldproof effect is just as you say, and this alone is indeed not enough to survive midwinter.
Use a hand warmer or a Grip heater as it gets tighter after hours of riding.
There was a time when I left my bicycle in the company's parking lot out of the rain, and the waterproof effect is quite good.
Note that the Accessory Case portion is not waterproof.
While it was easy to install, it lacked stability and I was concerned about wobble.
Also, I have a sensation that the wind is holding my hand down from about 80?
If a hand guard is attached, I think the above two can be improved at the same time.
I'm glad I bought it because it didn't look as bad as I thought it would look on my V-Strom 650.
I will use it again next Season!
View detail
Hand warmer
It was warm and very useful. View detail
The effect of reducing fatigue when driving on highways is Large. Not recommendation for use on public roads.
Purchased as a measure to alleviate wrist pain twisting the Axel when using the highway on long distance touring.
Installation is simply by screwing it into the Axel.
When using the Axel, place the base of the thumb on the plastic plate of the product and push it in to open the Axel.
The principle is simple and straightforward, but who knew that just not holding the Axel would make highway driving so much easier! I feel that it is.
On the other hand, the fine control of Axel is completely disabled, and I do not recommend using it in traffic jams or on public roads. I think there is a high risk of mishandling and rear-end collision.
This is not a defect of the product. and install and remove it each time.
View detail
Meter visor for CT125
I think the gap between the LightBody and the VisorBody is a little too large. I think so.
After installation, I am satisfied with the sharper impression than in the NORMAL condition.
It would be great if it were a little longer.
View detail